diff mbox series

[v1,2/2] cpufreq: mediatek: Fixed cpufreq has 2 policy will cause concurrency

Message ID 20240913103933.30895-3-chun-jen.tseng@mediatek.com (mailing list archive)
State New
Delegated to: viresh kumar
Headers show
Series fixed mediatek-cpufreq has multi policy concurrency issue | expand

Commit Message

Mark Tseng Sept. 13, 2024, 10:39 a.m. UTC
mtk_cpufreq_set_target() is re-enter function but the mutex lock decalre
in mtk_cpu_dvfs_info structure for each policy. It should change to
global variable for critical session avoid policy get wrong OPP.

SoC with CCI architecture should set transition_delay to 10 ms
because cpufreq need to call devfreq notifier in async mode. if delay
less than 10ms may get wrong OPP-level in CCI driver.

Add CPUFREQ_ASYNC_NOTIFICATION flages for cpufreq policy because some of
process will get CPU frequency by cpufreq sysfs node. It may get wrong
frequency then call cpufreq_out_of_sync() to fixed frequency.

Signed-off-by: Mark Tseng <chun-jen.tseng@mediatek.com>
---
 drivers/cpufreq/mediatek-cpufreq.c | 65 ++++++++++++++++++++++--------
 1 file changed, 49 insertions(+), 16 deletions(-)

Comments

Viresh Kumar Oct. 1, 2024, 6:43 a.m. UTC | #1
On 13-09-24, 18:39, Mark Tseng wrote:
> mtk_cpufreq_set_target() is re-enter function but the mutex lock decalre
> in mtk_cpu_dvfs_info structure for each policy. It should change to
> global variable for critical session avoid policy get wrong OPP.

I am not sure I understood the problem well. Can you explain clearly
why the current locking doesn't work with details call chain ?

It is normally okay to have per-policy locks otherwise. Are there any
common resources being used between policies that need locking ?

> SoC with CCI architecture should set transition_delay to 10 ms
> because cpufreq need to call devfreq notifier in async mode. if delay
> less than 10ms may get wrong OPP-level in CCI driver.
> 
> Add CPUFREQ_ASYNC_NOTIFICATION flages for cpufreq policy because some of
> process will get CPU frequency by cpufreq sysfs node. It may get wrong
> frequency then call cpufreq_out_of_sync() to fixed frequency.

Don't do so much in a single commit. Separate commits for each logical
change so they can be reviewed well. Also don't send cpufreq along
with devfreq changes, unless they are dependent on each other.
diff mbox series

Patch

diff --git a/drivers/cpufreq/mediatek-cpufreq.c b/drivers/cpufreq/mediatek-cpufreq.c
index 663f61565cf7..3303b6d72ea7 100644
--- a/drivers/cpufreq/mediatek-cpufreq.c
+++ b/drivers/cpufreq/mediatek-cpufreq.c
@@ -49,8 +49,6 @@  struct mtk_cpu_dvfs_info {
 	bool need_voltage_tracking;
 	int vproc_on_boot;
 	int pre_vproc;
-	/* Avoid race condition for regulators between notify and policy */
-	struct mutex reg_lock;
 	struct notifier_block opp_nb;
 	unsigned int opp_cpu;
 	unsigned long current_freq;
@@ -59,6 +57,9 @@  struct mtk_cpu_dvfs_info {
 	bool ccifreq_bound;
 };
 
+/* Avoid race condition for regulators between notify and policy */
+static DEFINE_MUTEX(mtk_policy_lock);
+
 static struct platform_device *cpufreq_pdev;
 
 static LIST_HEAD(dvfs_info_list);
@@ -200,20 +201,29 @@  static bool is_ccifreq_ready(struct mtk_cpu_dvfs_info *info)
 static int mtk_cpufreq_set_target(struct cpufreq_policy *policy,
 				  unsigned int index)
 {
-	struct cpufreq_frequency_table *freq_table = policy->freq_table;
-	struct clk *cpu_clk = policy->clk;
-	struct clk *armpll = clk_get_parent(cpu_clk);
-	struct mtk_cpu_dvfs_info *info = policy->driver_data;
-	struct device *cpu_dev = info->cpu_dev;
+	struct cpufreq_frequency_table *freq_table;
+	struct clk *cpu_clk;
+	struct clk *armpll;
+	struct mtk_cpu_dvfs_info *info;
+	struct device *cpu_dev;
 	struct dev_pm_opp *opp;
 	long freq_hz, pre_freq_hz;
 	int vproc, pre_vproc, inter_vproc, target_vproc, ret;
+	struct cpufreq_freqs freqs;
 
-	inter_vproc = info->intermediate_voltage;
+	mutex_lock(&mtk_policy_lock);
 
