| Message ID | 546B8452.6030701@arm.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On 11/18/14 18:00, Russell King - ARM Linux wrote: > On Tue, Nov 18, 2014 at 05:39:30PM +0000, Andrew Jackson wrote: >> On HDMI, the audio data are carried across the HDMI link which is >> driven by the TDMS clock. The TDMS clock is dependent on the video pixel >> rate. >> >> This patch sets the denominator (Cycle Time Stamp) appropriately >> allowing the driver to send audio to a wider range of HDMI sinks >> (i.e. monitors). > > This is actually pointless, because we don't use "manual" CTS mode. > > If the clocks for the video and audio are coherent, then you can program > both the N and CTS values to allow the sink to properly recover the > synchronous audio clock. > > However, in most cases, the audio and video clocks are not coherent, and > since the recovered audio clock has to match the source audio clock, the > only way this can be done is by the TDA998x (or in fact other HDMI > encoder) to measure the audio clock rate and generate the CTS value > itself. > > This is the mode we drive the TDA998x - so the programmed CTS value is > irrelevant. My apologies for the noise: I originally created the patch when one of the monitors with which I was working wouldn't play sound as expected. However, I now find that the monitor plays sound with or without the patch so it must have been something else. I'd missed the significance of the "auto CTS" comment a few lines earlier (partly because I've no datasheet on the TDA998x). Andrew
diff --git a/drivers/gpu/drm/i2c/tda998x_drv.c b/drivers/gpu/drm/i2c/tda998x_drv.c index d476279..da0d504 100644 --- a/drivers/gpu/drm/i2c/tda998x_drv.c +++ b/drivers/gpu/drm/i2c/tda998x_drv.c @@ -640,7 +640,7 @@ tda998x_configure_audio(struct tda998x_priv *priv, struct drm_display_mode *mode, struct tda998x_encoder_params *p) { uint8_t buf[6], clksel_aip, clksel_fs, cts_n, adiv; - uint32_t n; + uint32_t n, cts; /* Enable audio ports */ reg_write(priv, REG_ENA_AP, p->audio_cfg); @@ -696,9 +696,23 @@ tda998x_configure_audio(struct tda998x_priv *priv, n = 128 * p->audio_sample_rate / 1000; /* Write the CTS and N values */ - buf[0] = 0x44; - buf[1] = 0x42; - buf[2] = 0x01; + if ((n > 0) && (mode->clock > 0)) { + /* + * For non-coherent clocks, the average CTS value is + * calculated as: + * fTMDS * n / (128 * fs) + * which simplifies to: + * fTMDS / 1000 + * (See sections 7.2.2 and 7.2.3 of the HDMI specification.) + * NB mode->clock is in kHz. + */ + cts = mode->clock; + } else { + cts = 82500; + } + buf[0] = cts; + buf[1] = cts >> 8; + buf[2] = cts >> 16; buf[3] = n; buf[4] = n >> 8; buf[5] = n >> 16;
On HDMI, the audio data are carried across the HDMI link which is driven by the TDMS clock. The TDMS clock is dependent on the video pixel rate. This patch sets the denominator (Cycle Time Stamp) appropriately allowing the driver to send audio to a wider range of HDMI sinks (i.e. monitors). Signed-off-by: Andrew Jackson <Andrew.Jackson@arm.com> --- drivers/gpu/drm/i2c/tda998x_drv.c | 22 ++++++++++++++++++---- 1 files changed, 18 insertions(+), 4 deletions(-)