| Message ID | 20161226052029.10552-6-jh80.chung@samsung.com (mailing list archive) |
|---|---|
| State | New, archived |
| Delegated to: | Bjorn Helgaas |
| Headers | show |
On Mon, Dec 26, 2016 at 02:20:28PM +0900, Jaehoon Chung wrote: > Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> > --- > .../devicetree/bindings/pci/exynos5433-pcie.txt | 36 ++++++++++++++++++++++ > 1 file changed, 36 insertions(+) > create mode 100644 Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > > diff --git a/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > new file mode 100644 > index 0000000..932a847 > --- /dev/null > +++ b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt > @@ -0,0 +1,36 @@ > +* Samsung Exynos5433 PCIe interface > + > +This PCIe host controller is based on the Synopsis Designware PCIe IP Synopsys. > +and thus inherits all the common properties defined in designware-pcie.txt. > + > +Required properties: > +- compatible: "samsung,exynos5433-pcie" > +- reg: base addresses and lengths of the pcie controller, > + the phy controller, additional register for the phy controller. You mentioned three regs but the example contains four of them. Is the config comming from snps,dw-pcie? > +- reg-names: Must be "elbi", "phy" and "dbi" for each regs Again, three here, four in example. > +- interrupt-names: Must be "intr" for legacy interrupt pin. > + > +Other common properites refer to > + Documentation/devicetree/binding/pci/designware-pcie.txt > + > +Example: > + > + pcie: pcie@15700000 { > + compatible ="samsung,exynos5433-pcie", "snps,dw-pcie"; ^ space needed > + #address-cells = <3>; > + #size-cells = <2>; > + device_type = "pci"; > + interrupts = <GIC_SPI 245 IRQ_TYPE_LEVEL_HIGH>; > + interrupt-names = "intr"; > + clocks = <&cmu_fsys CLK_PCIE>, <&cmu_fsys CLK_PCLK_PCIE_PHY>; > + clock-names = "pcie", "pcie_bus"; > + num-lanes = <1>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pcie_bus>; > + reg = <0x156b0000 0x1000>, <0x15680000 0x1000>, > + <0x15700000 0x1000>, <0x0c000000 0x1000>; Indentation here looks wrong. You indented it with spaces after tabs... but not to align with line before. Beside that, fine with me: Acked-by: Krzysztof Kozlowski <krzk@kernel.org> Best regards, Krzysztof > + reg-names = "elbi", "phy", "dbi", "config"; > + ranges = <0x81000000 0 0 0x0c001000 0 0x00010000 > + 0x82000000 0 0x0c011000 0x0c011000 0 0x3feefff>; > + status = "disabled"; > + }; > -- > 2.10.2 > -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
On 12/28/2016 01:19 AM, Krzysztof Kozlowski wrote: > On Mon, Dec 26, 2016 at 02:20:28PM +0900, Jaehoon Chung wrote: >> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> >> --- >> .../devicetree/bindings/pci/exynos5433-pcie.txt | 36 ++++++++++++++++++++++ >> 1 file changed, 36 insertions(+) >> create mode 100644 Documentation/devicetree/bindings/pci/exynos5433-pcie.txt >> >> diff --git a/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt >> new file mode 100644 >> index 0000000..932a847 >> --- /dev/null >> +++ b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt >> @@ -0,0 +1,36 @@ >> +* Samsung Exynos5433 PCIe interface >> + >> +This PCIe host controller is based on the Synopsis Designware PCIe IP > > Synopsys. Will fix. > >> +and thus inherits all the common properties defined in designware-pcie.txt. >> + >> +Required properties: >> +- compatible: "samsung,exynos5433-pcie" >> +- reg: base addresses and lengths of the pcie controller, >> + the phy controller, additional register for the phy controller. > > You mentioned three regs but the example contains four of them. Is the > config comming from snps,dw-pcie? Oops..It's my mistake. Just needs to put three reg. Elbi : External local Bus interface register. Dbi : Data bus interface register.