| Message ID | 20221014092651.25202-1-fabrice.gasnier@foss.st.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | Add support for USB on STM32MP13 | expand |
On 10/14/22 11:26, Fabrice Gasnier wrote: > Add support for USBPHYC, USB Host and USB OTG on STM32MP13. > Enable all these interfaces on STM32MP135F-DK board. > Enable the STM32G0 UCSI driver as module. > Dependency on PWR and PMIC regulator is tempoarily managed by using > fixed regulators (resp in the SoC dtsi and the board dts files). > The USB support is functional when these regulators gets enabled at > boot time before entering the kernel. Hi, Please discard this series. Generic node names recommendation has been missed. I'll send a V2. Sorry for the noise. Best Regards, Fabrice > > Amelie Delaunay (5): > ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131 > ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131 > ARM: dts: stm32: add USB OTG HS support on stm32mp131 > ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk > ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk > > Fabrice Gasnier (5): > ARM: dts: stm32: add PWR fixed regulators on stm32mp131 > ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk > ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13 > ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk > ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules > > arch/arm/boot/dts/stm32mp13-pinctrl.dtsi | 7 ++ > arch/arm/boot/dts/stm32mp131.dtsi | 81 ++++++++++++++++++++ > arch/arm/boot/dts/stm32mp135f-dk.dts | 95 ++++++++++++++++++++++++ > arch/arm/configs/multi_v7_defconfig | 2 + > 4 files changed, 185 insertions(+) >