[46/59] drm/kmb: Enable LCD interrupts during modeset

Commit Message

Chrisanthus, Anitha June 30, 2020, 9:27 p.m. UTC

The issue was that spurious interrupts were happening before the LCD
controller was enabled and system hangs. Fix is to
clear LCD interrupts and disable them before modeset
and re enable them after enabling LCD controller.

Signed-off-by: Anitha Chrisanthus <[e-mail]>
Reviewed-by: Bob Paauwe <[e-mail]>
---
 drivers/gpu/drm/kmb/kmb_crtc.c |  6 +++++-
 drivers/gpu/drm/kmb/kmb_drv.c  | 21 +++------------------
 2 files changed, 8 insertions(+), 19 deletions(-)

Patch

diff --git a/drivers/gpu/drm/kmb/kmb_crtc.c b/drivers/gpu/drm/kmb/kmb_crtc.c
index b617507..16f6c7f 100644
--- a/drivers/gpu/drm/kmb/kmb_crtc.c
+++ b/drivers/gpu/drm/kmb/kmb_crtc.c
@@ -97,6 +97,7 @@  static void kmb_crtc_mode_set_nofb(struct drm_crtc *crtc)
 	struct videomode vm;
 	int vsync_start_offset;
 	int vsync_end_offset;
+	unsigned int val = 0;
 
 	/* initialize mipi */
 	kmb_dsi_hw_init(dev, m);
@@ -107,6 +108,9 @@  static void kmb_crtc_mode_set_nofb(struct drm_crtc *crtc)
 			m->crtc_hsync_start - m->crtc_hdisplay,
 			m->crtc_htotal - m->crtc_hsync_end,
 			m->crtc_hsync_end - m->crtc_hsync_start);
+	val = kmb_read_lcd(dev->dev_private, LCD_INT_ENABLE);
+	kmb_clr_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE, val);
+	kmb_set_bitmask_lcd(dev->dev_private, LCD_INT_CLEAR, ~0x0);
 //	vm.vfront_porch = m->crtc_vsync_start - m->crtc_vdisplay;
 	vm.vfront_porch = 2;
 //	vm.vback_porch = m->crtc_vtotal - m->crtc_vsync_end;
@@ -155,9 +159,9 @@  static void kmb_crtc_mode_set_nofb(struct drm_crtc *crtc)
 		kmb_write_lcd(dev->dev_private, LCD_VSYNC_START_EVEN, 10);
 		kmb_write_lcd(dev->dev_private, LCD_VSYNC_END_EVEN, 10);
 	}
-	/* enable VL1 layer as default */
 	kmb_write_lcd(dev->dev_private, LCD_TIMING_GEN_TRIG, ENABLE);
 	kmb_set_bitmask_lcd(dev->dev_private, LCD_CONTROL, LCD_CTRL_ENABLE);
+	kmb_set_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE, val);
 #endif
 	/* TBD */
 	/* set clocks here */
diff --git a/drivers/gpu/drm/kmb/kmb_drv.c b/drivers/gpu/drm/kmb/kmb_drv.c
index d987529..26d004c 100644
--- a/drivers/gpu/drm/kmb/kmb_drv.c
+++ b/drivers/gpu/drm/kmb/kmb_drv.c
@@ -57,8 +57,6 @@  static irqreturn_t kmb_isr(int irq, void *arg);
 
 static struct clk *clk_lcd;
 static struct clk *clk_mipi;
-static struct clk *clk_msscam;
-static struct clk *clk_pll0out0;
 static struct clk *clk_mipi_ecfg;
 static struct clk *clk_mipi_cfg;
 
@@ -79,12 +77,6 @@  int kmb_display_clk_enable(void)
 		DRM_ERROR("Failed to enable MIPI clock: %d\n", ret);
 		return ret;
 	}
-/*	ret = clk_prepare_enable(clk_msscam);
-	if (ret) {
-		DRM_ERROR("Failed to enable MSSCAM clock: %d\n", ret);
-		return ret;
-	}
-	*/
 
 	ret = clk_prepare_enable(clk_mipi_ecfg);
 	if (ret) {
@@ -107,8 +99,6 @@  static int kmb_display_clk_disable(void)
 		clk_disable_unprepare(clk_lcd);
 	if (clk_mipi)
 		clk_disable_unprepare(clk_mipi);
-	if (clk_msscam)
-		clk_disable_unprepare(clk_msscam);
 	if (clk_mipi_ecfg)
 		clk_disable_unprepare(clk_mipi_ecfg);
 	if (clk_mipi_cfg)
@@ -200,14 +190,6 @@  static int kmb_load(struct drm_device *drm, unsigned long flags)
 		DRM_ERROR("clk_get() failed clk_mipi\n");
 		goto setup_fail;
 	}
-	clk_pll0out0 = clk_get(&pdev->dev, "clk_pll0_out0");
-	if (IS_ERR(clk_pll0out0))
-		DRM_ERROR("clk_get() failed clk_pll0_out0\n");
-
-	if (clk_pll0out0)
-		DRM_INFO("Get clk_pll0out0 = %ld\n",
-				clk_get_rate(clk_pll0out0));
-
 	clk_mipi_ecfg = clk_get(&pdev->dev, "clk_mipi_ecfg");
 	if (IS_ERR(clk_mipi_ecfg)) {
 		DRM_ERROR("clk_get() failed clk_mipi_ecfg\n");
@@ -413,6 +395,9 @@  static irqreturn_t handle_lcd_irq(struct drm_device *dev)
 			break;
 		}
 	}
+
+	/* clear all interrupts */
+	kmb_set_bitmask_lcd(dev->dev_private, LCD_INT_CLEAR, ~0x0);
 	return IRQ_HANDLED;
 }