[GIT,PULL] Renesas ARM64 Based SoC DT Updates for v5.3

Pull-request

https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas.git tags/renesas-arm64-dt-for-v5.3

Message

Simon Horman June 21, 2019, 9:16 a.m. UTC

Hi Olof, Hi Kevin, Hi Arnd,

Please consider these Renesas ARM64 based SoC DT updates for v5.3.

I apologise that this pull request ended up somewhat larger than I
expected. It would have been better if I sent what was ready a
few weeks ago at that time. However, by the time I realised this
it was too late.


The following changes since commit a188339ca5a396acc588e5851ed7e19f66b0ebd9:

  Linux 5.2-rc1 (2019-05-19 15:47:09 -0700)

are available in the git repository at:

  https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas.git tags/renesas-arm64-dt-for-v5.3

for you to fetch changes up to f6130381e2a20b0503838477462a3f55f7672434:

  arm64: dts: renesas: hihope-common: Remove "label" from LEDs (2019-06-19 16:32:13 +0200)

----------------------------------------------------------------
Renesas ARM64 Based SoC DT Updates for v5.3

* Renesas SoCs
  - Revise usb2_phy nodes and phys properties according to updated bindings
  - Use ip=on for bootargs

* R-Car Gen 3 and RZ/G2M (r8a774a1) SoCs
  - Add dynamic power coefficient
  - Create thermal zone to support IPA

* R-Car E3 (r8a77990) and D3 (r8a77995) SoCs
  - Point LVDS0 to its companion LVDS1

* R-Car E3 (r8a77990) SoC
  - Corresct register range of DU

* R-Car E3 (r8a77990) based Ebisu board
  - Remove renesas, no-ether-link property

* R-Car D3 (r8a77995) based Draak board:
  - Remove unnecessary index from vin4 port

* RZ/G2M (r8a774a1) based HiHope main and sub-boards:
  - Initial support
  - Describe CPU capacity and topoligy
  - Enable CMT, HDMI, LEDs, PCIe RWDT, SCIF, SDHI, TMU, and USB 2.0 and 3.0

* RZ/G2E (r8a774c0) SoC based EK874 board:
  - Clean up CPU compatible strings
  - Enable: Bluetooth, HDMI audio and video, TPU, USB 3.0 and WLAN

----------------------------------------------------------------
Biju Das (22):
      arm64: dts: renesas: r8a774a1: Add VSP instances
      arm64: dts: renesas: r8a774a1: Add DU device to DT
      arm64: dts: renesas: r8a774a1: Add FDP1 instance
      arm64: dts: renesas: r8a774a1: Tie SYS-DMAC to IPMMU-DS0/1
      arm64: dts: renesas: r8a774a1: Tie Audio-DMAC to IPMMU-MP
      arm64: dts: renesas: r8a774a1: Connect Ethernet-AVB to IPMMU-DS0
      arm64: dts: renesas: cat874: Add WLAN support
      arm64: dts: renesas: cat874: Add BT support
      arm64: dts: renesas: Add HiHope RZ/G2M main board support
      arm64: dts: renesas: hihope-common: Add pincontrol support to scif2/scif clock
      arm64: dts: renesas: Add HiHope RZ/G2M sub board support
      arm64: dts: renesas: r8a774a1: Add PCIe device nodes
      arm64: dts: renesas: hihope-common: Declare pcie bus clock
      arm64: dts: renesas: hihope-rzg2-ex: Enable PCIe support
      arm64: dts: renesas: hihope-common: Add RWDT support
      arm64: dts: renesas: cat874: Enable USB3.0 host/peripheral device node
      arm64: dts: renesas: cat874: Enable usb role switch support
      arm64: dts: renesas: hihope-common: Enable USB3.0
      arm64: dts: renesas: r8a774a1: Add CPU topology on r8a774a1 SoC
      arm64: dts: renesas: r8a774a1: Add CPU capacity-dmips-mhz
      arm64: dts: renesas: r8a774a1: Create thermal zone to support IPA
      arm64: dts: renesas: r8a774a1: Add dynamic power coefficient

Cao Van Dong (3):
      arm64: dts: renesas: r8a7796: Add TPU support
      arm64: dts: renesas: r8a77965: Add TPU support
      arm64: dts: renesas: r8a7795: Add TPU support

Dien Pham (4):
      arm64: dts: renesas: r8a7795: Create thermal zone to support IPA
      arm64: dts: renesas: r8a7796: Create thermal zone to support IPA
      arm64: dts: renesas: r8a77965: Create thermal zone to support IPA
      arm64: dts: renesas: r8a77990: Create thermal zone to support IPA

