mbox series

[0/3] Optimize voltage switch for the SD controller

Message ID cover.1561094029.git.baolin.wang@linaro.org (mailing list archive)
Headers show
Series Optimize voltage switch for the SD controller | expand

Message

(Exiting) Baolin Wang June 21, 2019, 6:12 a.m. UTC 
This patch set is used to optimize voltage switch for the
Spreadtrum SD host controller.

Any comments are welcome. Thanks.

Baolin Wang (3):
  mmc: sdhci-sprd: Add start_signal_voltage_switch ops
  dt-bindings: mmc: sprd: Add pinctrl support
  mmc: sdhci-sprd: Add pin control support for voltage switch

 .../devicetree/bindings/mmc/sdhci-sprd.txt         |    7 ++
 drivers/mmc/host/sdhci-sprd.c                      |   78 ++++++++++++++++++++
 2 files changed, 85 insertions(+)

Comments

Ulf Hansson July 8, 2019, 11:55 a.m. UTC | #1 
On Fri, 21 Jun 2019 at 08:12, Baolin Wang <baolin.wang@linaro.org> wrote:
>
> This patch set is used to optimize voltage switch for the
> Spreadtrum SD host controller.
>
> Any comments are welcome. Thanks.
>
> Baolin Wang (3):
>   mmc: sdhci-sprd: Add start_signal_voltage_switch ops
>   dt-bindings: mmc: sprd: Add pinctrl support
>   mmc: sdhci-sprd: Add pin control support for voltage switch
>
>  .../devicetree/bindings/mmc/sdhci-sprd.txt         |    7 ++
>  drivers/mmc/host/sdhci-sprd.c                      |   78 ++++++++++++++++++++
>  2 files changed, 85 insertions(+)
>
> --
> 1.7.9.5
>

Applied for next, thanks!

Kind regards
Uffe