diff mbox series

[RESEND,5.10.y-cip,03/40] mmc: renesas_sdhi: populate SCC pointer at the proper place

Message ID 20220401194234.14057-4-prabhakar.mahadev-lad.rj@bp.renesas.com (mailing list archive)
State New
Headers show
Series Add SD/eMMC support for Renesas RZ/G2L SoC | expand

Commit Message

Lad Prabhakar April 1, 2022, 7:41 p.m. UTC 
From: Wolfram Sang <wsa+renesas@sang-engineering.com>

commit d14ac691bb6f6ebaa7eeec21ca04dd47300ff5b6 upstream.

The SCC pointer is currently filled whenever the SoC is Gen2+. This is
wrong because there is a Gen2-variant without SCC (SDHI_VER_GEN2_SDR50).
We have been lucky because the writes to unintended registers have not
caused problems so far. But further refactoring work exposed the
problem. So, move the pointer initialization to the place where we know
that the SDHI instance supports tuning. And also populate the 'reset'
pointer unconditionally to make sure the interrupt enable register is
always properly set for Gen2+.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Tested-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Link: https://lore.kernel.org/r/20201110142058.36393-4-wsa+renesas@sang-engineering.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
---
 drivers/mmc/host/renesas_sdhi_core.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c
index 9dc9824e1f76..fc210c314e6c 100644
--- a/drivers/mmc/host/renesas_sdhi_core.c
+++ b/drivers/mmc/host/renesas_sdhi_core.c
@@ -1012,11 +1012,7 @@  int renesas_sdhi_probe(struct platform_device *pdev,
 		host->ops.start_signal_voltage_switch =
 			renesas_sdhi_start_signal_voltage_switch;
 		host->sdcard_irq_setbit_mask = TMIO_STAT_ALWAYS_SET_27;
-
-		if (of_data && of_data->scc_offset) {
-			priv->scc_ctl = host->ctl + of_data->scc_offset;
-			host->reset = renesas_sdhi_reset;
-		}
+		host->reset = renesas_sdhi_reset;
 	}
 
 	/* Orginally registers were 16 bit apart, could be 32 or 64 nowadays */
@@ -1096,6 +1092,7 @@  int renesas_sdhi_probe(struct platform_device *pdev,
 		if (!hit)
 			dev_warn(&host->pdev->dev, "Unknown clock rate for tuning\n");
 
+		priv->scc_ctl = host->ctl + of_data->scc_offset;
 		host->check_retune = renesas_sdhi_check_scc_error;
 		host->ops.execute_tuning = renesas_sdhi_execute_tuning;
 		host->ops.prepare_hs400_tuning = renesas_sdhi_prepare_hs400_tuning;