| Message ID | 6bfe17d86ead62c20d236e2ebbc7b7fe3354829d.1606828668.git.stefan@agner.ch (mailing list archive) |
|---|---|
| State | Superseded |
| Headers | show |
| Series | [v2,1/5] arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements | expand |
Hi Stefan, On Tue, Dec 1, 2020 at 2:21 PM Stefan Agner <stefan@agner.ch> wrote: > > According to the datasheet (Rev. 1.9) the RTL8211F requires at least > 72ms "for internal circuits settling time" before accessing the PHY > egisters. On similar boards with the same PHY this fixes an issue where there's a typo here: it should be "registers" this is the same for the other four patches also > Ethernet link would not come up when using ip link set down/up. I have never experienced that myself but gotten a few reports about this. thank you very much for coming up with info from the datasheet! the following stmmac patch [0] has been added recently which may - or may not - have any impact also. > Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings") > Signed-off-by: Stefan Agner <stefan@agner.ch> with above typo fixed: Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> and also: Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> # on Odroid-C1+ Best regards, Martin [0] https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/drivers/net/ethernet/stmicro/stmmac?id=56311a315da7ebc668dbcc2f1c99689cc10796c4
On 2020-12-05 14:04, Martin Blumenstingl wrote: > Hi Stefan, > > On Tue, Dec 1, 2020 at 2:21 PM Stefan Agner <stefan@agner.ch> wrote: >> >> According to the datasheet (Rev. 1.9) the RTL8211F requires at least >> 72ms "for internal circuits settling time" before accessing the PHY >> egisters. On similar boards with the same PHY this fixes an issue where > there's a typo here: it should be "registers" > this is the same for the other four patches also Whoops, will send v3 shortly. > >> Ethernet link would not come up when using ip link set down/up. > I have never experienced that myself but gotten a few reports about this. > thank you very much for coming up with info from the datasheet! > > the following stmmac patch [0] has been added recently which may - or > may not - have any impact also. Thanks for the hint, wasn't aware of that. -- Stefan > >> Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings") >> Signed-off-by: Stefan Agner <stefan@agner.ch> > with above typo fixed: > Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> > and also: > Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> # > on Odroid-C1+ > > > Best regards, > Martin > > > [0] https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/drivers/net/ethernet/stmicro/stmmac?id=56311a315da7ebc668dbcc2f1c99689cc10796c4
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts index 0c26467de4d0..5963566dbcc9 100644 --- a/arch/arm/boot/dts/meson8b-odroidc1.dts +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts @@ -224,7 +224,7 @@ eth_phy: ethernet-phy@0 { reg = <0>; reset-assert-us = <10000>; - reset-deassert-us = <30000>; + reset-deassert-us = <80000>; reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>; interrupt-parent = <&gpio_intc>; diff --git a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts index cc498191ddd1..8f4eb1ed4581 100644 --- a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts +++ b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts @@ -81,7 +81,7 @@ eth_phy0: ethernet-phy@0 { reg = <0>; reset-assert-us = <10000>; - reset-deassert-us = <30000>; + reset-deassert-us = <80000>; reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>; }; };
According to the datasheet (Rev. 1.9) the RTL8211F requires at least 72ms "for internal circuits settling time" before accessing the PHY egisters. On similar boards with the same PHY this fixes an issue where Ethernet link would not come up when using ip link set down/up. Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings") Signed-off-by: Stefan Agner <stefan@agner.ch> --- arch/arm/boot/dts/meson8b-odroidc1.dts | 2 +- arch/arm/boot/dts/meson8m2-mxiii-plus.dts | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-)