@@ -40,6 +40,7 @@ CEC. It is one end of the pipeline.
Required properties:
- compatible: value must be one of:
+ * allwinner,sun4i-a10-hdmi
* allwinner,sun5i-a10s-hdmi
* allwinner,sun6i-a31-hdmi
- reg: base address and size of memory-mapped region
@@ -289,6 +289,58 @@ static const struct cec_pin_ops sun4i_hdmi_cec_pin_ops = {
#define SUN4I_HDMI_PAD_CTRL1_MASK (GENMASK(24, 7) | GENMASK(5, 0))
#define SUN4I_HDMI_PLL_CTRL_MASK (GENMASK(31, 8) | GENMASK(3, 0))
+/* Only difference from sun5i is AMP is 4 instead of 6 */
+static const struct sun4i_hdmi_variant sun4i_variant = {
+ .pad_ctrl0_init_val = SUN4I_HDMI_PAD_CTRL0_TXEN |
+ SUN4I_HDMI_PAD_CTRL0_CKEN |
+ SUN4I_HDMI_PAD_CTRL0_PWENG |
+ SUN4I_HDMI_PAD_CTRL0_PWEND |
+ SUN4I_HDMI_PAD_CTRL0_PWENC |
+ SUN4I_HDMI_PAD_CTRL0_LDODEN |
+ SUN4I_HDMI_PAD_CTRL0_LDOCEN |
+ SUN4I_HDMI_PAD_CTRL0_BIASEN,
+ .pad_ctrl1_init_val = SUN4I_HDMI_PAD_CTRL1_REG_AMP(4) |
+ SUN4I_HDMI_PAD_CTRL1_REG_EMP(2) |
+ SUN4I_HDMI_PAD_CTRL1_REG_DENCK |
+ SUN4I_HDMI_PAD_CTRL1_REG_DEN |
+ SUN4I_HDMI_PAD_CTRL1_EMPCK_OPT |
+ SUN4I_HDMI_PAD_CTRL1_EMP_OPT |
+ SUN4I_HDMI_PAD_CTRL1_AMPCK_OPT |
+ SUN4I_HDMI_PAD_CTRL1_AMP_OPT,
+ .pll_ctrl_init_val = SUN4I_HDMI_PLL_CTRL_VCO_S(8) |
+ SUN4I_HDMI_PLL_CTRL_CS(7) |
+ SUN4I_HDMI_PLL_CTRL_CP_S(15) |
+ SUN4I_HDMI_PLL_CTRL_S(7) |
+ SUN4I_HDMI_PLL_CTRL_VCO_GAIN(4) |
+ SUN4I_HDMI_PLL_CTRL_SDIV2 |
+ SUN4I_HDMI_PLL_CTRL_LDO2_EN |
+ SUN4I_HDMI_PLL_CTRL_LDO1_EN |
+ SUN4I_HDMI_PLL_CTRL_HV_IS_33 |
+ SUN4I_HDMI_PLL_CTRL_BWS |
+ SUN4I_HDMI_PLL_CTRL_PLL_EN,
+
+ .ddc_clk_reg = REG_FIELD(SUN4I_HDMI_DDC_CLK_REG, 0, 6),
+ .ddc_clk_pre_divider = 2,
+ .ddc_clk_m_offset = 1,
+
+ .field_ddc_en = REG_FIELD(SUN4I_HDMI_DDC_CTRL_REG, 31, 31),
+ .field_ddc_start = REG_FIELD(SUN4I_HDMI_DDC_CTRL_REG, 30, 30),
+ .field_ddc_reset = REG_FIELD(SUN4I_HDMI_DDC_CTRL_REG, 0, 0),
+ .field_ddc_addr_reg = REG_FIELD(SUN4I_HDMI_DDC_ADDR_REG, 0, 31),
+ .field_ddc_slave_addr = REG_FIELD(SUN4I_HDMI_DDC_ADDR_REG, 0, 6),
+ .field_ddc_int_status = REG_FIELD(SUN4I_HDMI_DDC_INT_STATUS_REG, 0, 8),
+ .field_ddc_fifo_clear = REG_FIELD(SUN4I_HDMI_DDC_FIFO_CTRL_REG, 31, 31),
+ .field_ddc_fifo_rx_thres = REG_FIELD(SUN4I_HDMI_DDC_FIFO_CTRL_REG, 4, 7),
+ .field_ddc_fifo_tx_thres = REG_FIELD(SUN4I_HDMI_DDC_FIFO_CTRL_REG, 0, 3),
+ .field_ddc_byte_count = REG_FIELD(SUN4I_HDMI_DDC_BYTE_COUNT_REG, 0, 9),
+ .field_ddc_cmd = REG_FIELD(SUN4I_HDMI_DDC_CMD_REG, 0, 2),
+ .field_ddc_sda_en = REG_FIELD(SUN4I_HDMI_DDC_LINE_CTRL_REG, 9, 9),
+ .field_ddc_sck_en = REG_FIELD(SUN4I_HDMI_DDC_LINE_CTRL_REG, 8, 8),
+
+ .ddc_fifo_reg = SUN4I_HDMI_DDC_FIFO_DATA_REG,
+ .ddc_fifo_has_dir = true,
+};
+
static const struct sun4i_hdmi_variant sun5i_variant = {
.pad_ctrl0_init_val = SUN4I_HDMI_PAD_CTRL0_TXEN |
SUN4I_HDMI_PAD_CTRL0_CKEN |
@@ -613,6 +665,7 @@ static int sun4i_hdmi_remove(struct platform_device *pdev)
}
static const struct of_device_id sun4i_hdmi_of_table[] = {
+ { .compatible = "allwinner,sun4i-a10-hdmi", .data = &sun4i_variant, },
{ .compatible = "allwinner,sun5i-a10s-hdmi", .data = &sun5i_variant, },
{ .compatible = "allwinner,sun6i-a31-hdmi", .data = &sun6i_variant, },
{ }
The HDMI controller in the A10 SoC is the same as the one currently supported in the A10s. It has slightly different setup parameters. Since these parameters are not thoroughly understood, we add support for this variant by copying these parameters verbatim. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- .../bindings/display/sunxi/sun4i-drm.txt | 1 + drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c | 53 ++++++++++++++++++++++ 2 files changed, 54 insertions(+)