@@ -354,6 +354,16 @@ struct v4l2_mbus_frame_desc {
unsigned short num_entries;
};
+/**
+ * enum v4l2_subdev_pre_streamon_flags - Flags for pre_streamon subdev core op
+ *
+ * @V4L2_SUBDEV_PRE_STREAMON_FL_MANUAL_LP: Set the transmitter to either LP-11
+ * or LP-111 mode before call to s_stream().
+ */
+enum v4l2_subdev_pre_streamon_flags {
+ V4L2_SUBDEV_PRE_STREAMON_FL_MANUAL_LP = BIT(0),
+};
+
/**
* struct v4l2_subdev_video_ops - Callbacks used when v4l device was opened
* in video mode.
@@ -409,6 +419,19 @@ struct v4l2_mbus_frame_desc {
* @s_rx_buffer: set a host allocated memory buffer for the subdev. The subdev
* can adjust @size to a lower value and must not write more data to the
* buffer starting at @data than the original value of @size.
+ *
+ * @pre_streamon: May be called before streaming is actually started, to help
+ * initialising the bus. Current usage is to set a CSI-2 transmitter to
+ * LP-11 or LP-111 mode before streaming. See &enum
+ * v4l2_subdev_pre_streamon_flags.
+ *
+ * pre_streamon shall return error if it cannot perform the operation as
+ * indicated by the flags argument. In particular, -EACCES indicates lack
+ * of support for the operation. The caller shall call post_streamoff for
+ * each successful call of pre_streamon.
+ *
+ * @post_streamoff: Called after streaming is stopped, but if and only if
+ * pre_streamon was called earlier.
*/
struct v4l2_subdev_video_ops {
int (*s_routing)(struct v4l2_subdev *sd, u32 input, u32 output, u32 config);
@@ -435,6 +458,8 @@ struct v4l2_subdev_video_ops {
struct v4l2_dv_timings *timings);
int (*s_rx_buffer)(struct v4l2_subdev *sd, void *buf,
unsigned int *size);
+ int (*pre_streamon)(struct v4l2_subdev *sd, u32 flags);
+ int (*post_streamoff)(struct v4l2_subdev *sd);
};
/**