-	pre_freq_hz = clk_get_rate(cpu_clk);
+	freq_table = policy->freq_table;
+	cpu_clk = policy->clk;
+	armpll = clk_get_parent(cpu_clk);
+	info = policy->driver_data;
+	cpu_dev = info->cpu_dev;
+	inter_vproc = info->intermediate_voltage;
+	pre_freq_hz = policy->cur * 1000;
 
-	mutex_lock(&info->reg_lock);
+	freqs.old = policy->cur;
+	freqs.new = freq_table[index].frequency;
+	cpufreq_freq_transition_begin(policy, &freqs);
 
 	if (unlikely(info->pre_vproc <= 0))
 		pre_vproc = regulator_get_voltage(info->proc_reg);
@@ -308,7 +318,8 @@  static int mtk_cpufreq_set_target(struct cpufreq_policy *policy,
 	info->current_freq = freq_hz;
 
 out:
-	mutex_unlock(&info->reg_lock);
+	cpufreq_freq_transition_end(policy, &freqs, false);
+	mutex_unlock(&mtk_policy_lock);
 
 	return ret;
 }
@@ -316,19 +327,20 @@  static int mtk_cpufreq_set_target(struct cpufreq_policy *policy,
 static int mtk_cpufreq_opp_notifier(struct notifier_block *nb,
 				    unsigned long event, void *data)
 {
-	struct dev_pm_opp *opp = data;
+	struct dev_pm_opp *opp;
 	struct dev_pm_opp *new_opp;
 	struct mtk_cpu_dvfs_info *info;
 	unsigned long freq, volt;
 	struct cpufreq_policy *policy;
 	int ret = 0;
 
+	mutex_lock(&mtk_policy_lock);
+	opp = data;
 	info = container_of(nb, struct mtk_cpu_dvfs_info, opp_nb);
 
 	if (event == OPP_EVENT_ADJUST_VOLTAGE) {
 		freq = dev_pm_opp_get_freq(opp);
 
-		mutex_lock(&info->reg_lock);
 		if (info->current_freq == freq) {
 			volt = dev_pm_opp_get_voltage(opp);
 			ret = mtk_cpufreq_set_voltage(info, volt);
@@ -336,7 +348,6 @@  static int mtk_cpufreq_opp_notifier(struct notifier_block *nb,
 				dev_err(info->cpu_dev,
 					"failed to scale voltage: %d\n", ret);
 		}
-		mutex_unlock(&info->reg_lock);
 	} else if (event == OPP_EVENT_DISABLE) {
 		freq = dev_pm_opp_get_freq(opp);
 
@@ -361,6 +372,7 @@  static int mtk_cpufreq_opp_notifier(struct notifier_block *nb,
 			}
 		}
 	}
+	mutex_unlock(&mtk_policy_lock);
 
 	return notifier_from_errno(ret);
 }
@@ -495,7 +507,6 @@  static int mtk_cpu_dvfs_info_init(struct mtk_cpu_dvfs_info *info, int cpu)
 	info->intermediate_voltage = dev_pm_opp_get_voltage(opp);
 	dev_pm_opp_put(opp);
 
-	mutex_init(&info->reg_lock);
 	info->current_freq = clk_get_rate(info->cpu_clk);
 
 	info->opp_cpu = cpu;
@@ -597,6 +608,9 @@  static int mtk_cpufreq_init(struct cpufreq_policy *policy)
 	policy->driver_data = info;
 	policy->clk = info->cpu_clk;
 
+	if (info->soc_data->ccifreq_supported)
+		policy->transition_delay_us = 10000;
+
 	return 0;
 }
 
@@ -607,13 +621,32 @@  static void mtk_cpufreq_exit(struct cpufreq_policy *policy)
 	dev_pm_opp_free_cpufreq_table(info->cpu_dev, &policy->freq_table);
 }
 
+static unsigned int mtk_cpufreq_get(unsigned int cpu)
+{
+	struct mtk_cpu_dvfs_info *info;
+	unsigned long current_freq;
+
+	mutex_lock(&mtk_policy_lock);
+	info = mtk_cpu_dvfs_info_lookup(cpu);
+	if (!info) {
+		mutex_unlock(&mtk_policy_lock);
+		return 0;
+	}
+
+	current_freq = info->current_freq / 1000;
+	mutex_unlock(&mtk_policy_lock);
+
+	return current_freq;
+}
+
 static struct cpufreq_driver mtk_cpufreq_driver = {
 	.flags = CPUFREQ_NEED_INITIAL_FREQ_CHECK |
 		 CPUFREQ_HAVE_GOVERNOR_PER_POLICY |
+		 CPUFREQ_ASYNC_NOTIFICATION |
 		 CPUFREQ_IS_COOLING_DEV,
 	.verify = cpufreq_generic_frequency_table_verify,
 	.target_index = mtk_cpufreq_set_target,
-	.get = cpufreq_generic_get,
+	.get = mtk_cpufreq_get,
 	.init = mtk_cpufreq_init,
 	.exit = mtk_cpufreq_exit,
 	.register_em = cpufreq_register_em_with_opp,