@@ -69,37 +69,22 @@ static int of_platform_serial_setup(struct platform_device *ofdev,
struct device *dev = &ofdev->dev;
struct device_node *np = dev->of_node;
struct uart_port *port = &up->port;
- u32 clk, spd, prop;
- int ret, irq;
+ u32 spd;
+ int ret;
memset(port, 0, sizeof *port);
pm_runtime_enable(&ofdev->dev);
pm_runtime_get_sync(&ofdev->dev);
- if (of_property_read_u32(np, "clock-frequency", &clk)) {
-
- /* Get clk rate through clk driver if present */
- info->clk = devm_clk_get_enabled(dev, NULL);
- if (IS_ERR(info->clk)) {
- ret = dev_err_probe(dev, PTR_ERR(info->clk), "failed to get clock\n");
- goto err_pmruntime;
- }
-
- clk = clk_get_rate(info->clk);
- }
- /* If current-speed was set, then try not to change it. */
- if (of_property_read_u32(np, "current-speed", &spd) == 0)
- port->custom_divisor = clk / (16 * spd);
-
ret = of_address_to_resource(np, 0, &resource);
if (ret) {
dev_err_probe(dev, ret, "invalid address\n");
goto err_pmruntime;
}
- port->flags = UPF_SHARE_IRQ | UPF_BOOT_AUTOCONF | UPF_FIXED_PORT |
- UPF_FIXED_TYPE;
+ port->dev = &ofdev->dev;
+ port->flags = UPF_BOOT_AUTOCONF | UPF_FIXED_PORT | UPF_FIXED_TYPE;
spin_lock_init(&port->lock);
if (resource_type(&resource) == IORESOURCE_IO) {
@@ -108,70 +93,31 @@ static int of_platform_serial_setup(struct platform_device *ofdev,
} else {
port->mapbase = resource.start;
port->mapsize = resource_size(&resource);
-
- /* Check for shifted address mapping */
- if (of_property_read_u32(np, "reg-offset", &prop) == 0) {
- if (prop >= port->mapsize) {
- ret = dev_err_probe(dev, -EINVAL, "reg-offset %u exceeds region size %pa\n",
- prop, &port->mapsize);
- goto err_pmruntime;
- }
-
- port->mapbase += prop;
- port->mapsize -= prop;
- }
-
- port->iotype = UPIO_MEM;
- if (of_property_read_u32(np, "reg-io-width", &prop) == 0) {
- switch (prop) {
- case 1:
- port->iotype = UPIO_MEM;
- break;
- case 2:
- port->iotype = UPIO_MEM16;
- break;
- case 4:
- port->iotype = of_device_is_big_endian(np) ?
- UPIO_MEM32BE : UPIO_MEM32;
- break;
- default:
- ret = dev_err_probe(dev, -EINVAL, "unsupported reg-io-width (%u)\n",
- prop);
- goto err_pmruntime;
- }
- }
port->flags |= UPF_IOREMAP;
}
+ ret = uart_read_port_properties(port, false);
+ if (ret)
+ goto err_pmruntime;
+
+ /* Get clk rate through clk driver if present */
+ if (!port->uartclk) {
+ info->clk = devm_clk_get_enabled(dev, NULL);
+ if (IS_ERR(info->clk)) {
+ ret = dev_err_probe(dev, PTR_ERR(info->clk), "failed to get clock\n");
+ goto err_pmruntime;
+ }
+
+ port->uartclk = clk_get_rate(info->clk);
+ }
+ /* If current-speed was set, then try not to change it. */
+ if (of_property_read_u32(np, "current-speed", &spd) == 0)
+ port->custom_divisor = port->uartclk / (16 * spd);
+
/* Compatibility with the deprecated pxa driver and 8250_pxa drivers. */
if (of_device_is_compatible(np, "mrvl,mmp-uart"))
port->regshift = 2;
- /* Check for registers offset within the devices address range */
- if (of_property_read_u32(np, "reg-shift", &prop) == 0)
- port->regshift = prop;
-
- /* Check for fifo size */
- if (of_property_read_u32(np, "fifo-size", &prop) == 0)
- port->fifosize = prop;
-
- /* Check for a fixed line number */
- ret = of_alias_get_id(np, "serial");
- if (ret >= 0)
- port->line = ret;
-
- irq = of_irq_get(np, 0);
- if (irq < 0) {
- if (irq == -EPROBE_DEFER) {
- ret = -EPROBE_DEFER;
- goto err_pmruntime;
- }
- /* IRQ support not mandatory */
- irq = 0;
- }
-
- port->irq = irq;
-
info->rst = devm_reset_control_get_optional_shared(&ofdev->dev, NULL);
if (IS_ERR(info->rst)) {
ret = PTR_ERR(info->rst);
@@ -183,12 +129,6 @@ static int of_platform_serial_setup(struct platform_device *ofdev,
goto err_pmruntime;
port->type = type;
- port->uartclk = clk;
-
- if (of_property_read_bool(np, "no-loopback-test"))
- port->flags |= UPF_SKIP_TEST;
-
- port->dev = &ofdev->dev;
port->rs485_config = serial8250_em485_config;
port->rs485_supported = serial8250_em485_supported;
up->rs485_start_tx = serial8250_em485_start_tx;
@@ -280,7 +220,6 @@ static int of_platform_serial_probe(struct platform_device *ofdev)
platform_set_drvdata(ofdev, info);
return 0;
err_dispose:
- irq_dispose_mapping(port8250.port.irq);
pm_runtime_put_sync(&ofdev->dev);
pm_runtime_disable(&ofdev->dev);
err_free: