diff mbox

ath10k: Enable RX batching

Message ID 1419834084-11859-1-git-send-email-sujith@msujith.org (mailing list archive)
State Accepted
Headers show

Commit Message

Sujith Manoharan Dec. 29, 2014, 6:21 a.m. UTC 
From: Sujith Manoharan <c_manoha@qca.qualcomm.com>

This feature allows the FW to batch RX indications,
reducing the rate of host interrupt generation, which
in turn reduces CPU load. Currently, this is enabled
only for the 10.2 firmware.

Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
---
 drivers/net/wireless/ath/ath10k/wmi.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

Comments

Kalle Valo Jan. 12, 2015, 11:56 a.m. UTC | #1 
Sujith Manoharan <sujith@msujith.org> writes:

> From: Sujith Manoharan <c_manoha@qca.qualcomm.com>
>
> This feature allows the FW to batch RX indications,
> reducing the rate of host interrupt generation, which
> in turn reduces CPU load. Currently, this is enabled
> only for the 10.2 firmware.
>
> Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>

Thanks, applied.
diff mbox

Patch

diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index b103122..aad08a2 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -3710,7 +3710,7 @@  static struct sk_buff *ath10k_wmi_10_2_op_gen_init(struct ath10k *ar)
 	struct wmi_init_cmd_10_2 *cmd;
 	struct sk_buff *buf;
 	struct wmi_resource_config_10x config = {};
-	u32 len, val;
+	u32 len, val, features = 0;
 
 	config.num_vdevs = __cpu_to_le32(TARGET_10X_NUM_VDEVS);
 	config.num_peers = __cpu_to_le32(TARGET_10X_NUM_PEERS);
@@ -3764,6 +3764,9 @@  static struct sk_buff *ath10k_wmi_10_2_op_gen_init(struct ath10k *ar)
 
 	cmd = (struct wmi_init_cmd_10_2 *)buf->data;
 
+	features |= WMI_10_2_RX_BATCH_MODE;
+	cmd->resource_config.feature_mask = __cpu_to_le32(features);
+
 	memcpy(&cmd->resource_config.common, &config, sizeof(config));
 	ath10k_wmi_put_host_mem_chunks(ar, &cmd->mem_chunks);