[0/2] drm/i915/display: Allow display PHYs to reset power state

Message

Kahola, Mika Jan. 29, 2025, 1:01 p.m. UTC

The dedicated display PHYs reset to a power state that blocks S0ix,
increasing idle system power. After a system reset (cold boot,
S3/4/5, warm reset) if a dedicated PHY is not being brought up
shortly, use these steps to move the PHY to the lowest power state
to save power.

1. Follow the PLL Enable Sequence, using any valid frequency such as DP 1.62 GHz.
   This brings lanes out of reset and enables the PLL to allow powerdown to be moved
   to the Disable state.
2. Follow PLL Disable Sequence. This moves powerdown to the Disable state and disables the PLL.

Before doing this, let's refactor the pll enabling in such a way that
the crtc_state structure is no longer needed.

Mika Kahola (2):
  drm/i915/display: Drop crtc_state from C10/C20 pll programming
  drm/i915/display: Allow display PHYs to reset power state

 drivers/gpu/drm/i915/display/intel_cx0_phy.c  | 144 ++++++++++++------
 drivers/gpu/drm/i915/display/intel_cx0_phy.h  |   1 +
 .../drm/i915/display/intel_display_reset.c    |   2 +
 drivers/gpu/drm/i915/display/intel_dpll_mgr.c |   2 +
 4 files changed, 104 insertions(+), 45 deletions(-)