@@ -218,6 +218,10 @@ struct dw_mipi_dsi_rockchip {
struct clk *grf_clk;
struct clk *phy_cfg_clk;
+ /* dual-channel */
+ bool is_slave;
+ struct dw_mipi_dsi_rockchip *slave;
+
unsigned int lane_mbps; /* per lane */
u16 input_div;
u16 feedback_div;
@@ -604,6 +608,8 @@ static void dw_mipi_dsi_encoder_mode_set(struct drm_encoder *encoder,
}
dw_mipi_dsi_rockchip_config(dsi, mux);
+ if (dsi->slave)
+ dw_mipi_dsi_rockchip_config(dsi->slave, mux);
clk_disable_unprepare(dsi->grf_clk);
}
@@ -632,6 +638,8 @@ dw_mipi_dsi_encoder_atomic_check(struct drm_encoder *encoder,
}
s->output_type = DRM_MODE_CONNECTOR_DSI;
+ if (dsi->slave)
+ s->output_flags = ROCKCHIP_OUTPUT_DSI_DUAL;
return 0;
}
@@ -641,6 +649,8 @@ static void dw_mipi_dsi_encoder_disable(struct drm_encoder *encoder)
struct dw_mipi_dsi_rockchip *dsi = to_dsi(encoder);
pm_runtime_put(dsi->dev);
+ if (dsi->slave)
+ pm_runtime_put(dsi->slave->dev);
}
static const struct drm_encoder_helper_funcs
@@ -681,18 +691,70 @@ static int dw_mipi_dsi_rockchip_bind(struct device *dev,
{
struct dw_mipi_dsi_rockchip *dsi = dev_get_drvdata(dev);
struct drm_device *drm_dev = data;
+ struct device_node *second_np;
struct drm_bridge *bridge;
struct drm_panel *panel;
+ bool master1, master2;
int ret;
/*
- * Handle probe-deferrals due to missing display.
+ * At this point both DSIs (if in use) should have probed and found
+ * any connected displays or bridges.
+ * This also takes care of handling possible probe-deferrals.
*/
ret = drm_of_find_panel_or_bridge(dsi->dev->of_node, 1, 0,
&panel, &bridge);
if (ret)
return ret;
+ second_np = of_mipi_dsi_find_second_host(dsi->dev->of_node, 1, 0);
+ if (IS_ERR(second_np))
+ return PTR_ERR(second_np);
+
+ if (second_np) {
+ struct platform_device *pdev;
+
+ master1 = of_property_read_bool(dsi->dev->of_node,
+ "clock-master");
+ master2 = of_property_read_bool(second_np, "clock-master");
+
+ if (master1 && master2) {
+ DRM_DEV_ERROR(dsi->dev, "only one clock-master allowed\n");
+ of_node_put(second_np);
+ return -EINVAL;
+ }
+
+ if (!master1 && !master2) {
+ DRM_DEV_ERROR(dsi->dev, "no clock-master defined\n");
+ of_node_put(second_np);
+ return -EINVAL;
+ }
+
+ /* we are the slave in dual-DSI */
+ if (!master1) {
+ dsi->is_slave = true;
+ of_node_put(second_np);
+ return 0;
+ }
+
+ pdev = of_find_device_by_node(second_np);
+ if (!pdev) {
+ DRM_DEV_ERROR(dev, "could not find slave controller\n");
+ return -ENODEV;
+ }
+
+ dsi->slave = platform_get_drvdata(pdev);
+ if (!dsi->slave) {
+ DRM_DEV_ERROR(dev, "could not get slaves platform-data\n");
+ return -ENODEV;
+ }
+
+ dsi->slave->is_slave = true;
+ dw_mipi_dsi_set_slave(dsi->dmd, dsi->slave->dmd);
+
+ of_node_put(second_np);
+ }
+
ret = rockchip_dsi_drm_create_encoder(dsi, drm_dev);
if (ret) {
DRM_DEV_ERROR(dev, "Failed to create drm encoder\n");
@@ -714,6 +776,9 @@ static void dw_mipi_dsi_rockchip_unbind(struct device *dev,
{
struct dw_mipi_dsi_rockchip *dsi = dev_get_drvdata(dev);
+ if (dsi->is_slave)
+ return;
+
dw_mipi_dsi_unbind(dsi->dmd);
}
@@ -37,6 +37,7 @@ struct rockchip_crtc_state {
int output_type;
int output_mode;
int output_bpc;
+ int output_flags;
};
#define to_rockchip_crtc_state(s) \
container_of(s, struct rockchip_crtc_state, base)
@@ -916,6 +916,7 @@ static void vop_crtc_atomic_enable(struct drm_crtc *crtc,
pin_pol |= (adjusted_mode->flags & DRM_MODE_FLAG_PVSYNC) ?
BIT(VSYNC_POSITIVE) : 0;
VOP_REG_SET(vop, output, pin_pol, pin_pol);
+ VOP_REG_SET(vop, output, mipi_dual_channel_en, 0);
switch (s->output_type) {
case DRM_MODE_CONNECTOR_LVDS:
@@ -933,6 +934,8 @@ static void vop_crtc_atomic_enable(struct drm_crtc *crtc,
case DRM_MODE_CONNECTOR_DSI:
VOP_REG_SET(vop, output, mipi_pin_pol, pin_pol);
VOP_REG_SET(vop, output, mipi_en, 1);
+ VOP_REG_SET(vop, output, mipi_dual_channel_en,
+ !!(s->output_flags & ROCKCHIP_OUTPUT_DSI_DUAL));
break;
case DRM_MODE_CONNECTOR_DisplayPort:
pin_pol &= ~BIT(DCLK_INVERT);
@@ -60,6 +60,7 @@ struct vop_output {
struct vop_reg edp_en;
struct vop_reg hdmi_en;
struct vop_reg mipi_en;
+ struct vop_reg mipi_dual_channel_en;
struct vop_reg rgb_en;
};
@@ -213,6 +214,9 @@ struct vop_data {
/* for use special outface */
#define ROCKCHIP_OUT_MODE_AAAA 15
+/* output flags */
+#define ROCKCHIP_OUTPUT_DSI_DUAL BIT(0)
+
enum alpha_mode {
ALPHA_STRAIGHT,
ALPHA_INVERSE,
@@ -421,6 +421,7 @@ static const struct vop_output rk3399_output = {
.hdmi_en = VOP_REG(RK3288_SYS_CTRL, 0x1, 13),
.edp_en = VOP_REG(RK3288_SYS_CTRL, 0x1, 14),
.mipi_en = VOP_REG(RK3288_SYS_CTRL, 0x1, 15),
+ .mipi_dual_channel_en = VOP_REG(RK3288_SYS_CTRL, 0x1, 3),
};
static const struct vop_data rk3399_vop_big = {
Add the Rockchip-sepcific dual-dsi setup and hook it into the VOP as well. As described in the general dual-dsi devicetree binding, the panel should define two input ports and point each of them to one of the used dsi- controllers, as well as declare one of them as clock-master. This is used to determine the dual-dsi state and get access to both controller instances. Signed-off-by: Heiko Stuebner <heiko@sntech.de> --- .../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c | 67 ++++++++++++++++++- drivers/gpu/drm/rockchip/rockchip_drm_drv.h | 1 + drivers/gpu/drm/rockchip/rockchip_drm_vop.c | 3 + drivers/gpu/drm/rockchip/rockchip_drm_vop.h | 4 ++ drivers/gpu/drm/rockchip/rockchip_vop_reg.c | 1 + 5 files changed, 75 insertions(+), 1 deletion(-)