@@ -31,6 +31,7 @@ static void qedf_remove(struct pci_dev *pdev);
static void qedf_shutdown(struct pci_dev *pdev);
static void qedf_schedule_recovery_handler(void *dev);
static void qedf_recovery_handler(struct work_struct *work);
+static int qedf_suspend(struct pci_dev *pdev, pm_message_t state);
/*
* Driver module parameters.
@@ -3271,6 +3272,7 @@ static struct pci_driver qedf_pci_driver = {
.probe = qedf_probe,
.remove = qedf_remove,
.shutdown = qedf_shutdown,
+ .suspend = qedf_suspend,
};
static int __qedf_probe(struct pci_dev *pdev, int mode)
@@ -4000,6 +4002,22 @@ static void qedf_shutdown(struct pci_dev *pdev)
__qedf_remove(pdev, QEDF_MODE_NORMAL);
}
+static int qedf_suspend(struct pci_dev *pdev, pm_message_t state)
+{
+ struct qedf_ctx *qedf;
+
+ if (!pdev) {
+ QEDF_ERR(NULL, "pdev is NULL.\n");
+ return -ENODEV;
+ }
+
+ qedf = pci_get_drvdata(pdev);
+
+ QEDF_ERR(&qedf->dbg_ctx, "%s: Device does not support suspend operation\n", __func__);
+
+ return -EPERM;
+}
+
/*
* Recovery handler code
*/
While performing certain power-off sequences, PCI drivers are called to suspend and resume their underlying devices through PCI PM (power management) interface. However the hardware does not support PCI PM suspend/resume operations so system wide suspend/resume leads to bad MFW (management firmware) state which causes various follow-up errors in driver when communicating with the device/firmware. To fix this driver implements PCI PM suspend handler to indicate unsupported operation to the PCI subsystem explicitly, thus avoiding system to go into suspended/standby mode. Fixes: 61d8658b4a43 ("scsi: qedf: Add QLogic FastLinQ offload FCoE driver framework.") Signed-off-by: Saurav Kashyap <skashyap@marvell.com> Signed-off-by: Nilesh Javali <njavali@marvell.com> --- drivers/scsi/qedf/qedf_main.c | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)