Fabrizio Castro (12):
      arm64: dts: renesas: cat874: Add HDMI video support
      arm64: dts: renesas: cat874: Add HDMI audio
      arm64: dts: renesas: r8a774a1: Add operating points
      arm64: dts: renesas: hihope-common: Add uSD and eMMC
      arm64: dts: renesas: r8a774a1: Add CMT device nodes
      arm64: dts: renesas: r8a774a1: Add TMU device nodes
      arm64: dts: renesas: r8a774a1: Fix USB 2.0 clocks
      arm64: dts: renesas: hihope-common: Add USB 2.0 support
      arm64: dts: renesas: hihope-common: Add LEDs support
      arm64: dts: renesas: r8a774a1: Add HDMI encoder instance
      arm64: dts: renesas: hihope-common: Add HDMI support
      arm64: dts: renesas: hihope-common: Remove "label" from LEDs

Laurent Pinchart (1):
      arm64: dts: renesas: r8a7799[05]: Point LVDS0 to its companion LVDS1

Magnus Damm (1):
      arm64: dts: renesas: Use ip=on for bootargs

Robin Murphy (1):
      arm64: dts: renesas: r8a774c0: Clean up CPU compatibles

Simon Horman (5):
      arm64: dts: renesas: draak: Remove unnecessary index from vin4 port
      arm64: dts: renesas: r8a7795: Add dynamic power coefficient
      arm64: dts: renesas: r8a7796: Add dynamic power coefficient
      arm64: dts: renesas: r8a77965: Add dynamic power coefficient
      arm64: dts: renesas: r8a77990: Add dynamic power coefficient

Spyridon Papageorgiou (1):
      arm64: dts: renesas: ulcb-kf: Add support for TI WL1837

Takeshi Kihara (2):
      arm64: dts: renesas: ebisu: Remove renesas, no-ether-link property
      arm64: dts: renesas: r8a77990: Fix register range of display node

Yoshihiro Shimoda (1):
      arm64: dts: renesas: Revise usb2_phy nodes and phys properties

 arch/arm64/boot/dts/renesas/Makefile               |   2 +
 arch/arm64/boot/dts/renesas/hihope-common.dtsi     | 325 +++++++++++++
 arch/arm64/boot/dts/renesas/hihope-rzg2-ex.dtsi    |  63 +++
 .../boot/dts/renesas/r8a774a1-hihope-rzg2m-ex.dts  |  15 +
 .../boot/dts/renesas/r8a774a1-hihope-rzg2m.dts     |  26 +
 arch/arm64/boot/dts/renesas/r8a774a1.dtsi          | 527 ++++++++++++++++++++-
 arch/arm64/boot/dts/renesas/r8a774c0-cat874.dts    | 246 +++++++++-
 arch/arm64/boot/dts/renesas/r8a774c0.dtsi          |  12 +-
 arch/arm64/boot/dts/renesas/r8a7795.dtsi           |  93 ++--
 arch/arm64/boot/dts/renesas/r8a7796.dtsi           |  71 ++-
 arch/arm64/boot/dts/renesas/r8a77965.dtsi          |  45 +-
 arch/arm64/boot/dts/renesas/r8a77970-eagle.dts     |   2 +-
 arch/arm64/boot/dts/renesas/r8a77990-ebisu.dts     |   3 +-
 arch/arm64/boot/dts/renesas/r8a77990.dtsi          |  32 +-
 arch/arm64/boot/dts/renesas/r8a77995-draak.dts     |   9 +-
 arch/arm64/boot/dts/renesas/r8a77995.dtsi          |  10 +-
 arch/arm64/boot/dts/renesas/salvator-common.dtsi   |   2 +-
 arch/arm64/boot/dts/renesas/ulcb-kf.dtsi           |  49 ++
 arch/arm64/boot/dts/renesas/ulcb.dtsi              |   2 +-
 19 files changed, 1393 insertions(+), 141 deletions(-)
 create mode 100644 arch/arm64/boot/dts/renesas/hihope-common.dtsi
 create mode 100644 arch/arm64/boot/dts/renesas/hihope-rzg2-ex.dtsi
 create mode 100644 arch/arm64/boot/dts/renesas/r8a774a1-hihope-rzg2m-ex.dts
 create mode 100644 arch/arm64/boot/dts/renesas/r8a774a1-hihope-rzg2m.dts

Comments

Olof Johansson June 25, 2019, 11:46 a.m. UTC | #1

On Fri, Jun 21, 2019 at 11:16:27AM +0200, Simon Horman wrote:
> Hi Olof, Hi Kevin, Hi Arnd,
> 
> Please consider these Renesas ARM64 based SoC DT updates for v5.3.
> 
> I apologise that this pull request ended up somewhat larger than I
> expected. It would have been better if I sent what was ready a
> few weeks ago at that time. However, by the time I realised this
> it was too late.
> 
> 
> The following changes since commit a188339ca5a396acc588e5851ed7e19f66b0ebd9:
> 
>   Linux 5.2-rc1 (2019-05-19 15:47:09 -0700)
> 
> are available in the git repository at:
> 
>   https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas.git tags/renesas-arm64-dt-for-v5.3
> 
> for you to fetch changes up to f6130381e2a20b0503838477462a3f55f7672434:
> 
>   arm64: dts: renesas: hihope-common: Remove "label" from LEDs (2019-06-19 16:32:13 +0200)


Merged, thanks!


-Olof