@@ -524,6 +524,7 @@ dtb-$(CONFIG_ARCH_QCOM) += \
qcom-apq8064-cm-qs600.dtb \
qcom-apq8064-ifc6410.dtb \
qcom-apq8064-sony-xperia-yuga.dtb \
+ qcom-apq8064-asus-nexus7-flo.dts \
qcom-apq8074-dragonboard.dtb \
qcom-apq8084-ifc6540.dtb \
qcom-apq8084-mtp.dtb \
new file mode 100644
@@ -0,0 +1,276 @@
+#include "qcom-apq8064-v2.0.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
+/ {
+ model = "Asus Nexus7(flo)";
+ compatible = "asus,nexus7-flo", "qcom,apq8064";
+
+ aliases {
+ serial0 = &gsbi7_serial;
+ serial1 = &gsbi6_serial;
+ };
+
+ chosen {
+ stdout-path = "serial0:115200n8";
+ };
+
+ ext_3p3v: regulator-fixed@1 {
+ compatible = "regulator-fixed";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ regulator-name = "ext_3p3v";
+ regulator-type = "voltage";
+ startup-delay-us = <0>;
+ gpio = <&tlmm_pinmux 77 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ regulator-boot-on;
+ };
+
+ gpio-keys {
+ compatible = "gpio-keys";
+ power {
+ label = "Power";
+ gpios = <&tlmm_pinmux 26 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_POWER>;
+ gpio-key,wakeup;
+ };
+ volume_up {
+ label = "Volume Up";
+ gpios = <&pm8921_gpio 4 GPIO_ACTIVE_HIGH>;
+ linux,code = <KEY_VOLUMEUP>;
+ };
+ volume_down {
+ label = "Volume Down";
+ gpios = <&pm8921_gpio 38 GPIO_ACTIVE_HIGH>;
+ linux,code = <KEY_VOLUMEDOWN>;
+ };
+ };
+
+ soc {
+ rpm@108000 {
+ regulators {
+ vdd_l1_l2_l12_l18-supply = <&pm8921_s4>;
+ vin_lvs1_3_6-supply = <&pm8921_s4>;
+ vin_lvs4_5_7-supply = <&pm8921_s4>;
+
+
+ vdd_l24-supply = <&pm8921_s1>;
+ vdd_l25-supply = <&pm8921_s1>;
+ vin_lvs2-supply = <&pm8921_s1>;
+
+ vdd_l26-supply = <&pm8921_s7>;
+ vdd_l27-supply = <&pm8921_s7>;
+ vdd_l28-supply = <&pm8921_s7>;
+
+ vdd_ncp-supply = <&pm8921_l6>;
+
+ /* Buck SMPS */
+ s1 {
+ regulator-always-on;
+ regulator-min-microvolt = <1225000>;
+ regulator-max-microvolt = <1225000>;
+ qcom,switch-mode-frequency = <3200000>;
+ bias-pull-down;
+ };
+
+ /* msm otg HSUSB_VDDCX */
+ s3 {
+ regulator-min-microvolt = <500000>;
+ regulator-max-microvolt = <1150000>;
+ qcom,switch-mode-frequency = <4800000>;
+ };
+
+ /*
+ * msm_sdcc.1-sdc-vdd_io
+ * tabla2x-slim-CDC_VDDA_RX
+ * tabla2x-slim-CDC_VDDA_TX
+ * tabla2x-slim-CDC_VDD_CP
+ * tabla2x-slim-VDDIO_CDC
+ */
+ s4 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ qcom,switch-mode-frequency = <3200000>;
+ regulator-always-on;
+ };
+
+ s7 {
+ regulator-min-microvolt = <1300000>;
+ regulator-max-microvolt = <1300000>;
+ qcom,switch-mode-frequency = <3200000>;
+ };
+
+ /* mipi_dsi.1-dsi1_pll_vdda */
+ l2 {
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ };
+
+ /* msm_otg-HSUSB_3p3 */
+ l3 {
+ regulator-min-microvolt = <3075000>;
+ regulator-max-microvolt = <3075000>;
+ bias-pull-down;
+ };
+
+ /* msm_otg-HSUSB_1p8 */
+ l4 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ bias-pull-down;
+ };
+
+ /* msm_sdcc.1-sdc_vdd */
+ l5 {
+ regulator-min-microvolt = <2950000>;
+ regulator-max-microvolt = <2950000>;
+ regulator-always-on;
+ bias-pull-down;
+ };
+
+ l6 {
+ regulator-min-microvolt = <2950000>;
+ regulator-max-microvolt = <2950000>;
+ };
+
