@@ -241,6 +241,37 @@ static int d71_disable_irq(struct komeda_dev *mdev)
return 0;
}
+static int to_d71_opmode(int core_mode)
+{
+ switch (core_mode) {
+ case KOMEDA_MODE_DISP0:
+ return DO0_ACTIVE_MODE;
+ case KOMEDA_MODE_DISP1:
+ return DO1_ACTIVE_MODE;
+ case KOMEDA_MODE_DUAL_DISP:
+ return DO01_ACTIVE_MODE;
+ case KOMEDA_MODE_INACTIVE:
+ return INACTIVE_MODE;
+ default:
+ WARN(1, "Unknown operation mode");
+ return INACTIVE_MODE;
+ }
+}
+
+static int d71_change_opmode(struct komeda_dev *mdev, int new_mode)
+{
+ struct d71_dev *d71 = mdev->chip_data;
+ u32 opmode = to_d71_opmode(new_mode);
+ int ret;
+
+ malidp_write32_mask(d71->gcu_addr, BLK_CONTROL, 0x7, opmode);
+
+ ret = dp_wait_cond(((malidp_read32(d71->gcu_addr, BLK_CONTROL) & 0x7) == opmode),
+ 100, 1000, 10000);
+
+ return ret > 0 ? 0 : -ETIMEDOUT;
+}
+
static void d71_flush(struct komeda_dev *mdev,
int master_pipe, u32 active_pipes)
{
@@ -461,6 +492,7 @@ static struct komeda_dev_funcs d71_chip_funcs = {
.irq_handler = d71_irq_handler,
.enable_irq = d71_enable_irq,
.disable_irq = d71_disable_irq,
+ .change_opmode = d71_change_opmode,
.flush = d71_flush,
};
@@ -40,6 +40,110 @@ komeda_crtc_atomic_check(struct drm_crtc *crtc,
return 0;
}
+u32 komeda_calc_mclk(struct komeda_crtc_state *kcrtc_st)
+{
+ unsigned long mclk = kcrtc_st->base.adjusted_mode.clock * 1000;
+
+ return mclk;
+}
+
+/* For active a crtc, mainly need two parts of preparation
+ * 1. adjust display operation mode.
+ * 2. enable needed clk
+ */
+static int
+komeda_crtc_prepare(struct komeda_crtc *kcrtc)
+{
+ struct komeda_dev *mdev = kcrtc->base.dev->dev_private;
+ struct komeda_pipeline *master = kcrtc->master;
+ struct komeda_crtc_state *kcrtc_st = to_kcrtc_st(kcrtc->base.state);
+ unsigned long pxlclk_rate = kcrtc_st->base.adjusted_mode.clock * 1000;
+ u32 new_mode;
+ int err;
+
+ mutex_lock(&mdev->lock);
+
+ new_mode = mdev->dpmode | BIT(master->id);
+ if (WARN_ON(new_mode == mdev->dpmode)) {
+ err = 0;
+ goto unlock;
+ }
+
+ err = mdev->funcs->change_opmode(mdev, new_mode);
+ if (err) {
+ DRM_ERROR("failed to change opmode: 0x%x -> 0x%x.\n,",
+ mdev->dpmode, new_mode);
+ goto unlock;
+ }
+
+ mdev->dpmode = new_mode;
+ /* Only need to enable mclk on single display mode, but no need to
+ * enable mclk it on dual display mode, since the dual mode always
+ * switch from single display mode, the mclk already enabled, no need
+ * to enable it again.
