@@ -952,12 +952,21 @@ static int sta_apply_auth_flags(struct ieee80211_local *local,
}
if (mask & BIT(NL80211_STA_FLAG_AUTHORIZED)) {
- if (set & BIT(NL80211_STA_FLAG_AUTHORIZED))
+ if (set & BIT(NL80211_STA_FLAG_AUTHORIZED)) {
+ /*
+ * When peer becomes authorized, init rate control as
+ * well. Some drivers require rate control initialized
+ * before drv_sta_state() is called.
+ */
+ if (test_sta_flag(sta, WLAN_STA_TDLS_PEER))
+ rate_control_rate_init(sta);
+
ret = sta_info_move_state(sta, IEEE80211_STA_AUTHORIZED);
- else if (test_sta_flag(sta, WLAN_STA_AUTHORIZED))
+ } else if (test_sta_flag(sta, WLAN_STA_AUTHORIZED)) {
ret = sta_info_move_state(sta, IEEE80211_STA_ASSOC);
- else
+ } else {
ret = 0;
+ }
if (ret)
return ret;
}
@@ -1346,11 +1355,6 @@ static int ieee80211_change_station(struct wiphy *wiphy,
if (err)
goto out_err;
- /* When peer becomes authorized, init rate control as well */
- if (test_sta_flag(sta, WLAN_STA_TDLS_PEER) &&
- test_sta_flag(sta, WLAN_STA_AUTHORIZED))
- rate_control_rate_init(sta);
-
mutex_unlock(&local->sta_mtx);
if ((sdata->vif.type == NL80211_IFTYPE_AP ||
Currently when TDLS station in driver goes from assoc to authorized state it can not use rate control parameters because rate control is not initialized yet. Some drivers require parameters already initialized by rate control when entering authorized state. It can be done by initializing rate control after station transition to authorized state but before notifying driver about that. Signed-off-by: Marek Puzyniak <marek.puzyniak@tieto.com> --- net/mac80211/cfg.c | 20 ++++++++++++-------- 1 file changed, 12 insertions(+), 8 deletions(-)