+ /* mipi_dsi.1-dsi1_avdd */
+ l11 {
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3000000>;
+ bias-pull-down;
+ };
+
+ /* pwm_power for backlight */
+ l17 {
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3600000>;
+ bias-pull-down;
+ };
+
+ /* camera, qdsp6 */
+ l23 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ bias-pull-down;
+ };
+
+ /*
+ * tabla2x-slim-CDC_VDDA_A_1P2V
+ * tabla2x-slim-VDDD_CDC_D
+ */
+ l25 {
+ regulator-min-microvolt = <1250000>;
+ regulator-max-microvolt = <1250000>;
+ bias-pull-down;
+ };
+
+ lvs1 {
+ bias-pull-down;
+ };
+
+ lvs4 {
+ bias-pull-down;
+ };
+
+ lvs5 {
+ bias-pull-down;
+ };
+
+ lvs6 {
+ bias-pull-down;
+ };
+ /*
+ * mipi_dsi.1-dsi1_vddio
+ * pil_riva-pll_vdd
+ */
+ lvs7 {
+ bias-pull-down;
+ };
+ };
+ };
+
+ gsbi@16200000 {
+ status = "okay";
+ qcom,mode = <GSBI_PROT_I2C>;
+ i2c@16280000 {
+ status = "okay";
+ clock-frequency = <200000>;
+ pinctrl-0 = <&i2c3_pins>;
+ pinctrl-names = "default";
+
+ trackpad@10 {
+ compatible = "elan,ekth3500";
+ reg = <0x10>;
+ interrupt-parent = <&tlmm_pinmux>;
+ interrupts = <6 IRQ_TYPE_EDGE_FALLING>;
+ };
+ };
+ };
+
+
+ gsbi@12440000 {
+ status = "okay";
+ qcom,mode = <GSBI_PROT_I2C>;
+
+ i2c@12460000 {
+ status = "okay";
+ clock-frequency = <200000>;
+ pinctrl-0 = <&i2c1_pins>;
+ pinctrl-names = "default";
+
+ eeprom@52 {
+ compatible = "atmel,24c128";
+ reg = <0x52>;
+ pagesize = <32>;
+ };
+ };
+ };
+
+ gsbi@16500000 {
+ status = "ok";
+ qcom,mode = <GSBI_PROT_I2C_UART>;
+
+ serial@16540000 {
+ status = "ok";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&gsbi6_uart_4pins>;
+ };
+ };
+
+ gsbi@16600000 {
+ status = "ok";
+ qcom,mode = <GSBI_PROT_I2C_UART>;
+ serial@16640000 {
+ status = "ok";
+ };
+ };
+
+ /* OTG */
+ phy@12500000 {
+ status = "okay";
+ vddcx-supply = <&pm8921_s3>;
+ v3p3-supply = <&pm8921_l3>;
+ v1p8-supply = <&pm8921_l4>;
+ };
+
+ gadget@12500000 {
+ status = "okay";
+ };
+
+ /* OTG */
+ usb@12500000 {
+ status = "okay";
+ };
+
+ amba {
+ /* eMMC */
+ sdcc@12400000 {
+ status = "okay";
+ vmmc-supply = <&pm8921_l5>;
+ vqmmc-supply = <&pm8921_s4>;
+ };
+ };
+ };
+};
This patch adds a dts file to support the Nexus7 2013 device. Its based off of the qcom-apq8064-ifc6410.dts which is similar hardware. Also includes some comments and context folded in from Vinay Simha BN <simhavcs@gmail.com> Cc: Rob Herring <robh+dt@kernel.org> Cc: Arnd Bergmann <arnd.bergmann@linaro.org> Cc: Pawel Moll <pawel.moll@arm.com> Cc: Mark Rutland <mark.rutland@arm.com> Cc: Ian Campbell <ijc+devicetree@hellion.org.uk> Cc: Kumar Gala <galak@codeaurora.org> Cc: Andy Gross <agross@codeaurora.org> Cc: Russell King <linux@arm.linux.org.uk> Cc: Vinay Simha BN <simhavcs@gmail.com> Cc: Bjorn Andersson <bjorn.andersson@linaro.org> Cc: Stephen Boyd <stephen.boyd@linaro.org> Cc: linux-arm-msm@vger.kernel.org Cc: devicetree@vger.kernel.org Signed-off-by: John Stultz <john.stultz@linaro.org> --- arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts | 276 +++++++++++++++++++++ 2 files changed, 277 insertions(+) create mode 100644 arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts