new file mode 100644
@@ -0,0 +1,43 @@
+Rockchip specific extensions to the Synopsys Designware HDMI
+================================
+
+Required properties:
+- compatible: "rockchip,rk3288-dw-hdmi";
+- reg: Physical base address and length of the controller's registers.
+- ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
+- clocks: from common clock binding: handle to hdmi clock.
+- clock-names: should be "clk" "hdcp_clk"
+- rockchip,grf: this soc should set GRF regs to mux vopl/vopb.
+- interrupts: HDMI interrupt number
+- ports: contain a port node with endpoint definitions as defined in
+ Documentation/devicetree/bindings/media/video-interfaces.txt. For
+ vopb,set the reg = <0> and set the reg = <1> for vopl.
+- reg-io-width: the width of the reg:1,4, the value should be 4 on
+ rk3288 platform
+
+Example:
+hdmi: hdmi@ff980000 {
+ compatible = "rockchip,rk3288-dw-hdmi";
+ reg = <0xff980000 0x20000>;
+ reg-io-width = <4>;
+ ddc-i2c-bus = <&i2c5>;
+ rockchip,grf = <&grf>;
+ interrupts = <GIC_SPI 103 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&cru PCLK_HDMI_CTRL>, <&cru SCLK_HDMI_HDCP>;
+ clock-names = "clk", "hdcp_clk";
+ status = "disabled";
+ ports {
+ hdmi_in: port {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ hdmi_in_vopb: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&vopb_out_hdmi>;
+ };
+ hdmi_in_vopl: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&vopl_out_hdmi>;
+ };
+ };
+ };
+};
Signed-off-by: Andy Yan <andy.yan@rock-chips.com> --- Changes in v15: None Changes in v14: None Changes in v13: None Changes in v12: None Changes in v11: None Changes in v10: None Changes in v9: None Changes in v8: - Add documentation for rockchip dw hdmi Changes in v7: None Changes in v6: None Changes in v5: None Changes in v4: None Changes in v3: None .../devicetree/bindings/video/dw_hdmi-rockchip.txt | 43 ++++++++++++++++++++++ 1 file changed, 43 insertions(+) create mode 100644 Documentation/devicetree/bindings/video/dw_hdmi-rockchip.txt