+ */
+ if (new_mode != KOMEDA_MODE_DUAL_DISP) {
+ err = clk_set_rate(mdev->mclk, komeda_calc_mclk(kcrtc_st));
+ if (err)
+ DRM_ERROR("failed to set mclk.\n");
+ err = clk_prepare_enable(mdev->mclk);
+ if (err)
+ DRM_ERROR("failed to enable mclk.\n");
+ }
+
+ err = clk_prepare_enable(master->aclk);
+ if (err)
+ DRM_ERROR("failed to enable axi clk for pipe%d.\n", master->id);
+ err = clk_set_rate(master->pxlclk, pxlclk_rate);
+ if (err)
+ DRM_ERROR("failed to set pxlclk for pipe%d\n", master->id);
+ err = clk_prepare_enable(master->pxlclk);
+ if (err)
+ DRM_ERROR("failed to enable pxl clk for pipe%d.\n", master->id);
+
+unlock:
+ mutex_unlock(&mdev->lock);
+
+ return err;
+}
+
+static int
+komeda_crtc_unprepare(struct komeda_crtc *kcrtc)
+{
+ struct komeda_dev *mdev = kcrtc->base.dev->dev_private;
+ struct komeda_pipeline *master = kcrtc->master;
+ u32 new_mode;
+ int err;
+
+ mutex_lock(&mdev->lock);
+
+ new_mode = mdev->dpmode & (~BIT(master->id));
+
+ if (WARN_ON(new_mode == mdev->dpmode)) {
+ err = 0;
+ goto unlock;
+ }
+
+ err = mdev->funcs->change_opmode(mdev, new_mode);
+ if (err) {
+ DRM_ERROR("failed to change opmode: 0x%x -> 0x%x.\n,",
+ mdev->dpmode, new_mode);
+ goto unlock;
+ }
+
+ mdev->dpmode = new_mode;
+
+ clk_disable_unprepare(master->pxlclk);
+ clk_disable_unprepare(master->aclk);
+ if (new_mode == KOMEDA_MODE_INACTIVE)
+ clk_disable_unprepare(mdev->mclk);
+
+unlock:
+ mutex_unlock(&mdev->lock);
+
+ return err;
+}
+
void komeda_crtc_handle_event(struct komeda_crtc *kcrtc,
struct komeda_events *evts)
{
@@ -148,6 +148,8 @@ struct komeda_dev *komeda_dev_create(struct device *dev)
if (!mdev)
return ERR_PTR(-ENOMEM);
+ mutex_init(&mdev->lock);
+
mdev->dev = dev;
mdev->reg_base = devm_ioremap_resource(dev, io_res);
if (IS_ERR(mdev->reg_base)) {
@@ -106,11 +106,34 @@ struct komeda_dev_funcs {
/** @dump_register: Optional, dump registers to seq_file */
void (*dump_register)(struct komeda_dev *mdev, struct seq_file *seq);
+ /**
+ * @change_opmode:
+ *
+ * Notify HW to switch to a new display operation mode.
+ */
+ int (*change_opmode)(struct komeda_dev *mdev, int new_mode);
/** @flush: Notify the HW to flush or kickoff the update */
void (*flush)(struct komeda_dev *mdev,
int master_pipe, u32 active_pipes);
};
+/**
+ * DISPLAY_MODE describes how many display been enabled, and which will be
+ * passed to CHIP by &komeda_dev_funcs->change_opmode(), then CHIP can do the
+ * pipeline resources assignment according to this usage hint.
+ * - KOMEDA_MODE_DISP0: Only one display enabled, pipeline-0 work as master.
+ * - KOMEDA_MODE_DISP1: Only one display enabled, pipeline-0 work as master.
+ * - KOMEDA_MODE_DUAL_DISP: Dual display mode, both display has been enabled.
+ * And D71 supports assign two pipelines to one single display on mode
+ * KOMEDA_MODE_DISP0/DISP1
+ */
+enum {
+ KOMEDA_MODE_INACTIVE = 0,
+ KOMEDA_MODE_DISP0 = BIT(0),
+ KOMEDA_MODE_DISP1 = BIT(1),
+ KOMEDA_MODE_DUAL_DISP = KOMEDA_MODE_DISP0 | KOMEDA_MODE_DISP1,
+};
+
/**
* struct komeda_dev
*
@@ -133,6 +156,10 @@ struct komeda_dev {
/** @irq: irq number */
u32 irq;
+ /* TODO: manage the dpmode by a drm_private_obj */
+ struct mutex lock; /* use to protect dpmode */
+ u32 dpmode; /* current display mode */
+
int n_pipelines;
struct komeda_pipeline *pipelines[KOMEDA_MAX_PIPELINES];
These two function will be used by komeda_crtc_enable/disable to do some prepartion works when enable/disable a crtc. like enable a crtc: 1. Adjust display operation mode. 2. Enable/prepare needed clk. Signed-off-by: James (Qian) Wang <james.qian.wang@arm.com> --- .../gpu/drm/arm/display/komeda/d71/d71_dev.c | 32 ++++++ .../gpu/drm/arm/display/komeda/komeda_crtc.c | 104 ++++++++++++++++++ .../gpu/drm/arm/display/komeda/komeda_dev.c | 2 + .../gpu/drm/arm/display/komeda/komeda_dev.h | 27 +++++ 4 files changed, 165 insertions(+)