| Message ID | 1456666367-11418-3-git-send-email-ygardi@codeaurora.org (mailing list archive) |
|---|---|
| State | Not Applicable, archived |
| Headers | show |
On 02/28/2016 09:32 PM, Yaniv Gardi wrote: > When control reaches to Linux UFS driver during UFS boot mode, UFS host > controller interrupt status/enable registers may have left over > settings. > In order to avoid any spurious interrupts due to these left overs, > it's important to clear these interrupt status/enable registers before > enabling UFS interrupt handling. > > Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org> > Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org> > > --- > drivers/scsi/ufs/ufshcd.c | 15 +++++++++++++++ > 1 file changed, 15 insertions(+) > Reviewed-by: Hannes Reinecke <hare@suse.de> Cheers, Hannes
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c index a8e42df..de7280c 100644 --- a/drivers/scsi/ufs/ufshcd.c +++ b/drivers/scsi/ufs/ufshcd.c @@ -5837,6 +5837,21 @@ int ufshcd_init(struct ufs_hba *hba, void __iomem *mmio_base, unsigned int irq) init_waitqueue_head(&hba->dev_cmd.tag_wq); ufshcd_init_clk_gating(hba); + + /* + * In order to avoid any spurious interrupt immediately after + * registering UFS controller interrupt handler, clear any pending UFS + * interrupt status and disable all the UFS interrupts. + */ + ufshcd_writel(hba, ufshcd_readl(hba, REG_INTERRUPT_STATUS), + REG_INTERRUPT_STATUS); + ufshcd_writel(hba, 0, REG_INTERRUPT_ENABLE); + /* + * Make sure that UFS interrupts are disabled and any pending interrupt + * status is cleared before registering UFS interrupt handler. + */ + mb(); + /* IRQ registration */ err = devm_request_irq(dev, irq, ufshcd_intr, IRQF_SHARED, UFSHCD, hba); if (err) {