@@ -113,6 +113,13 @@ static void set_scanout(struct drm_crtc *crtc, struct drm_framebuffer *fb)
tilcdc_crtc->curr_fb = fb;
}
+void tilcdc_crtc_reload_palette(struct drm_crtc *crtc)
+{
+ struct tilcdc_crtc *tilcdc_crtc = to_tilcdc_crtc(crtc);
+
+ reinit_completion(&tilcdc_crtc->palette_loaded);
+}
+
static void reset(struct drm_crtc *crtc);
/*
* The driver currently only supports only true color formats. For
@@ -122,15 +129,13 @@ static void set_scanout(struct drm_crtc *crtc, struct drm_framebuffer *fb)
*/
static void tilcdc_crtc_load_palette(struct drm_crtc *crtc)
{
- u32 dma_fb_base, dma_fb_ceiling, raster_ctl;
struct tilcdc_crtc *tilcdc_crtc = to_tilcdc_crtc(crtc);
struct drm_device *dev = crtc->dev;
struct tilcdc_drm_private *priv = dev->dev_private;
int ret;
- dma_fb_base = tilcdc_read(dev, LCDC_DMA_FB_BASE_ADDR_0_REG);
- dma_fb_ceiling = tilcdc_read(dev, LCDC_DMA_FB_CEILING_ADDR_0_REG);
- raster_ctl = tilcdc_read(dev, LCDC_RASTER_CTRL_REG);
+ if (completion_done(&tilcdc_crtc->palette_loaded))
+ return;
/* SW reset before turning DMA on (see section 13.3.8 in AM335x TRM)*/
reset(crtc);
@@ -168,11 +173,6 @@ static void tilcdc_crtc_load_palette(struct drm_crtc *crtc)
tilcdc_clear(dev, LCDC_RASTER_CTRL_REG, LCDC_V1_PL_INT_ENA);
else
tilcdc_write(dev, LCDC_INT_ENABLE_CLR_REG, LCDC_V2_PL_INT_ENA);
-
- /* Restore the registers. */
- tilcdc_write(dev, LCDC_DMA_FB_BASE_ADDR_0_REG, dma_fb_base);
- tilcdc_write(dev, LCDC_DMA_FB_CEILING_ADDR_0_REG, dma_fb_ceiling);
- tilcdc_write(dev, LCDC_RASTER_CTRL_REG, raster_ctl);
}
static void tilcdc_crtc_enable_irqs(struct drm_device *dev)
@@ -242,9 +242,6 @@ static void tilcdc_crtc_enable(struct drm_crtc *crtc)
reset(crtc);
- if (!completion_done(&tilcdc_crtc->palette_loaded))
- tilcdc_crtc_load_palette(crtc);
-
tilcdc_crtc_enable_irqs(dev);
tilcdc_clear(dev, LCDC_DMA_CTRL_REG, LCDC_DUAL_FRAME_BUFFER_ENABLE);
@@ -288,12 +285,6 @@ static void tilcdc_crtc_off(struct drm_crtc *crtc, bool shutdown)
__func__);
}
- /*
- * LCDC will not retain the palette when reset. Make sure it gets
- * reloaded on tilcdc_crtc_enable().
- */
- reinit_completion(&tilcdc_crtc->palette_loaded);
-
drm_crtc_vblank_off(crtc);
tilcdc_crtc_disable_irqs(dev);
@@ -681,10 +672,12 @@ static void tilcdc_crtc_mode_set_nofb(struct drm_crtc *crtc)
drm_framebuffer_reference(fb);
- set_scanout(crtc, fb);
-
tilcdc_crtc_set_clk(crtc);
+ tilcdc_crtc_load_palette(crtc);
+
+ set_scanout(crtc, fb);
+
crtc->hwmode = crtc->state->adjusted_mode;
}
@@ -637,8 +637,20 @@ static int tilcdc_pm_resume(struct device *dev)
}
#endif
+static int tilcdc_pm_runtime_resume(struct device *dev)
+{
+ struct drm_device *ddev = dev_get_drvdata(dev);
+ struct tilcdc_drm_private *priv = ddev->dev_private;
+
+ if (priv->crtc)
+ tilcdc_crtc_reload_palette(priv->crtc);
+
+ return 0;
+}
+
static const struct dev_pm_ops tilcdc_pm_ops = {
SET_SYSTEM_SLEEP_PM_OPS(tilcdc_pm_suspend, tilcdc_pm_resume)
+ .runtime_resume = tilcdc_pm_runtime_resume,
};
/*
@@ -180,6 +180,7 @@ void tilcdc_crtc_set_simulate_vesa_sync(struct drm_crtc *crtc,
int tilcdc_crtc_update_fb(struct drm_crtc *crtc,
struct drm_framebuffer *fb,
struct drm_pending_vblank_event *event);
+void tilcdc_crtc_reload_palette(struct drm_crtc *crtc);
int tilcdc_plane_init(struct drm_device *dev, struct drm_plane *plane);
Load palette at the end of mode_set_nofb() and only if the palette has not been loaded since last runtime resume. Moving the palette loading to mode_set_nofb() saves us from storing and restoring of LCDC dma addresses that were just recently updated. Signed-off-by: Jyri Sarha <jsarha@ti.com> --- drivers/gpu/drm/tilcdc/tilcdc_crtc.c | 33 +++++++++++++-------------------- drivers/gpu/drm/tilcdc/tilcdc_drv.c | 12 ++++++++++++ drivers/gpu/drm/tilcdc/tilcdc_drv.h | 1 + 3 files changed, 26 insertions(+), 20 deletions(-)