@@ -110,6 +110,8 @@ API Changes
Also, make sure to start the actual text at the margin.
=========================================================
+ * ``rte_mem_phy2mch`` was used in xen dom0 to obtain the physical address;
+ remove this API as xen dom0 support was removed.
ABI Changes
-----------
@@ -1289,7 +1289,7 @@ eth_em_tx_queue_setup(struct rte_eth_dev *dev,
txq->port_id = dev->data->port_id;
txq->tdt_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_TDT(queue_idx));
- txq->tx_ring_phys_addr = rte_mem_phy2mch(tz->memseg_id, tz->phys_addr);
+ txq->tx_ring_phys_addr = tz->phys_addr;
txq->tx_ring = (struct e1000_data_desc *) tz->addr;
PMD_INIT_LOG(DEBUG, "sw_ring=%p hw_ring=%p dma_addr=0x%"PRIx64,
@@ -1416,7 +1416,7 @@ eth_em_rx_queue_setup(struct rte_eth_dev *dev,
rxq->rdt_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_RDT(queue_idx));
rxq->rdh_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_RDH(queue_idx));
- rxq->rx_ring_phys_addr = rte_mem_phy2mch(rz->memseg_id, rz->phys_addr);
+ rxq->rx_ring_phys_addr = rz->phys_addr;
rxq->rx_ring = (struct e1000_rx_desc *) rz->addr;
PMD_INIT_LOG(DEBUG, "sw_ring=%p hw_ring=%p dma_addr=0x%"PRIx64,
@@ -1530,7 +1530,7 @@ eth_igb_tx_queue_setup(struct rte_eth_dev *dev,
txq->port_id = dev->data->port_id;
txq->tdt_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_TDT(txq->reg_idx));
- txq->tx_ring_phys_addr = rte_mem_phy2mch(tz->memseg_id, tz->phys_addr);
+ txq->tx_ring_phys_addr = tz->phys_addr;
txq->tx_ring = (union e1000_adv_tx_desc *) tz->addr;
/* Allocate software ring */
@@ -1667,7 +1667,7 @@ eth_igb_rx_queue_setup(struct rte_eth_dev *dev,
}
rxq->rdt_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_RDT(rxq->reg_idx));
rxq->rdh_reg_addr = E1000_PCI_REG_ADDR(hw, E1000_RDH(rxq->reg_idx));
- rxq->rx_ring_phys_addr = rte_mem_phy2mch(rz->memseg_id, rz->phys_addr);
+ rxq->rx_ring_phys_addr = rz->phys_addr;
rxq->rx_ring = (union e1000_adv_rx_desc *) rz->addr;
/* Allocate software ring. */
@@ -1887,7 +1887,7 @@ fm10k_rx_queue_setup(struct rte_eth_dev *dev, uint16_t queue_id,
return -ENOMEM;
}
q->hw_ring = mz->addr;
- q->hw_ring_phys_addr = rte_mem_phy2mch(mz->memseg_id, mz->phys_addr);
+ q->hw_ring_phys_addr = mz->phys_addr;
/* Check if number of descs satisfied Vector requirement */
if (!rte_is_power_of_2(nb_desc)) {
@@ -2047,7 +2047,7 @@ fm10k_tx_queue_setup(struct rte_eth_dev *dev, uint16_t queue_id,
return -ENOMEM;
}
q->hw_ring = mz->addr;
- q->hw_ring_phys_addr = rte_mem_phy2mch(mz->memseg_id, mz->phys_addr);
+ q->hw_ring_phys_addr = mz->phys_addr;
/*
* allocate memory for the RS bit tracker. Enough slots to hold the
@@ -3741,7 +3741,7 @@ i40e_allocate_dma_mem_d(__attribute__((unused)) struct i40e_hw *hw,
mem->size = size;
mem->va = mz->addr;
- mem->pa = rte_mem_phy2mch(mz->memseg_id, mz->phys_addr);
+ mem->pa = mz->phys_addr;
mem->zone = (const void *)mz;
PMD_DRV_LOG(DEBUG,
"memzone %s allocated with physical address: %"PRIu64,
@@ -249,7 +249,7 @@ i40e_fdir_setup(struct i40e_pf *pf)
goto fail_mem;
}
pf->fdir.prg_pkt = mz->addr;
- pf->fdir.dma_addr = rte_mem_phy2mch(mz->memseg_id, mz->phys_addr);
+ pf->fdir.dma_addr = mz->phys_addr;
pf->fdir.match_counter_index = I40E_COUNTER_INDEX_FDIR(hw->pf_id);
PMD_DRV_LOG(INFO, "FDIR setup successfully, with programming queue %u.",
@@ -1822,7 +1822,7 @@ i40e_dev_rx_queue_setup(struct rte_eth_dev *dev,
/* Zero all the descriptors in the ring. */
memset(rz->addr, 0, ring_size);
- rxq->rx_ring_phys_addr = rte_mem_phy2mch(rz->memseg_id, rz->phys_addr);
+ rxq->rx_ring_phys_addr = rz->phys_addr;
rxq->rx_ring = (union i40e_rx_desc *)rz->addr;
