| Message ID | 1311231185-5503-4-git-send-email-shubhrajyoti@ti.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Thu, Jul 21, 2011 at 12:23 PM, Shubhrajyoti D <shubhrajyoti@ti.com> wrote: > The reset in the driver at init is not needed > anymore as the hwmod framework takes care of > reseting it. > > Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com> > --- > drivers/i2c/busses/i2c-omap.c | 57 +++++++++++------------------------------ > 1 files changed, 15 insertions(+), 42 deletions(-) > > diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c > index 8f87a37..d6ea7de 100644 > --- a/drivers/i2c/busses/i2c-omap.c > +++ b/drivers/i2c/busses/i2c-omap.c > @@ -155,9 +155,6 @@ enum { > #define OMAP_I2C_SYSTEST_SDA_O (1 << 0) /* SDA line drive out */ > #endif > > -/* OCP_SYSSTATUS bit definitions */ > -#define SYSS_RESETDONE_MASK (1 << 0) > - > /* OCP_SYSCONFIG bit definitions */ > #define SYSC_CLOCKACTIVITY_MASK (0x3 << 8) > #define SYSC_SIDLEMODE_MASK (0x3 << 3) > @@ -182,6 +179,8 @@ struct omap_i2c_dev { > u32 latency; /* maximum mpu wkup latency */ > void (*set_mpu_wkup_lat)(struct device *dev, > long latency); > + int (*device_reset)(struct device *dev); > + > u32 speed; /* Speed of bus in Khz */ > u16 cmd_err; > u8 *buf; > @@ -332,7 +331,6 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) > u16 psc = 0, scll = 0, sclh = 0, buf = 0; > u16 fsscll = 0, fssclh = 0, hsscll = 0, hssclh = 0; > unsigned long fclk_rate = 12000000; > - unsigned long timeout; > unsigned long internal_clk = 0; > struct clk *fclk; > struct platform_device *pdev; > @@ -341,43 +339,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) > pdev = to_platform_device(dev->dev); > pdata = pdev->dev.platform_data; > > - if (dev->rev >= OMAP_I2C_OMAP1_REV_2) { > - /* Disable I2C controller before soft reset */ > - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, > - omap_i2c_read_reg(dev, OMAP_I2C_CON_REG) & > - ~(OMAP_I2C_CON_EN)); > - > - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, SYSC_SOFTRESET_MASK); > - /* For some reason we need to set the EN bit before the > - * reset done bit gets set. */ > - timeout = jiffies + OMAP_I2C_TIMEOUT; > - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, OMAP_I2C_CON_EN); > - while (!(omap_i2c_read_reg(dev, OMAP_I2C_SYSS_REG) & > - SYSS_RESETDONE_MASK)) { > - if (time_after(jiffies, timeout)) { > - dev_warn(dev->dev, "timeout waiting " > - "for controller reset\n"); > - return -ETIMEDOUT; > - } > - msleep(1); > - } > - > - /* SYSC register is cleared by the reset; rewrite it */ > - if (dev->rev == OMAP_I2C_REV_ON_2430) { > - > - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, > - SYSC_AUTOIDLE_MASK); > - > - } else if (dev->rev >= OMAP_I2C_REV_ON_3430) { > - dev->syscstate = SYSC_AUTOIDLE_MASK; > - dev->syscstate |= SYSC_ENAWAKEUP_MASK; > - dev->syscstate |= (SYSC_IDLEMODE_SMART << > - __ffs(SYSC_SIDLEMODE_MASK)); > - dev->syscstate |= (SYSC_CLOCKACTIVITY_FCLK << > - __ffs(SYSC_CLOCKACTIVITY_MASK)); > - > - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, > - dev->syscstate); > + if (dev->rev >= OMAP_I2C_REV_ON_3430) { > /* > * Enabling all wakup sources to stop I2C freezing on > * WFI instruction. one extra level of indentation > @@ -388,7 +350,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) > omap_i2c_write_reg(dev, OMAP_I2C_WE_REG, > dev->westate); > } same > - } > + spurious change, This comment applies to other patches in the series. > omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0); > > if (pdata->flags & OMAP_I2C_FLAG_ALWAYS_ARMXOR_CLK) { -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c index 8f87a37..d6ea7de 100644 --- a/drivers/i2c/busses/i2c-omap.c +++ b/drivers/i2c/busses/i2c-omap.c @@ -155,9 +155,6 @@ enum { #define OMAP_I2C_SYSTEST_SDA_O (1 << 0) /* SDA line drive out */ #endif -/* OCP_SYSSTATUS bit definitions */ -#define SYSS_RESETDONE_MASK (1 << 0) - /* OCP_SYSCONFIG bit definitions */ #define SYSC_CLOCKACTIVITY_MASK (0x3 << 8) #define SYSC_SIDLEMODE_MASK (0x3 << 3) @@ -182,6 +179,8 @@ struct omap_i2c_dev { u32 latency; /* maximum mpu wkup latency */ void (*set_mpu_wkup_lat)(struct device *dev, long latency); + int (*device_reset)(struct device *dev); + u32 speed; /* Speed of bus in Khz */ u16 cmd_err; u8 *buf; @@ -332,7 +331,6 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) u16 psc = 0, scll = 0, sclh = 0, buf = 0; u16 fsscll = 0, fssclh = 0, hsscll = 0, hssclh = 0; unsigned long fclk_rate = 12000000; - unsigned long timeout; unsigned long internal_clk = 0; struct clk *fclk; struct platform_device *pdev; @@ -341,43 +339,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) pdev = to_platform_device(dev->dev); pdata = pdev->dev.platform_data; - if (dev->rev >= OMAP_I2C_OMAP1_REV_2) { - /* Disable I2C controller before soft reset */ - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, - omap_i2c_read_reg(dev, OMAP_I2C_CON_REG) & - ~(OMAP_I2C_CON_EN)); - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, SYSC_SOFTRESET_MASK); - /* For some reason we need to set the EN bit before the - * reset done bit gets set. */ - timeout = jiffies + OMAP_I2C_TIMEOUT; - omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, OMAP_I2C_CON_EN); - while (!(omap_i2c_read_reg(dev, OMAP_I2C_SYSS_REG) & - SYSS_RESETDONE_MASK)) { - if (time_after(jiffies, timeout)) { - dev_warn(dev->dev, "timeout waiting " - "for controller reset\n"); - return -ETIMEDOUT; - } - msleep(1); - } - - /* SYSC register is cleared by the reset; rewrite it */ - if (dev->rev == OMAP_I2C_REV_ON_2430) { - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, - SYSC_AUTOIDLE_MASK); - - } else if (dev->rev >= OMAP_I2C_REV_ON_3430) { - dev->syscstate = SYSC_AUTOIDLE_MASK; - dev->syscstate |= SYSC_ENAWAKEUP_MASK; - dev->syscstate |= (SYSC_IDLEMODE_SMART << - __ffs(SYSC_SIDLEMODE_MASK)); - dev->syscstate |= (SYSC_CLOCKACTIVITY_FCLK << - __ffs(SYSC_CLOCKACTIVITY_MASK)); - - omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, - dev->syscstate); + if (dev->rev >= OMAP_I2C_REV_ON_3430) { /* * Enabling all wakup sources to stop I2C freezing on * WFI instruction. @@ -388,7 +350,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev) omap_i2c_write_reg(dev, OMAP_I2C_WE_REG, dev->westate); } - } + omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0); if (pdata->flags & OMAP_I2C_FLAG_ALWAYS_ARMXOR_CLK) { @@ -612,6 +574,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap, return r; if (r == 0) { dev_err(dev->dev, "controller timed out\n"); + if (dev->device_reset != NULL) { + r = dev->device_reset(dev->dev); + if (r < 0) + dev_err(dev->dev, "reset failed\n"); + } omap_i2c_init(dev); return -ETIMEDOUT; } @@ -622,6 +589,11 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap, /* We have an error */ if (dev->cmd_err & (OMAP_I2C_STAT_AL | OMAP_I2C_STAT_ROVR | OMAP_I2C_STAT_XUDF)) { + if (dev->device_reset != NULL) { + r = dev->device_reset(dev->dev); + if (r < 0) + dev_err(dev->dev, "reset failed\n"); + } omap_i2c_init(dev); return -EIO; } @@ -1024,6 +996,7 @@ omap_i2c_probe(struct platform_device *pdev) if (pdata != NULL) { speed = pdata->clkrate; dev->set_mpu_wkup_lat = pdata->set_mpu_wkup_lat; + dev->device_reset = pdata->device_reset; } else { speed = 100; /* Default speed */ dev->set_mpu_wkup_lat = NULL;
The reset in the driver at init is not needed anymore as the hwmod framework takes care of reseting it. Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com> --- drivers/i2c/busses/i2c-omap.c | 57 +++++++++++------------------------------ 1 files changed, 15 insertions(+), 42 deletions(-)