@@ -879,7 +879,7 @@ static struct dev_pm_domain acpi_lpss_pm_domain = {
#ifdef CONFIG_PM
#ifdef CONFIG_PM_SLEEP
.prepare = acpi_subsys_prepare,
- .complete = pm_complete_with_resume_check,
+ .complete = acpi_subsys_complete,
.suspend = acpi_subsys_suspend,
.suspend_late = acpi_lpss_suspend_late,
.resume_early = acpi_lpss_resume_early,
@@ -964,6 +964,23 @@ int acpi_subsys_prepare(struct device *dev)
EXPORT_SYMBOL_GPL(acpi_subsys_prepare);
/**
+ * acpi_subsys_complete - Finalize device's resume during system resume.
+ * @dev: Device to handle.
+ */
+void acpi_subsys_complete(struct device *dev)
+{
+ pm_generic_complete(dev);
+ /*
+ * If the device had been runtime-suspended before the system went into
+ * the sleep state it is going out of and it has never been resumed till
+ * now, resume it in case the firmware powered it up.
+ */
+ if (dev->power.direct_complete && pm_resume_via_firmware())
+ pm_request_resume(dev);
+}
+EXPORT_SYMBOL_GPL(acpi_subsys_complete);
+
+/**
* acpi_subsys_suspend - Run the device driver's suspend callback.
* @dev: Device to handle.
*
@@ -1031,7 +1048,7 @@ static struct dev_pm_domain acpi_general_pm_domain = {
.runtime_resume = acpi_subsys_runtime_resume,
#ifdef CONFIG_PM_SLEEP
.prepare = acpi_subsys_prepare,
- .complete = pm_complete_with_resume_check,
+ .complete = acpi_subsys_complete,
.suspend = acpi_subsys_suspend,
.suspend_late = acpi_subsys_suspend_late,
.resume_early = acpi_subsys_resume_early,
The commit 58a1fbbb2ee8 ("PM / PCI / ACPI: Kick devices that might have been reset by firmware"), made PCI's and ACPI's ->complete() callbacks to be assigned to a new API called pm_complete_with_resume_check(), which was introduced in the same change. Later it turned out that using pm_complete_with_resume_check() isn't good enough for PCI, as it needs additional PCI specific checks, before deciding whether runtime resuming the device is needed when running the ->complete() callback. This leaves ACPI being the only user of pm_complete_with_resume_check(). Therefore let's restore ACPI's acpi_subsys_complete(), which was dropped in commit 58a1fbbb2ee8 ("PM / PCI / ACPI: Kick devices that might have been reset by firmware"). This enables us to remove the pm_complete_with_resume_check() API in a following change, but it also enables ACPI to add more ACPI specific checks in acpi_subsys_complete() if it turns out that is needed. Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org> --- drivers/acpi/acpi_lpss.c | 2 +- drivers/acpi/device_pm.c | 19 ++++++++++++++++++- 2 files changed, 19 insertions(+), 2 deletions(-)