len = (uint16_t)(nb_desc + RTE_PMD_I40E_RX_MAX_BURST);
@@ -2159,7 +2159,7 @@ i40e_dev_tx_queue_setup(struct rte_eth_dev *dev,
txq->vsi = vsi;
txq->tx_deferred_start = tx_conf->tx_deferred_start;
- txq->tx_ring_phys_addr = rte_mem_phy2mch(tz->memseg_id, tz->phys_addr);
+ txq->tx_ring_phys_addr = tz->phys_addr;
txq->tx_ring = (struct i40e_tx_desc *)tz->addr;
/* Allocate software ring */
@@ -2671,7 +2671,7 @@ i40e_fdir_setup_tx_resources(struct i40e_pf *pf)
txq->reg_idx = pf->fdir.fdir_vsi->base_queue;
txq->vsi = pf->fdir.fdir_vsi;
- txq->tx_ring_phys_addr = rte_mem_phy2mch(tz->memseg_id, tz->phys_addr);
+ txq->tx_ring_phys_addr = tz->phys_addr;
txq->tx_ring = (struct i40e_tx_desc *)tz->addr;
/*
* don't need to allocate software ring and reset for the fdir
@@ -2727,7 +2727,7 @@ i40e_fdir_setup_rx_resources(struct i40e_pf *pf)
rxq->reg_idx = pf->fdir.fdir_vsi->base_queue;
rxq->vsi = pf->fdir.fdir_vsi;
- rxq->rx_ring_phys_addr = rte_mem_phy2mch(rz->memseg_id, rz->phys_addr);
+ rxq->rx_ring_phys_addr = rz->phys_addr;
rxq->rx_ring = (union i40e_rx_desc *)rz->addr;
/*
@@ -2548,7 +2548,7 @@ ixgbe_dev_tx_queue_setup(struct rte_eth_dev *dev,
else
txq->tdt_reg_addr = IXGBE_PCI_REG_ADDR(hw, IXGBE_TDT(txq->reg_idx));
- txq->tx_ring_phys_addr = rte_mem_phy2mch(tz->memseg_id, tz->phys_addr);
+ txq->tx_ring_phys_addr = tz->phys_addr;
txq->tx_ring = (union ixgbe_adv_tx_desc *) tz->addr;
/* Allocate software ring */
@@ -2850,7 +2850,7 @@ ixgbe_dev_rx_queue_setup(struct rte_eth_dev *dev,
IXGBE_PCI_REG_ADDR(hw, IXGBE_RDH(rxq->reg_idx));
}
- rxq->rx_ring_phys_addr = rte_mem_phy2mch(rz->memseg_id, rz->phys_addr);
+ rxq->rx_ring_phys_addr = rz->phys_addr;
rxq->rx_ring = (union ixgbe_adv_rx_desc *) rz->addr;
/*
@@ -61,7 +61,7 @@ sfc_dma_alloc(const struct sfc_adapter *sa, const char *name, uint16_t id,
return ENOMEM;
}
- esmp->esm_addr = rte_mem_phy2mch(mz->memseg_id, mz->phys_addr);
+ esmp->esm_addr = mz->phys_addr;
if (esmp->esm_addr == RTE_BAD_PHYS_ADDR) {
(void)rte_memzone_free(mz);
return EFAULT;
@@ -187,11 +187,6 @@ unsigned rte_memory_get_nchannel(void);
*/
unsigned rte_memory_get_nrank(void);
-static inline phys_addr_t
-rte_mem_phy2mch(int32_t memseg_id __rte_unused, const phys_addr_t phy_addr)
-{
- return phy_addr;
-}
#ifdef __cplusplus
}
#endif
@@ -473,8 +473,6 @@ rte_mempool_populate_virt(struct rte_mempool *mp, char *addr,
mp->populated_size < mp->size; off += phys_len) {
paddr = rte_mem_virt2phy(addr + off);
- /* required for xen_dom0 to get the machine address */
- paddr = rte_mem_phy2mch(-1, paddr);
if (paddr == RTE_BAD_PHYS_ADDR && rte_eal_has_hugepages()) {
ret = -EINVAL;
@@ -486,7 +484,6 @@ rte_mempool_populate_virt(struct rte_mempool *mp, char *addr,
phys_addr_t paddr_tmp;
paddr_tmp = rte_mem_virt2phy(addr + off + phys_len);
- paddr_tmp = rte_mem_phy2mch(-1, paddr_tmp);
if (paddr_tmp != paddr + phys_len)
break;
Previously, to get MFN address in dom0, this API is a wrapper to obtain the "physical address". As we removed xen dom0 support, this API is not necessary. Signed-off-by: Jianfeng Tan <jianfeng.tan@intel.com> --- doc/guides/rel_notes/release_17_11.rst | 2 ++ drivers/net/e1000/em_rxtx.c | 4 ++-- drivers/net/e1000/igb_rxtx.c | 4 ++-- drivers/net/fm10k/fm10k_ethdev.c | 4 ++-- drivers/net/i40e/i40e_ethdev.c | 2 +- drivers/net/i40e/i40e_fdir.c | 2 +- drivers/net/i40e/i40e_rxtx.c | 8 ++++---- drivers/net/ixgbe/ixgbe_rxtx.c | 4 ++-- drivers/net/sfc/sfc.c | 2 +- lib/librte_eal/common/include/rte_memory.h | 5 ----- lib/librte_mempool/rte_mempool.c | 3 --- 11 files changed, 17 insertions(+), 23 deletions(-)