| Message ID | 1438015365-15685-4-git-send-email-stefan@agner.ch (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Mon, Jul 27, 2015 at 06:42:43PM +0200, Stefan Agner wrote: > Signed-off-by: Bill Pringlemeir <bpringlemeir@nbsps.com> > Signed-off-by: Stefan Agner <stefan@agner.ch> Acked-by: Shawn Guo <shawnguo@kernel.org> > --- > .../devicetree/bindings/mtd/vf610-nfc.txt | 45 ++++++++++++++++++++++ > 1 file changed, 45 insertions(+) > create mode 100644 Documentation/devicetree/bindings/mtd/vf610-nfc.txt > > diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt > new file mode 100644 > index 0000000..cae5f25 > --- /dev/null > +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt > @@ -0,0 +1,45 @@ > +Freescale's NAND flash controller (NFC) > + > +This variant of the Freescale NAND flash controller (NFC) can be found on > +Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70. > + > +Required properties: > +- compatible: Should be set to "fsl,vf610-nfc" > +- reg: address range of the NFC > +- interrupts: interrupt of the NFC > +- nand-bus-width: see nand.txt > +- nand-ecc-mode: see nand.txt > +- nand-on-flash-bbt: see nand.txt > +- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>; > +- assigned-clock-rates: The NAND bus timing is derived from this clock > + rate and should not exceed maximum timing for any NAND memory chip > + in a board stuffing. Typical NAND memory timings derived from this > + clock are found in the SoC hardware reference manual. Furthermore, > + there might be restrictions on maximum rates when using hardware ECC. > + > +- #address-cells, #size-cells : Must be present if the device has sub-nodes > + representing partitions. > + > +Required properties for hardware ECC: > +- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt) > +- nand-ecc-step-size: step size equals page size, currently only 2k pages are > + supported > + > +Example: > + > + nfc: nand@400e0000 { > + compatible = "fsl,vf610-nfc"; > + #address-cells = <1>; > + #size-cells = <1>; > + reg = <0x400e0000 0x4000>; > + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>; > + clocks = <&clks VF610_CLK_NFC>; > + clock-names = "nfc"; > + assigned-clocks = <&clks VF610_CLK_NFC>; > + assigned-clock-rates = <33000000>; > + nand-bus-width = <8>; > + nand-ecc-mode = "hw"; > + nand-ecc-strength = <32>; > + nand-ecc-step-size = <2048>; > + nand-on-flash-bbt; > + }; > -- > 2.4.5 > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel >
diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt new file mode 100644 index 0000000..cae5f25 --- /dev/null +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt @@ -0,0 +1,45 @@ +Freescale's NAND flash controller (NFC) + +This variant of the Freescale NAND flash controller (NFC) can be found on +Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70. + +Required properties: +- compatible: Should be set to "fsl,vf610-nfc" +- reg: address range of the NFC +- interrupts: interrupt of the NFC +- nand-bus-width: see nand.txt +- nand-ecc-mode: see nand.txt +- nand-on-flash-bbt: see nand.txt +- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>; +- assigned-clock-rates: The NAND bus timing is derived from this clock + rate and should not exceed maximum timing for any NAND memory chip + in a board stuffing. Typical NAND memory timings derived from this + clock are found in the SoC hardware reference manual. Furthermore, + there might be restrictions on maximum rates when using hardware ECC. + +- #address-cells, #size-cells : Must be present if the device has sub-nodes + representing partitions. + +Required properties for hardware ECC: +- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt) +- nand-ecc-step-size: step size equals page size, currently only 2k pages are + supported + +Example: + + nfc: nand@400e0000 { + compatible = "fsl,vf610-nfc"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0x400e0000 0x4000>; + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&clks VF610_CLK_NFC>; + clock-names = "nfc"; + assigned-clocks = <&clks VF610_CLK_NFC>; + assigned-clock-rates = <33000000>; + nand-bus-width = <8>; + nand-ecc-mode = "hw"; + nand-ecc-strength = <32>; + nand-ecc-step-size = <2048>; + nand-on-flash-bbt; + };