(Control register.) Config : for configuration space. "config" can be removed. Because it's not Exynos specific, synopsys's Required property. > >> +- reg-names: Must be "elbi", "phy" and "dbi" for each regs > > Again, three here, four in example. Will fix. > >> +- interrupt-names: Must be "intr" for legacy interrupt pin. >> + >> +Other common properites refer to >> + Documentation/devicetree/binding/pci/designware-pcie.txt >> + >> +Example: >> + >> + pcie: pcie@15700000 { >> + compatible ="samsung,exynos5433-pcie", "snps,dw-pcie"; > ^ > space needed >> + #address-cells = <3>; >> + #size-cells = <2>; >> + device_type = "pci"; >> + interrupts = <GIC_SPI 245 IRQ_TYPE_LEVEL_HIGH>; >> + interrupt-names = "intr"; >> + clocks = <&cmu_fsys CLK_PCIE>, <&cmu_fsys CLK_PCLK_PCIE_PHY>; >> + clock-names = "pcie", "pcie_bus"; >> + num-lanes = <1>; >> + pinctrl-names = "default"; >> + pinctrl-0 = <&pcie_bus>; >> + reg = <0x156b0000 0x1000>, <0x15680000 0x1000>, >> + <0x15700000 0x1000>, <0x0c000000 0x1000>; > > Indentation here looks wrong. You indented it with spaces after tabs... > but not to align with line before. Will fix. Best Regards, Jaehoon Chung > > Beside that, fine with me: > Acked-by: Krzysztof Kozlowski <krzk@kernel.org> > > Best regards, > Krzysztof > > >> + reg-names = "elbi", "phy", "dbi", "config"; >> + ranges = <0x81000000 0 0 0x0c001000 0 0x00010000 >> + 0x82000000 0 0x0c011000 0x0c011000 0 0x3feefff>; >> + status = "disabled"; >> + }; >> -- >> 2.10.2 >> > -- > To unsubscribe from this list: send the line "unsubscribe linux-pci" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > > > -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt new file mode 100644 index 0000000..932a847 --- /dev/null +++ b/Documentation/devicetree/bindings/pci/exynos5433-pcie.txt @@ -0,0 +1,36 @@ +* Samsung Exynos5433 PCIe interface + +This PCIe host controller is based on the Synopsis Designware PCIe IP +and thus inherits all the common properties defined in designware-pcie.txt. + +Required properties: +- compatible: "samsung,exynos5433-pcie" +- reg: base addresses and lengths of the pcie controller, + the phy controller, additional register for the phy controller. +- reg-names: Must be "elbi", "phy" and "dbi" for each regs +- interrupt-names: Must be "intr" for legacy interrupt pin. + +Other common properites refer to + Documentation/devicetree/binding/pci/designware-pcie.txt + +Example: + + pcie: pcie@15700000 { + compatible ="samsung,exynos5433-pcie", "snps,dw-pcie"; + #address-cells = <3>; + #size-cells = <2>; + device_type = "pci"; + interrupts = <GIC_SPI 245 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "intr"; + clocks = <&cmu_fsys CLK_PCIE>, <&cmu_fsys CLK_PCLK_PCIE_PHY>; + clock-names = "pcie", "pcie_bus"; + num-lanes = <1>; + pinctrl-names = "default"; + pinctrl-0 = <&pcie_bus>; + reg = <0x156b0000 0x1000>, <0x15680000 0x1000>, + <0x15700000 0x1000>, <0x0c000000 0x1000>; + reg-names = "elbi", "phy", "dbi", "config"; + ranges = <0x81000000 0 0 0x0c001000 0 0x00010000 + 0x82000000 0 0x0c011000 0x0c011000 0 0x3feefff>; + status = "disabled"; + };
Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> --- .../devicetree/bindings/pci/exynos5433-pcie.txt | 36 ++++++++++++++++++++++ 1 file changed, 36 insertions(+) create mode 100644 Documentation/devicetree/bindings/pci/exynos5433-pcie.txt