| Message ID | 1423965635-13915-1-git-send-email-b38343@freescale.com (mailing list archive) |
|---|---|
| State | Accepted |
| Headers | show |
On Sun, Feb 15, 2015 at 10:00:35AM +0800, Robin Gong wrote: > Below comments got from Page4724 of Reference Manual of i.mx6q: > http://cache.freescale.com/files/32bit/doc/ref_manual/IMX6DQRM.pdf > > --"Static context mode should be used for the first channel called > after reset to ensure that the all context RAM for that channel is > initialized during the context SAVE phase when the channel is > done or yields. Subsequent calls to the same channel or > different channels may use any of the dynamic context modes. > This will ensure that all context locations for the bootload > channel are initialized, and prevent undefined values in context > RAM from being loaded during the context restore if the > channel is re-started later" > > Unfortunately, the rule was broken by commit(5b28aa319bba96987316425a1131813d87cbab35) > .This patch just take them back. Applied, thanks
diff --git a/drivers/dma/imx-sdma.c b/drivers/dma/imx-sdma.c index d0df198..644cfa0 100644 --- a/drivers/dma/imx-sdma.c +++ b/drivers/dma/imx-sdma.c @@ -531,6 +531,10 @@ static int sdma_run_channel0(struct sdma_engine *sdma) dev_err(sdma->dev, "Timeout waiting for CH0 ready\n"); } + /* Set bits of CONFIG register with dynamic context switching */ + if (readl(sdma->regs + SDMA_H_CONFIG) == 0) + writel_relaxed(SDMA_H_CONFIG_CSM, sdma->regs + SDMA_H_CONFIG); + return ret ? 0 : -ETIMEDOUT; } @@ -1401,9 +1405,6 @@ static int sdma_init(struct sdma_engine *sdma) writel_relaxed(ccb_phys, sdma->regs + SDMA_H_C0PTR); - /* Set bits of CONFIG register with given context switching mode */ - writel_relaxed(SDMA_H_CONFIG_CSM, sdma->regs + SDMA_H_CONFIG); - /* Initializes channel's priorities */ sdma_set_channel_priority(&sdma->channel[0], 7);
Below comments got from Page4724 of Reference Manual of i.mx6q: http://cache.freescale.com/files/32bit/doc/ref_manual/IMX6DQRM.pdf --"Static context mode should be used for the first channel called after reset to ensure that the all context RAM for that channel is initialized during the context SAVE phase when the channel is done or yields. Subsequent calls to the same channel or different channels may use any of the dynamic context modes. This will ensure that all context locations for the bootload channel are initialized, and prevent undefined values in context RAM from being loaded during the context restore if the channel is re-started later" Unfortunately, the rule was broken by commit(5b28aa319bba96987316425a1131813d87cbab35) .This patch just take them back. Signed-off-by: Robin Gong <b38343@freescale.com> --- drivers/dma/imx-sdma.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-)