@@ -351,6 +351,8 @@ static int stm32_spdifrx_start_sync(struct stm32_spdifrx_data *spdifrx)
SPDIFRX_CR_CUMSK | SPDIFRX_CR_PTMSK | SPDIFRX_CR_RXSTEO;
cr_mask = cr;
+ cr |= SPDIFRX_CR_NBTRSET(SPDIFRX_NBTR_63);
+ cr_mask |= SPDIFRX_CR_NBTR_MASK;
cr |= SPDIFRX_CR_SPDIFENSET(SPDIFRX_SPDIFEN_SYNC);
cr_mask |= SPDIFRX_CR_SPDIFEN_MASK;
ret = regmap_update_bits(spdifrx->regmap, STM32_SPDIFRX_CR,
@@ -666,7 +668,7 @@ static irqreturn_t stm32_spdifrx_isr(int irq, void *devid)
struct snd_pcm_substream *substream = spdifrx->substream;
struct platform_device *pdev = spdifrx->pdev;
unsigned int cr, mask, sr, imr;
- unsigned int flags;
+ unsigned int flags, sync_state;
int err = 0, err_xrun = 0;
regmap_read(spdifrx->regmap, STM32_SPDIFRX_SR, &sr);
@@ -726,11 +728,23 @@ static irqreturn_t stm32_spdifrx_isr(int irq, void *devid)
}
if (err) {
- /* SPDIFRX in STATE_STOP. Disable SPDIFRX to clear errors */
+ regmap_read(spdifrx->regmap, STM32_SPDIFRX_CR, &cr);
+ sync_state = FIELD_GET(SPDIFRX_CR_SPDIFEN_MASK, cr) &&
+ SPDIFRX_SPDIFEN_SYNC;
+
+ /* SPDIFRX is in STATE_STOP. Disable SPDIFRX to clear errors */
cr = SPDIFRX_CR_SPDIFENSET(SPDIFRX_SPDIFEN_DISABLE);
regmap_update_bits(spdifrx->regmap, STM32_SPDIFRX_CR,
SPDIFRX_CR_SPDIFEN_MASK, cr);
+ /* If SPDIFRX was in STATE_SYNC, retry synchro */
+ if (sync_state) {
+ cr = SPDIFRX_CR_SPDIFENSET(SPDIFRX_SPDIFEN_SYNC);
+ regmap_update_bits(spdifrx->regmap, STM32_SPDIFRX_CR,
+ SPDIFRX_CR_SPDIFEN_MASK, cr);
+ return IRQ_HANDLED;
+ }
+
if (substream)
snd_pcm_stop(substream, SNDRV_PCM_STATE_DISCONNECTED);
When STM32 SPDIFRX is in sync state, allow multiple synchro attempts, instead of exiting on first unsuccessful trial. This is useful when spdif signal is not immediately available on input. This also allows Pulseaudio to check iec capture device availability when no signal is present. Signed-off-by: Olivier Moysan <olivier.moysan@st.com> --- sound/soc/stm/stm32_spdifrx.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-)