diff mbox series

[v1,09/11] arm64: dts: meson-sm1-odroid-c4: Used onboard usb hub reset on odroid c4

Message ID 20221228100321.15949-10-linux.amoon@gmail.com (mailing list archive)
State Superseded
Headers show
Series Used onboard HUB to reset and add power to hub | expand

Commit Message

Anand Moon Dec. 28, 2022, 10:03 a.m. UTC 
On Odroid c4 previously use gpio-hog to reset the usb hub,
switch to used on-board usb hub reset to enable the usb hub
and enable power to hub.

Signed-off-by: Anand Moon <linux.amoon@gmail.com>
---
 .../boot/dts/amlogic/meson-sm1-odroid-c4.dts  | 25 +++++++++----------
 1 file changed, 12 insertions(+), 13 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
index 8c30ce63686e..9b8230d6a9da 100644
--- a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
@@ -26,20 +26,19 @@  led-blue {
 	sound {
 		model = "ODROID-C4";
 	};
-};
 
-&gpio {
-	/*
-	 * WARNING: The USB Hub on the Odroid-C4 needs a reset signal
-	 * to be turned high in order to be detected by the USB Controller
-	 * This signal should be handled by a USB specific power sequence
-	 * in order to reset the Hub when USB bus is powered down.
-	 */
-	hog-0 {
-		gpio-hog;
-		gpios = <GPIOH_4 GPIO_ACTIVE_HIGH>;
-		output-high;
-		line-name = "usb-hub-reset";
+	usb {
+		dr_mode = "host";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		hub: hub@1 {
+			/* Via lab VL817-Q7 usb hub */
+			compatible = "vialab,usb2109";
+			reg = <1>;
+			vdd-supply = <&usb_pwr_en>;
+			reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
+		};
 	};
 };