@@ -86,6 +86,7 @@ implementation.
:maxdepth: 2
sh/index
+ x86/index
Korean translations
-------------------
new file mode 100644
@@ -0,0 +1,168 @@
+===================
+Intel(R) SGX driver
+===================
+
+Introduction
+============
+
+Intel(R) SGX is a set of CPU instructions that can be used by applications to
+set aside private regions of code and data. The code outside the enclave is
+disallowed to access the memory inside the enclave by the CPU access control.
+In a way you can think that SGX provides inverted sandbox. It protects the
+application from a malicious host.
+
+You can tell if your CPU supports SGX by looking into ``/proc/cpuinfo``:
+
+ ``cat /proc/cpuinfo | grep sgx``
+
+Overview of SGX
+===============
+
+SGX has a set of data structures to maintain information about the enclaves and
+their security properties. BIOS reserves a fixed size region of physical memory
+for these structures by setting Processor Reserved Memory Range Registers
+(PRMRR).
+
+This memory range is protected from outside access by the CPU and all the data
+coming in and out of the CPU package is encrypted by a key that is generated for
+each boot cycle.
+
+Enclaves execute in ring-3 in a special enclave submode using pages from the
+reserved memory range. A fixed logical address range for the enclave is reserved
+by ENCLS(ECREATE), a leaf instruction used to create enclaves. It is referred in
+the documentation commonly as the ELRANGE.
+
+Every memory access to the ELRANGE is asserted by the CPU. If the CPU is not
+executing in the enclave mode inside the enclave, #GP is raised. On the other
+hand enclave code can make memory accesses both inside and outside of the
+ELRANGE.
+
+Enclave can only execute code inside the ELRANGE. Instructions that may cause
+VMEXIT, IO instructions and instructions that require a privilege change are
+prohibited inside the enclave. Interrupts and exceptions always cause enclave
+to exit and jump to an address outside the enclave given when the enclave is
+entered by using the leaf instruction ENCLS(EENTER).
+
+Data types
+----------
+
+The protected memory range contains the following data:
+
+* **Enclave Page Cache (EPC):** protected pages
+* **Enclave Page Cache Map (EPCM):** a database that describes the state of the
+ pages and link them to an enclave.
+
+EPC has a number of different types of pages:
+
+* **SGX Enclave Control Structure (SECS)**: describes the global
+ properties of an enclave.
+* **Regular (REG):** code and data pages in the ELRANGE.
+* **Thread Control Structure (TCS):** pages that define entry points inside an
+ enclave. The enclave can only be entered through these entry points and each
+ can host a single hardware thread at a time.
+* **Version Array (VA)**: 64-bit version numbers for pages that have been
+ swapped outside the enclave. Each page contains 512 version numbers.
+
+Launch control
+--------------
+
+To launch an enclave, two structures must be provided for ENCLS(EINIT):
+
+1. **SIGSTRUCT:** signed measurement of the enclave binary.
+2. **EINITTOKEN:** a cryptographic token CMAC-signed with a AES256-key called
+ *launch key*, which is re-generated for each boot cycle.
+
+The CPU holds a SHA256 hash of a 3072-bit RSA public key inside
+IA32_SGXLEPUBKEYHASHn MSRs. Enclaves with a SIGSTRUCT that is signed with this
+key do not require a valid EINITTOKEN and can be authorized with special
+privileges. One of those privileges is ability to acquire the launch key with
+ENCLS(EGETKEY).
+
+**IA32_FEATURE_CONTROL[17]** is used by to BIOS configure whether
+IA32_SGXLEPUBKEYHASH MSRs are read-only or read-write before locking the
+feature control register and handing over control to the operating system.
+
+Enclave construction
+--------------------
+
+The construction is started by filling out the SECS that contains enclave
+address range, privileged attributes and measurement of TCS and REG pages (pages
+that will be mapped to the address range) among the other things. This structure
+is passed out to the ENCLS(ECREATE) together with a physical address of a page
+in EPC that will hold the SECS.
+
+Then pages are added with ENCLS(EADD) and measured with ENCLS(EEXTEND). Finally
+enclave is initialized with ENCLS(EINIT). ENCLS(INIT) checks that the SIGSTRUCT
+is signed with the contained public key and that the supplied EINITTOKEN is
+valid (CMAC'd with the launch key). If these hold, the enclave is successfully
+initialized.
+
+Swapping pages
+--------------
+
+Enclave pages can be swapped out with ENCLS(EWB) to the unprotected memory. In
+addition to the EPC page, ENCLS(EWB) takes in a VA page and address for PCMD
+structure (Page Crypto MetaData) as input. The VA page will seal a version
+number for the page. PCMD is 128 byte structure that contains tracking
+information for the page, most importantly its MAC. With these structures the
+enclave is sealed and rollback protected while it resides in the unprotected
+memory.
+
+Before the page can be swapped out it must not have any active TLB references.
+By using ENCLS(EBLOCK) instructions no new TLB entries can be created to it.
+After this the a counter called *epoch* associated hardware threads inside the
+enclave is increased with ENCLS(ETRACK). After all the threads from the previous
+epoch have exited the page can be safely swapped out.
+
+An enclave memory access to a swapped out pages will cause #PF. #PF handler can
+fault the page back by using ENCLS(ELDU).
+
+Driver internals
+================
+
+Launching enclaves
+------------------
+
+For privileged enclaves the launch is performed simply by submitting the
+SIGSTRUCT for that enclave to ENCLS(EINIT). For unprivileged enclaves the
+driver hosts a process in ring-3 that hosts a launch enclave signed with a key
+supplied for kbuild.
+
+The current implementation of the launch enclave generates a token for any
+enclave. In the future it could be potentially extended to have ways to
+configure policy what can be lauched.
+
+The driver will fail to initialize if it cannot start its own launch enclave.
+A user space application can submit a SIGSTRUCT instance through the ioctl API.
+The kernel will take care of the rest.
+
+This design assures that the Linux kernel has always full control, which
+enclaves get to launch and which do not, even if the public key MSRs are
+read-only. Having launch intrinsics inside the kernel also enables easy
+development of enclaves without necessarily needing any heavy weight SDK.
+Having a low-barrier to implement enclaves could make sense for example for
+system daemons where amount of dependecies ought to be minimized.
+
+Swapper
+-------
+
+The driver has a trivial implementation of swapping code in sgx_page_cache.c,
+which swaps pages from processes and enclaves in a round-robin fashion. In
+future it would probably make sense to find a way to let the Linux swapper to
+pick the victim pages but it is not currently doable because EPC pages do not
+have associated page structures.
+
+SGX uapi
+========
+
+.. kernel-doc:: drivers/platform/x86/intel_sgx/sgx_ioctl.c
+ :functions: sgx_ioc_enclave_create
+ sgx_ioc_enclave_add_page
+ sgx_ioc_enclave_init
+
+.. kernel-doc:: arch/x86/include/uapi/asm/sgx.h
+
+References
+==========
+
+* System Programming Manual: 39.1.4 Intel® SGX Launch Control Configuration