@@ -186,12 +186,8 @@ static int bcm2835_thermal_probe(struct platform_device *pdev)
}
data->clk = devm_clk_get_enabled(dev, NULL);
- if (IS_ERR(data->clk)) {
- err = PTR_ERR(data->clk);
- if (err != -EPROBE_DEFER)
- dev_err(dev, "Could not get clk: %d\n", err);
- return err;
- }
+ if (IS_ERR(data->clk))
+ return dev_err_probe(dev, PTR_ERR(data->clk), "Could not get clk\n");
rate = clk_get_rate(data->clk);
if ((rate < 1920000) || (rate > 5000000))
@@ -201,11 +197,8 @@ static int bcm2835_thermal_probe(struct platform_device *pdev)
/* register of thermal sensor and get info from DT */
tz = devm_thermal_of_zone_register(dev, 0, data, &bcm2835_thermal_ops);
- if (IS_ERR(tz)) {
- err = PTR_ERR(tz);
- dev_err(dev, "Failed to register the thermal device: %d\n", err);
- return err;
- }
+ if (IS_ERR(tz))
+ return dev_err_probe(dev, PTR_ERR(tz), "Failed to register the thermal device\n");
/*
* right now the FW does set up the HW-block, so we are not
Error handling in probe() can be a bit simpler with dev_err_probe(). Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- drivers/thermal/broadcom/bcm2835_thermal.c | 15 ++++----------- 1 file changed, 4 insertions(+), 11 deletions(-)