| Message ID | 20181207105231.25593-2-ccaione@baylibre.com (mailing list archive) |
|---|---|
| State | Accepted |
| Headers | show |
| Series | meson: Fix IRQ trigger type | expand |
Carlo Caione <ccaione@baylibre.com> writes: > A long running stress test on a custom board shipping an AXG SoCs and a > Realtek RTL8211F PHY revealed that after a few hours the connection > speed would drop drastically, from ~1000Mbps to ~3Mbps. At the same time > the 'macirq' (eth0) IRQ would stop being triggered at all and as > consequence the GMAC IRQs never ACKed. > > After a painful investigation the problem seemed to be due to a wrong > defined IRQ type for the GMAC IRQ that should be LEVEL_HIGH instead of > EDGE_RISING. > > The change in the macirq IRQ type also solved another long standing > issue affecting this SoC/PHY where EEE was causing the network > connection to die after stressing it with iperf3 (even though much > sooner). It's now possible to remove the 'eee-broken-1000t' quirk as > well. > > Fixes: feb3cbea0946 ("ARM64: dts: meson-gxbb-odroidc2: fix GbE tx link breakage") > Fixes: 6d28d577510f ("ARM64: dts: meson-axg: fix ethernet stability issue") > Reviewed-by: Jerome Brunet <jbrunet@baylibre.com> > Tested-by: Jerome Brunet <jbrunet@baylibre.com> > Acked-by: Neil Armstrong <narmstrong@baylibre.com> > Signed-off-by: Carlo Caione <ccaione@baylibre.com> Queuing this one for v4.21 (dt64 branch) I'm going to wait for the dust to settle on 'PATCH v2 2/2' for the 32-bit SoCs (and will rely on Martin's recommendation for the final decision there.) Kevin
diff --git a/arch/arm64/boot/dts/amlogic/meson-axg-s400.dts b/arch/arm64/boot/dts/amlogic/meson-axg-s400.dts index 18778ada7bd3..4d57363ac536 100644 --- a/arch/arm64/boot/dts/amlogic/meson-axg-s400.dts +++ b/arch/arm64/boot/dts/amlogic/meson-axg-s400.dts @@ -357,7 +357,6 @@ eth_phy0: ethernet-phy@0 { /* Realtek RTL8211F (0x001cc916) */ reg = <0>; - eee-broken-1000t; }; }; }; diff --git a/arch/arm64/boot/dts/amlogic/meson-axg.dtsi b/arch/arm64/boot/dts/amlogic/meson-axg.dtsi index df017dbd2e57..b1a42e99cb67 100644 --- a/arch/arm64/boot/dts/amlogic/meson-axg.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-axg.dtsi @@ -143,7 +143,7 @@ compatible = "amlogic,meson-axg-dwmac", "snps,dwmac"; reg = <0x0 0xff3f0000 0x0 0x10000 0x0 0xff634540 0x0 0x8>; - interrupts = <GIC_SPI 8 IRQ_TYPE_EDGE_RISING>; + interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>; interrupt-names = "macirq"; clocks = <&clkc CLKID_ETH>, <&clkc CLKID_FCLK_DIV2>, diff --git a/arch/arm64/boot/dts/amlogic/meson-gx.dtsi b/arch/arm64/boot/dts/amlogic/meson-gx.dtsi index f1e5cdbade5e..58e6bcaac1d8 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gx.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-gx.dtsi @@ -462,7 +462,7 @@ compatible = "amlogic,meson-gx-dwmac", "amlogic,meson-gxbb-dwmac", "snps,dwmac"; reg = <0x0 0xc9410000 0x0 0x10000 0x0 0xc8834540 0x0 0x4>; - interrupts = <GIC_SPI 8 IRQ_TYPE_EDGE_RISING>; + interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>; interrupt-names = "macirq"; status = "disabled"; }; diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts index 54954b314a45..f8d1cedbe600 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts @@ -143,7 +143,6 @@ interrupt-parent = <&gpio_intc>; /* MAC_INTR on GPIOZ_15 */ interrupts = <29 IRQ_TYPE_LEVEL_LOW>; - eee-broken-1000t; }; }; }; diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek.dtsi index 70325b273bd2..ec09bb5792b7 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek.dtsi @@ -142,7 +142,6 @@ eth_phy0: ethernet-phy@0 { /* Realtek RTL8211F (0x001cc916) */ reg = <0>; - eee-broken-1000t; }; }; };
A long running stress test on a custom board shipping an AXG SoCs and a Realtek RTL8211F PHY revealed that after a few hours the connection speed would drop drastically, from ~1000Mbps to ~3Mbps. At the same time the 'macirq' (eth0) IRQ would stop being triggered at all and as consequence the GMAC IRQs never ACKed. After a painful investigation the problem seemed to be due to a wrong defined IRQ type for the GMAC IRQ that should be LEVEL_HIGH instead of EDGE_RISING. The change in the macirq IRQ type also solved another long standing issue affecting this SoC/PHY where EEE was causing the network connection to die after stressing it with iperf3 (even though much sooner). It's now possible to remove the 'eee-broken-1000t' quirk as well. Fixes: feb3cbea0946 ("ARM64: dts: meson-gxbb-odroidc2: fix GbE tx link breakage") Fixes: 6d28d577510f ("ARM64: dts: meson-axg: fix ethernet stability issue") Reviewed-by: Jerome Brunet <jbrunet@baylibre.com> Tested-by: Jerome Brunet <jbrunet@baylibre.com> Acked-by: Neil Armstrong <narmstrong@baylibre.com> Signed-off-by: Carlo Caione <ccaione@baylibre.com> --- arch/arm64/boot/dts/amlogic/meson-axg-s400.dts | 1 - arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 2 +- arch/arm64/boot/dts/amlogic/meson-gx.dtsi | 2 +- arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts | 1 - arch/arm64/boot/dts/amlogic/meson-gxbb-wetek.dtsi | 1 - 5 files changed, 2 insertions(+), 5 deletions(-)