@@ -889,6 +889,7 @@ static int tc_set_edp_video_mode(struct tc_data *tc,
u32 dp0_syncval;
u32 bits_per_pixel = 24;
u32 in_bw, out_bw;
+ u32 dpipxlfmt;
/*
* Recommended maximum number of symbols transferred in a transfer unit:
@@ -938,10 +939,15 @@ static int tc_set_edp_video_mode(struct tc_data *tc,
if (ret)
return ret;
- ret = regmap_write(tc->regmap, DPIPXLFMT,
- VS_POL_ACTIVE_LOW | HS_POL_ACTIVE_LOW |
- DE_POL_ACTIVE_HIGH | SUB_CFG_TYPE_CONFIG1 |
- DPI_BPP_RGB888);
+ dpipxlfmt = DE_POL_ACTIVE_HIGH | SUB_CFG_TYPE_CONFIG1 | DPI_BPP_RGB888;
+
+ if (mode->flags & DRM_MODE_FLAG_NVSYNC)
+ dpipxlfmt |= VS_POL_ACTIVE_LOW;
+
+ if (mode->flags & DRM_MODE_FLAG_NHSYNC)
+ dpipxlfmt |= HS_POL_ACTIVE_LOW;
+
+ ret = regmap_write(tc->regmap, DPIPXLFMT, dpipxlfmt);
if (ret)
return ret;
@@ -1471,18 +1477,6 @@ tc_edp_bridge_atomic_disable(struct drm_bridge *bridge,
dev_err(tc->dev, "main link disable error: %d\n", ret);
}
-static bool tc_bridge_mode_fixup(struct drm_bridge *bridge,
- const struct drm_display_mode *mode,
- struct drm_display_mode *adj)
-{
- /* Fixup sync polarities, both hsync and vsync are active low */
- adj->flags = mode->flags;
- adj->flags |= (DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC);
- adj->flags &= ~(DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC);
-
- return true;
-}
-
static int tc_common_atomic_check(struct drm_bridge *bridge,
struct drm_bridge_state *bridge_state,
struct drm_crtc_state *crtc_state,
@@ -1758,7 +1752,6 @@ static const struct drm_bridge_funcs tc_edp_bridge_funcs = {
.atomic_check = tc_edp_atomic_check,
.atomic_enable = tc_edp_bridge_atomic_enable,
.atomic_disable = tc_edp_bridge_atomic_disable,
- .mode_fixup = tc_bridge_mode_fixup,
.detect = tc_bridge_detect,
.get_edid = tc_get_edid,
.atomic_duplicate_state = drm_atomic_helper_bridge_duplicate_state,
It doesn't always work, as there is just a single adjusted mode, so if parts of the display pipeline disagree on the required sync polarity it's possible to end up with a invalid config. However it also isn't necessary for this bridge chip, as the DPI interface has a configurable sync polarity, so we can just set it up to match the mode. Signed-off-by: Lucas Stach <l.stach@pengutronix.de> --- drivers/gpu/drm/bridge/tc358767.c | 27 ++++++++++----------------- 1 file changed, 10 insertions(+), 17 deletions(-)