@@ -761,7 +761,7 @@ static void cdns_dsi_bridge_enable(struct drm_bridge *bridge)
struct phy_configure_opts_mipi_dphy *phy_cfg = &output->phy_opts.mipi_dphy;
unsigned long tx_byte_period;
struct cdns_dsi_cfg dsi_cfg;
- u32 tmp, reg_wakeup, div;
+ u32 tmp, reg_wakeup, div, status;
int nlanes;
if (WARN_ON(pm_runtime_get_sync(dsi->base.dev) < 0))
@@ -778,6 +778,17 @@ static void cdns_dsi_bridge_enable(struct drm_bridge *bridge)
cdns_dsi_init_link(dsi);
cdns_dsi_hs_init(dsi);
+ /*
+ * Now that the DSI Link and DSI Phy are initialized,
+ * wait for the CLK and Data Lanes to be ready.
+ */
+ tmp = CLK_LANE_RDY;
+ for (int i = 0; i < nlanes; i++)
+ tmp |= DATA_LANE_RDY(i);
+
+ WARN_ON_ONCE(readl_poll_timeout(dsi->regs + MCTL_MAIN_STS, status,
+ status & tmp, 100, 0));
+
writel(HBP_LEN(dsi_cfg.hbp) | HSA_LEN(dsi_cfg.hsa),
dsi->regs + VID_HSIZE1);
writel(HFP_LEN(dsi_cfg.hfp) | HACT_LEN(dsi_cfg.hact),
Once the DSI Link and DSI Phy are initialized, the code needs to wait for Clk and Data Lanes to be ready, before continuing configuration. This is in accordance with the DSI Start-up procedure, found in the Technical Reference Manual of Texas Instrument's J721E SoC[0] which houses this DSI TX controller. If the previous bridge (or crtc/encoder) are configured pre-maturely, the input signal FIFO gets corrupt. This introduces a color-shift on the display. Allow the driver to wait for the clk and data lanes to get ready during DSI enable. [0]: See section 12.6.5.7.3 "Start-up Procedure" in J721E SoC TRM TRM Link: http://www.ti.com/lit/pdf/spruil1 Fixes: e19233955d9e ("drm/bridge: Add Cadence DSI driver") Tested-by: Dominik Haller <d.haller@phytec.de> Signed-off-by: Aradhya Bhatia <a-bhatia1@ti.com> --- drivers/gpu/drm/bridge/cadence/cdns-dsi-core.c | 13 ++++++++++++- 1 file changed, 12 insertions(+), 1 deletion(-)