@@ -5818,12 +5818,39 @@ retry:
return ret;
}
+static bool pipe_config_supports_ips(struct drm_i915_private *dev_priv,
+ struct intel_crtc_state *pipe_config)
+{
+ if (pipe_config->pipe_bpp > 24)
+ return false;
+
+ /* HSW can handle pixel rate up to cdclk? */
+ if (IS_HASWELL(dev_priv->dev))
+ return true;
+
+ /*
+ * FIXME if we compare against max we should then
+ * increase the cdclk frequency when the current
+ * value is too low. The other option is to compare
+ * against the cdclk frequency we're going have post
+ * modeset (ie. one we computed using other constraints).
+ * Need to measure whether using a lower cdclk w/o IPS
+ * is better or worse than a higher cdclk w/ IPS.
+ */
+ return ilk_pipe_pixel_rate(pipe_config) <=
+ dev_priv->max_cdclk_freq * 95 / 100;
+}
+
static void hsw_compute_ips_config(struct intel_crtc *crtc,
struct intel_crtc_state *pipe_config)
{
+ struct drm_device *dev = crtc->base.dev;
+ struct drm_i915_private *dev_priv = dev->dev_private;
+
pipe_config->ips_enabled = i915.enable_ips &&
- hsw_crtc_supports_ips(crtc) &&
- pipe_config->pipe_bpp <= 24;
+ hsw_crtc_supports_ips(crtc) &&
+ pipe_config_supports_ips(dev_priv, pipe_config);
+
}
static int intel_crtc_compute_config(struct intel_crtc *crtc,
@@ -1270,6 +1270,7 @@ void ilk_wm_get_hw_state(struct drm_device *dev);
void skl_wm_get_hw_state(struct drm_device *dev);
void skl_ddb_get_hw_state(struct drm_i915_private *dev_priv,
struct skl_ddb_allocation *ddb /* out */);
+uint32_t ilk_pipe_pixel_rate(const struct intel_crtc_state *pipe_config);
/* intel_sdvo.c */
@@ -1411,23 +1411,22 @@ static void i845_update_wm(struct drm_crtc *unused_crtc)
I915_WRITE(FW_BLC, fwater_lo);
}
-static uint32_t ilk_pipe_pixel_rate(struct drm_device *dev,
- struct drm_crtc *crtc)
+uint32_t ilk_pipe_pixel_rate(const struct intel_crtc_state *pipe_config)
{
- struct intel_crtc *intel_crtc = to_intel_crtc(crtc);
uint32_t pixel_rate;
- pixel_rate = intel_crtc->config->base.adjusted_mode.crtc_clock;
+ pixel_rate = pipe_config->base.adjusted_mode.crtc_clock;
/* We only use IF-ID interlacing. If we ever use PF-ID we'll need to
* adjust the pixel_rate here. */
- if (intel_crtc->config->pch_pfit.enabled) {
+ if (pipe_config->pch_pfit.enabled) {
uint64_t pipe_w, pipe_h, pfit_w, pfit_h;
- uint32_t pfit_size = intel_crtc->config->pch_pfit.size;
+ uint32_t pfit_size = pipe_config->pch_pfit.size;
+
+ pipe_w = pipe_config->pipe_src_w;
+ pipe_h = pipe_config->pipe_src_h;
- pipe_w = intel_crtc->config->pipe_src_w;
- pipe_h = intel_crtc->config->pipe_src_h;
pfit_w = (pfit_size >> 16) & 0xFFFF;
pfit_h = pfit_size & 0xFFFF;
if (pipe_w < pfit_w)
@@ -2043,7 +2042,7 @@ static void ilk_compute_wm_parameters(struct drm_crtc *crtc,
p->active = true;
p->pipe_htotal = intel_crtc->config->base.adjusted_mode.crtc_htotal;
- p->pixel_rate = ilk_pipe_pixel_rate(dev, crtc);
+ p->pixel_rate = ilk_pipe_pixel_rate(intel_crtc->config);
if (crtc->primary->state->fb) {
p->pri.enabled = true;