@@ -1965,7 +1965,9 @@ int ath10k_debug_start(struct ath10k *ar)
ath10k_warn(ar, "failed to disable pktlog: %d\n", ret);
}
- if (ar->debug.nf_cal_period) {
+ if (ar->debug.nf_cal_period &&
+ !test_bit(ATH10K_FW_FEATURE_NON_BMI,
+ ar->normal_mode_fw.fw_file.fw_features)) {
ret = ath10k_wmi_pdev_set_param(ar,
ar->wmi.pdev_param->cal_period,
ar->debug.nf_cal_period);
@@ -1982,7 +1984,9 @@ void ath10k_debug_stop(struct ath10k *ar)
{
lockdep_assert_held(&ar->conf_mutex);
- ath10k_debug_cal_data_fetch(ar);
+ if (!test_bit(ATH10K_FW_FEATURE_NON_BMI,
+ ar->normal_mode_fw.fw_file.fw_features))
+ ath10k_debug_cal_data_fetch(ar);
/* Must not use _sync to avoid deadlock, we do that in
* ath10k_debug_destroy(). The check for htt_stats_mask is to avoid
@@ -2484,15 +2488,18 @@ int ath10k_debug_register(struct ath10k *ar)
debugfs_create_file("fw_dbglog", 0600, ar->debug.debugfs_phy, ar,
&fops_fw_dbglog);
- debugfs_create_file("cal_data", 0400, ar->debug.debugfs_phy, ar,
- &fops_cal_data);
+ if (!test_bit(ATH10K_FW_FEATURE_NON_BMI,
+ ar->normal_mode_fw.fw_file.fw_features)) {
+ debugfs_create_file("cal_data", 0400, ar->debug.debugfs_phy, ar,
+ &fops_cal_data);
+
+ debugfs_create_file("nf_cal_period", 0600, ar->debug.debugfs_phy, ar,
+ &fops_nf_cal_period);
+ }
debugfs_create_file("ani_enable", 0600, ar->debug.debugfs_phy, ar,
&fops_ani_enable);
- debugfs_create_file("nf_cal_period", 0600, ar->debug.debugfs_phy, ar,
- &fops_nf_cal_period);
-
if (IS_ENABLED(CONFIG_ATH10K_DFS_CERTIFIED)) {
debugfs_create_file("dfs_simulate_radar", 0200, ar->debug.debugfs_phy,
ar, &fops_simulate_radar);
In non-bmi target ex. WCN3990, data calibration is handled via QMI. Skip data calibration in debug routine to enable ath10k debugfs for non bmi targets. Signed-off-by: Surabhi Vishnoi <svishnoi@codeaurora.org> --- drivers/net/wireless/ath/ath10k/debug.c | 21 ++++++++++++++------- 1 file changed, 14 insertions(+), 7 deletions(-)