@@ -182,13 +182,6 @@ config PINCTRL_QCS404
This is the pinctrl, pinmux, pinconf and gpiolib driver for the
TLMM block found in the Qualcomm QCS404 platform.
-config PINCTRL_QDF2XXX
- tristate "Qualcomm Technologies QDF2xxx pin controller driver"
- depends on ACPI
- help
- This is the GPIO driver for the TLMM block found on the
- Qualcomm Technologies QDF2xxx SOCs.
-
config PINCTRL_QDU1000
tristate "Qualcomm Technologies Inc QDU1000/QRU1000 pin controller driver"
depends on ARM64 || COMPILE_TEST
@@ -23,7 +23,6 @@ obj-$(CONFIG_PINCTRL_MSM8996) += pinctrl-msm8996.o
obj-$(CONFIG_PINCTRL_MSM8998) += pinctrl-msm8998.o
obj-$(CONFIG_PINCTRL_QCM2290) += pinctrl-qcm2290.o
obj-$(CONFIG_PINCTRL_QCS404) += pinctrl-qcs404.o
-obj-$(CONFIG_PINCTRL_QDF2XXX) += pinctrl-qdf2xxx.o
obj-$(CONFIG_PINCTRL_MDM9607) += pinctrl-mdm9607.o
obj-$(CONFIG_PINCTRL_MDM9615) += pinctrl-mdm9615.o
obj-$(CONFIG_PINCTRL_QCOM_SPMI_PMIC) += pinctrl-spmi-gpio.o
deleted file mode 100644
@@ -1,164 +0,0 @@
-// SPDX-License-Identifier: GPL-2.0-only
-/*
- * Copyright (c) 2015, The Linux Foundation. All rights reserved.
- *
- * GPIO and pin control functions on this SOC are handled by the "TLMM"
- * device. The driver which controls this device is pinctrl-msm.c. Each
- * SOC with a TLMM is expected to create a client driver that registers
- * with pinctrl-msm.c. This means that all TLMM drivers are pin control
- * drivers.
- *
- * This pin control driver is intended to be used only an ACPI-enabled
- * system. As such, UEFI will handle all pin control configuration, so
- * this driver does not provide pin control functions. It is effectively
- * a GPIO-only driver. The alternative is to duplicate the GPIO code of
- * pinctrl-msm.c into another driver.
- */
-
-#include <linux/module.h>
-#include <linux/platform_device.h>
-#include <linux/pinctrl/pinctrl.h>
-#include <linux/acpi.h>
-
-#include "pinctrl-msm.h"
-
-/* A maximum of 256 allows us to use a u8 array to hold the GPIO numbers */
-#define MAX_GPIOS 256
-
-/* maximum size of each gpio name (enough room for "gpioXXX" + null) */
-#define NAME_SIZE 8
-
-static int qdf2xxx_pinctrl_probe(struct platform_device *pdev)
-{
- struct msm_pinctrl_soc_data *pinctrl;
- struct pinctrl_pin_desc *pins;
- struct msm_pingroup *groups;
- char (*names)[NAME_SIZE];
- unsigned int i;
- u32 num_gpios;
- unsigned int avail_gpios; /* The number of GPIOs we support */
- u8 gpios[MAX_GPIOS]; /* An array of supported GPIOs */
- int ret;
-
- /* Query the number of GPIOs from ACPI */
- ret = device_property_read_u32(&pdev->dev, "num-gpios", &num_gpios);
- if (ret < 0) {
- dev_err(&pdev->dev, "missing 'num-gpios' property\n");
- return ret;
- }
- if (!num_gpios || num_gpios > MAX_GPIOS) {
- dev_err(&pdev->dev, "invalid 'num-gpios' property\n");
- return -ENODEV;
- }
-
- /* The number of GPIOs in the approved list */
- ret = device_property_count_u8(&pdev->dev, "gpios");
- if (ret < 0) {
- dev_err(&pdev->dev, "missing 'gpios' property\n");
- return ret;
- }
- /*
- * The number of available GPIOs should be non-zero, and no
- * more than the total number of GPIOS.
- */
- if (!ret || ret > num_gpios) {
- dev_err(&pdev->dev, "invalid 'gpios' property\n");
- return -ENODEV;
- }
- avail_gpios = ret;
-
- ret = device_property_read_u8_array(&pdev->dev, "gpios", gpios,
- avail_gpios);
- if (ret < 0) {
- dev_err(&pdev->dev, "could not read list of GPIOs\n");
- return ret;
- }
-
- pinctrl = devm_kzalloc(&pdev->dev, sizeof(*pinctrl), GFP_KERNEL);
- pins = devm_kcalloc(&pdev->dev, num_gpios,
- sizeof(struct pinctrl_pin_desc), GFP_KERNEL);
- groups = devm_kcalloc(&pdev->dev, num_gpios,
- sizeof(struct msm_pingroup), GFP_KERNEL);
- names = devm_kcalloc(&pdev->dev, avail_gpios, NAME_SIZE, GFP_KERNEL);
-
- if (!pinctrl || !pins || !groups || !names)
- return -ENOMEM;
-
- /*
- * Initialize the array. GPIOs not listed in the 'gpios' array
- * still need a number, but nothing else.
- */
- for (i = 0; i < num_gpios; i++) {
- pins[i].number = i;
- groups[i].grp.pins = &pins[i].number;
- }
-
- /* Populate the entries that are meant to be exposed as GPIOs. */
- for (i = 0; i < avail_gpios; i++) {
- unsigned int gpio = gpios[i];
-
- groups[gpio].grp.npins = 1;
- snprintf(names[i], NAME_SIZE, "gpio%u", gpio);
- pins[gpio].name = names[i];
- groups[gpio].grp.name = names[i];
-
- groups[gpio].ctl_reg = 0x10000 * gpio;
- groups[gpio].io_reg = 0x04 + 0x10000 * gpio;
- groups[gpio].intr_cfg_reg = 0x08 + 0x10000 * gpio;
- groups[gpio].intr_status_reg = 0x0c + 0x10000 * gpio;
- groups[gpio].intr_target_reg = 0x08 + 0x10000 * gpio;
-
- groups[gpio].mux_bit = 2;
- groups[gpio].pull_bit = 0;
- groups[gpio].drv_bit = 6;
- groups[gpio].oe_bit = 9;
- groups[gpio].in_bit = 0;
- groups[gpio].out_bit = 1;
- groups[gpio].intr_enable_bit = 0;
- groups[gpio].intr_status_bit = 0;
- groups[gpio].intr_target_bit = 5;
- groups[gpio].intr_target_kpss_val = 1;
- groups[gpio].intr_raw_status_bit = 4;
- groups[gpio].intr_polarity_bit = 1;
- groups[gpio].intr_detection_bit = 2;
- groups[gpio].intr_detection_width = 2;
- }
-
- pinctrl->pins = pins;
- pinctrl->groups = groups;
- pinctrl->npins = num_gpios;
- pinctrl->ngroups = num_gpios;
- pinctrl->ngpios = num_gpios;
-
- return msm_pinctrl_probe(pdev, pinctrl);
-}
-
-static const struct acpi_device_id qdf2xxx_acpi_ids[] = {
- {"QCOM8002"},
- {},
-};
-MODULE_DEVICE_TABLE(acpi, qdf2xxx_acpi_ids);
-
-static struct platform_driver qdf2xxx_pinctrl_driver = {
- .driver = {
- .name = "qdf2xxx-pinctrl",
- .acpi_match_table = qdf2xxx_acpi_ids,
- },
- .probe = qdf2xxx_pinctrl_probe,
- .remove_new = msm_pinctrl_remove,
-};
-
-static int __init qdf2xxx_pinctrl_init(void)
-{
- return platform_driver_register(&qdf2xxx_pinctrl_driver);
-}
-arch_initcall(qdf2xxx_pinctrl_init);
-
-static void __exit qdf2xxx_pinctrl_exit(void)
-{
- platform_driver_unregister(&qdf2xxx_pinctrl_driver);
-}
-module_exit(qdf2xxx_pinctrl_exit);
-
-MODULE_DESCRIPTION("Qualcomm Technologies QDF2xxx pin control driver");
-MODULE_LICENSE("GPL v2");
This SoC family was destined for server use, featuring Qualcomm's very interesting Kryo cores (before "Kryo" became a marketing term for Arm cores with small modifications). It did however not leave the labs of Qualcomm and presumably some partners, nor was it ever productized. Remove this driver, as it seems to be long obsolete. Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org> --- drivers/pinctrl/qcom/Kconfig.msm | 7 -- drivers/pinctrl/qcom/Makefile | 1 - drivers/pinctrl/qcom/pinctrl-qdf2xxx.c | 164 --------------------------------- 3 files changed, 172 deletions(-)