[v4,0/9] Add display support for QCS615 platform

Message

Fange Zhang Dec. 10, 2024, 6:53 a.m. UTC

This series aims to enable display on the QCS615 platform

1.Add MDSS & DPU support for QCS615
2.Add DSI support for QCS615

QCS615 platform supports DisplayPort, and this feature will be added in a future patch

Only dts part of this patch series depends on the following patch series
The other dependency patches have already been merged into linux-next
- dispcc
https://lore.kernel.org/all/[e-mail]/
- dispcc dts
https://lore.kernel.org/lkml/[e-mail]/

Signed-off-by: Li Liu <[e-mail]>
Signed-off-by: Fange Zhang <[e-mail]>
---
Changes in v4:
- Add dp-connector node for anx_7625_out [Dmitry]
- Add missing qcom,sm6150-dsi-ctrl for dsi-controller-main.yaml [Krzysztof]
- Change VIG_SDM845_MASK to VIG_SDM845_MASK_SDMA for sm6150_sspp [Abhinav]
- Change DMA_SDM845_MASK to DMA_SDM845_MASK_SDMA for sm6150_sspp [Abhinav]
- Remove redundant annotation from sdm845_dsi_cfg [Dmitry]
- Remove redundant blocks from sm6150_intf [Dmitry]
- Update mdp_opp_table opp clk to correct value
- Link to v3: https://lore.kernel.org/r/20[e-mail]

Changes in v3:
- Add reg_bus_bw for sm6150_data [Dmitry]
- Remove patch for SX150X defconfig [Dmitry]
- Remove dsi0_hpd_cfg_pins from ioexp [Dmitry]
- Remove dsi0_cdet_cfg_pins from ioexpa [Dmitry]
- Remove tlmm node for ioexp_intr_active and ioAexp_reset_active [Dmitry]
- Remove qcs615_dsi_regulators and reuse sdm845_dsi_cfg [Dmitry, Konrad]
- Rename qcs615/QCS615 to sm6150/SM6150 for whole patch [Dmitry]
- Rename qcom,dsi-phy-14nm-615 to qcom,sm6150-dsi-phy-14nm [Dmitry]
- Rename qcom,qcs615-dsi-ctrl to qcom,sm6150-dsi-ctrl [Dmitry]
- Rename qcom,qcs615-dpu to qcom,sm6150-dpu [Dmitry]
- Rename qcom,qcs615-mdss to qcom,sm6150-mdss [Dmitry]
- Split drm dsi patch to dsi and dsi phy [Dmitry]
- Update yaml clocks node with ephemeral nodes and remove unsed include [Dmitry, Rob]
- Link to v2: https://lore.kernel.org/r/20[e-mail]

Changes in v2:
- Add QCS615 DP controller comment in commit message [Dmitry]
- Add comments for dsi_dp_hpd_cfg_pins and dsi_dp_cdet_cfg_pins [Dmitry]
- Add missing port@1 for connector for anx7625 [Dmitry]
- Change 0 to QCOM_ICC_TAG_ALWAYS for mdss interconnects [Dmitry]
- Change 0 to GPIO_ACTIVE_HIGH for GPIO flags [Dmitry]
- Move anx_7625 to same node [Dmitry]
- Move status to last in mdss_dsi0 [Dmitry]
- Rename dsi0_hpd_cfg_pins to dsi_dp_hpd_cfg_pins in ioexp [Dmitry]
- Rename dsi0_cdet_cfg_pins to dsi_dp_cdet_cfg_pins in ioexp [Dmitry]
- Rename anx_7625_1 to dsi_anx_7625 in ioexp [Dmitry]
- Remove absent block in qcs615_lm [Dmitry]
- Remove merge_3d value in qcs615_pp [Dmitry]
- Remove redundant annotation in qcs615_sspp [Dmitry]
- Remove unsupported dsi clk from dsi0_opp_table [Dmitry]
- Remove dp_hpd_cfg_pins node from ioexp [Dmitry]
- Splite drm driver patches to mdss, dpu and dsi [Dmitry]
- Link to v1: https://lore.kernel.org/r/[e-mail]

---
Li Liu (9):
      dt-bindings: display/msm: Add SM6150 DSI phy
      dt-bindings: display/msm: dsi-controller-main: Document SM6150
      dt-bindings: display/msm: Add SM6150 MDSS & DPU
      drm/msm: mdss: Add SM6150 support
      drm/msm/dpu: Add SM6150 support
      drm/msm/dsi: Add dsi phy support for SM6150
      drm/msm/dsi: Add support for SM6150
      arm64: dts: qcom: Add display support for QCS615
      arm64: dts: qcom: Add display support for QCS615 RIDE board

 .../bindings/display/msm/dsi-controller-main.yaml  |   2 +
 .../bindings/display/msm/dsi-phy-14nm.yaml         |   1 +
 .../bindings/display/msm/qcom,sm6150-dpu.yaml      | 108 +++++++++
 .../bindings/display/msm/qcom,sm6150-mdss.yaml     | 245 ++++++++++++++++++++
 arch/arm64/boot/dts/qcom/qcs615-ride.dts           |  89 ++++++++
 arch/arm64/boot/dts/qcom/qcs615.dtsi               | 181 ++++++++++++++-
 .../gpu/drm/msm/disp/dpu1/catalog/dpu_5_3_sm6150.h | 254 +++++++++++++++++++++
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_catalog.c     |   1 +
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_catalog.h     |   1 +
 drivers/gpu/drm/msm/disp/dpu1/dpu_kms.c            |   1 +
 drivers/gpu/drm/msm/dsi/dsi_cfg.c                  |   2 +
 drivers/gpu/drm/msm/dsi/dsi_cfg.h                  |   1 +
 drivers/gpu/drm/msm/dsi/phy/dsi_phy.c              |   2 +
 drivers/gpu/drm/msm/dsi/phy/dsi_phy.h              |   1 +
 drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c         |  21 ++
 drivers/gpu/drm/msm/msm_mdss.c                     |   8 +
 16 files changed, 917 insertions(+), 1 deletion(-)
---
base-commit: 1031240d9d007339c6661dddfbe2efda0b3859e9
change-id: 20241209-add-display-support-for-qcs615-platform-22b8e8848f87

Best regards,