@@ -288,27 +288,6 @@ static int dsicm_power_on(struct panel_drv_data *ddata)
struct omap_dss_device *src = ddata->src;
u8 id1, id2, id3;
int r;
- struct omap_dss_dsi_config dsi_config = {
- .vm = &ddata->vm,
- .hs_clk_min = 150000000,
- .hs_clk_max = 300000000,
- .lp_clk_min = 7000000,
- .lp_clk_max = 10000000,
- };
-
- r = regulator_bulk_enable(DCS_REGULATOR_SUPPLY_NUM, ddata->supplies);
- if (r) {
- dev_err(&ddata->dsi->dev, "failed to enable supplies: %d\n", r);
- return r;
- }
-
- r = src->ops->dsi.set_config(src, &dsi_config);
- if (r) {
- dev_err(&ddata->dsi->dev, "failed to configure DSI\n");
- goto err_regulators;
- }
-
- src->ops->enable(src);
dsicm_hw_reset(ddata);
@@ -363,12 +342,6 @@ static int dsicm_power_on(struct panel_drv_data *ddata)
dsicm_hw_reset(ddata);
- src->ops->disable(src);
-err_regulators:
- r = regulator_bulk_disable(DCS_REGULATOR_SUPPLY_NUM, ddata->supplies);
- if (r)
- dev_err(&ddata->dsi->dev, "failed to disable supplies: %d\n", r);
-
return r;
}
@@ -377,6 +350,8 @@ static void dsicm_power_off(struct panel_drv_data *ddata)
struct omap_dss_device *src = ddata->src;
int r;
+ ddata->enabled = 0;
+
src->ops->dsi.disable_video_output(src, ddata->dsi->channel);
r = mipi_dsi_dcs_set_display_off(ddata->dsi);
@@ -388,14 +363,6 @@ static void dsicm_power_off(struct panel_drv_data *ddata)
"error disabling panel, issuing HW reset\n");
dsicm_hw_reset(ddata);
}
-
- src->ops->disable(src);
-
- r = regulator_bulk_disable(DCS_REGULATOR_SUPPLY_NUM, ddata->supplies);
- if (r)
- dev_err(&ddata->dsi->dev, "failed to disable supplies: %d\n", r);
-
- ddata->enabled = 0;
}
static int dsicm_connect(struct omap_dss_device *src,
@@ -415,6 +382,30 @@ static void dsicm_disconnect(struct omap_dss_device *src,
ddata->src = NULL;
}
+static void dsicm_pre_enable(struct omap_dss_device *dssdev)
+{
+ struct panel_drv_data *ddata = to_panel_data(dssdev);
+ struct omap_dss_device *src = ddata->src;
+ int r;
+ struct omap_dss_dsi_config dsi_config = {
+ .vm = &ddata->vm,
+ .hs_clk_min = 150000000,
+ .hs_clk_max = 300000000,
+ .lp_clk_min = 7000000,
+ .lp_clk_max = 10000000,
+ };
+
+ r = regulator_bulk_enable(DCS_REGULATOR_SUPPLY_NUM, ddata->supplies);
+ if (r) {
+ dev_err(&ddata->dsi->dev, "failed to enable supplies: %d\n", r);
+ }
+
+ r = src->ops->dsi.set_config(src, &dsi_config);
+ if (r) {
+ dev_err(&ddata->dsi->dev, "failed to configure DSI\n");
+ }
+}
+
static void dsicm_enable(struct omap_dss_device *dssdev)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
@@ -449,6 +440,16 @@ static void dsicm_disable(struct omap_dss_device *dssdev)
mutex_unlock(&ddata->lock);
}
+static void dsicm_post_disable(struct omap_dss_device *dssdev)
+{
+ struct panel_drv_data *ddata = to_panel_data(dssdev);
+ int r;
+
+ r = regulator_bulk_disable(DCS_REGULATOR_SUPPLY_NUM, ddata->supplies);
+ if (r)
+ dev_err(&ddata->dsi->dev, "failed to disable supplies: %d\n", r);
+}
+
static int _dsicm_enable_te(struct panel_drv_data *ddata, bool enable)
{
struct mipi_dsi_device *dsi = ddata->dsi;
@@ -502,8 +503,10 @@ static const struct omap_dss_device_ops dsicm_ops = {
.connect = dsicm_connect,
.disconnect = dsicm_disconnect,
+ .pre_enable = dsicm_pre_enable,
.enable = dsicm_enable,
.disable = dsicm_disable,
+ .post_disable = dsicm_post_disable,
.get_modes = dsicm_get_modes,
.check_timings = dsicm_check_timings,
@@ -666,8 +669,6 @@ static int __exit dsicm_remove(struct mipi_dsi_device *dsi)
omapdss_device_unregister(dssdev);
- if (omapdss_device_is_enabled(dssdev))
- dsicm_disable(dssdev);
omapdss_device_disconnect(ddata->src, dssdev);
sysfs_remove_group(&dsi->dev.kobj, &dsicm_attr_group);
@@ -171,14 +171,10 @@ static void omap_encoder_disable(struct drm_encoder *encoder)
omapdss_device_disable(dssdev->next);
/*
- * Disable the internal encoder. This will disable the DSS output. The
- * DSI is treated as an exception as DSI pipelines still use the legacy
- * flow where the pipeline output controls the encoder.
+ * Disable the internal encoder. This will disable the DSS output.
*/
- if (dssdev->type != OMAP_DISPLAY_TYPE_DSI) {
- dssdev->ops->disable(dssdev);
- dssdev->state = OMAP_DSS_DISPLAY_DISABLED;
- }
+ dssdev->ops->disable(dssdev);
+ dssdev->state = OMAP_DSS_DISPLAY_DISABLED;
/*
* Perform the post-disable operations on the chain of external devices
@@ -199,14 +195,10 @@ static void omap_encoder_enable(struct drm_encoder *encoder)
omapdss_device_pre_enable(dssdev->next);
/*
- * Enable the internal encoder. This will enable the DSS output. The
- * DSI is treated as an exception as DSI pipelines still use the legacy
- * flow where the pipeline output controls the encoder.
+ * Enable the internal encoder. This will enable the DSS output.
*/
- if (dssdev->type != OMAP_DISPLAY_TYPE_DSI) {
- dssdev->ops->enable(dssdev);
- dssdev->state = OMAP_DSS_DISPLAY_ACTIVE;
- }
+ dssdev->ops->enable(dssdev);
+ dssdev->state = OMAP_DSS_DISPLAY_ACTIVE;
/*
* Enable the chain of external devices, starting at the one at the
Complete the direction reversal of the DSS device enable/disable operations started by 19b4200d8f4b ("drm/omap: Reverse direction of the DSS device enable/disable operations"). This effectively drops the requirement of calling DSS specific code from the DSI panel driver moving it a bit further to a standard drm_panel driver. Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com> --- .../gpu/drm/omapdrm/displays/panel-dsi-cm.c | 75 ++++++++++--------- drivers/gpu/drm/omapdrm/omap_encoder.c | 20 ++--- 2 files changed, 44 insertions(+), 51 deletions(-)