@@ -69,13 +69,16 @@ sub-node should be of the format as listed below.
};
};
The above regulator entries are defined in regulator bindings documentation
-except op_mode description.
+except these properties:
- op_mode: describes the different operating modes of the LDO's with
power mode change in SOC. The different possible values are,
0 - always off mode
1 - on in normal mode
2 - low power mode
3 - suspend mode
+ - s5m8767,pmic-ext-control-gpios: (optional) GPIO specifier for one
+ GPIO controlling this regulator (enable/disable); This is
+ valid only for buck9.
The following are the names of the regulators that the s5m8767 pmic block
supports. Note: The 'n' in LDOn and BUCKn represents the LDO or BUCK number
@@ -148,5 +151,13 @@ Example:
regulator-always-on;
regulator-boot-on;
};
+
+ vemmc_reg: BUCK9 {
+ regulator-name = "VMEM_VDD_2.8V";
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ op_mode = <3>; /* Standby Mode */
+ s5m8767,pmic-ext-control-gpios = <&gpk0 2 0>;
+ };
};
};
Add documentation for new binding for controlling (enable/disable) the Buck9 Converter by GPIO (BUCK9EN). Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com> Cc: Kyungmin Park <kyungmin.park@samsung.com> Cc: Marek Szyprowski <m.szyprowski@samsung.com> Cc: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com> --- .../bindings/regulator/s5m8767-regulator.txt | 13 ++++++++++++- 1 file changed, 12 insertions(+), 1 deletion(-)