@@ -320,6 +320,11 @@
#address-cells = <1>;
#size-cells = <0>;
reg = <1>;
+
+ tcon0_out_dsi: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&dsi_in_tcon0>;
+ };
};
};
};
@@ -818,6 +823,45 @@
#interrupt-cells = <3>;
};
+
+ dsi: dsi@1ca0000 {
+ compatible = "allwinner,sun50i-a64-mipi-dsi";
+ reg = <0x01ca0000 0x1000>;
+ interrupts = <GIC_SPI 89 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_MIPI_DSI>;
+ clock-names = "bus";
+ resets = <&ccu RST_BUS_MIPI_DSI>;
+ phys = <&dphy>;
+ phy-names = "dphy";
+ status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0>;
+
+ dsi_in_tcon0: endpoint {
+ remote-endpoint = <&tcon0_out_dsi>;
+ };
+ };
+ };
+ };
+
+ dphy: d-phy@1ca1000 {
+ compatible = "allwinner,sun6i-a31-mipi-dphy";
+ reg = <0x01ca1000 0x1000>;
+ clocks = <&ccu CLK_BUS_MIPI_DSI>,
+ <&ccu CLK_DSI_DPHY>;
+ clock-names = "bus", "mod";
+ resets = <&ccu RST_BUS_MIPI_DSI>;
+ status = "disabled";
+ #phy-cells = <0>;
+ };
+
pwm: pwm@1c21400 {
compatible = "allwinner,sun50i-a64-pwm",
"allwinner,sun5i-a13-pwm";
The A64 has a MIPI-DSI block which is similar to A31 without mod clock. So, add dsi node with A64 compatible, dphy node with A31 compatible and finally connect dsi to tcon0 to make proper DSI pipeline. Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> --- arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 44 +++++++++++++++++++ 1 file changed, 44 insertions(+)