@@ -41,14 +41,17 @@
#define CLK_V2_TX_DELAY_MASK GENMASK(19, 16)
#define CLK_V2_RX_DELAY_MASK GENMASK(23, 20)
#define CLK_V2_ALWAYS_ON BIT(24)
+#define CLK_V2_IRQ_SDIO_SLEEP BIT(25)
#define CLK_V3_TX_DELAY_MASK GENMASK(21, 16)
#define CLK_V3_RX_DELAY_MASK GENMASK(27, 22)
#define CLK_V3_ALWAYS_ON BIT(28)
+#define CLK_V3_IRQ_SDIO_SLEEP BIT(29)
#define CLK_TX_DELAY_MASK(h) (h->data->tx_delay_mask)
#define CLK_RX_DELAY_MASK(h) (h->data->rx_delay_mask)
#define CLK_ALWAYS_ON(h) (h->data->always_on)
+#define CLK_IRQ_SDIO_SLEEP(h) (h->data->irq_sdio_sleep)
#define SD_EMMC_DELAY 0x4
#define SD_EMMC_ADJUST 0x8
@@ -135,6 +138,7 @@ struct meson_mmc_data {
unsigned int rx_delay_mask;
unsigned int always_on;
unsigned int adjust;
+ unsigned int irq_sdio_sleep;
};
struct sd_emmc_desc {
@@ -174,6 +178,7 @@ struct meson_host {
bool vqmmc_enabled;
bool needs_pre_post_req;
+ spinlock_t lock;
};
#define CMD_CFG_LENGTH_MASK GENMASK(8, 0)
@@ -430,6 +435,7 @@ static int meson_mmc_clk_init(struct meson_host *host)
clk_reg |= FIELD_PREP(CLK_CORE_PHASE_MASK, CLK_PHASE_180);
clk_reg |= FIELD_PREP(CLK_TX_PHASE_MASK, CLK_PHASE_0);
clk_reg |= FIELD_PREP(CLK_RX_PHASE_MASK, CLK_PHASE_0);
+ clk_reg |= CLK_IRQ_SDIO_SLEEP(host);
writel(clk_reg, host->regs + SD_EMMC_CLOCK);
/* get the mux parents */
@@ -934,32 +940,54 @@ static void meson_mmc_read_resp(struct mmc_host *mmc, struct mmc_command *cmd)
}
}
+static void __meson_mmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
+{
+ struct meson_host *host = mmc_priv(mmc);
+ u32 reg_irqen = IRQ_EN_MASK;
+
+ if (enable)
+ reg_irqen |= IRQ_SDIO;
+ writel(reg_irqen, host->regs + SD_EMMC_IRQ_EN);
+}
+
static irqreturn_t meson_mmc_irq(int irq, void *dev_id)
{
struct meson_host *host = dev_id;
struct mmc_command *cmd;
- struct mmc_data *data;
u32 status, raw_status;
irqreturn_t ret = IRQ_NONE;
raw_status = readl(host->regs + SD_EMMC_STATUS);
- status = raw_status & IRQ_EN_MASK;
+ status = raw_status & (IRQ_EN_MASK | IRQ_SDIO);
if (!status) {
dev_dbg(host->dev,
"Unexpected IRQ! irq_en 0x%08lx - status 0x%08x\n",
- IRQ_EN_MASK, raw_status);
+ IRQ_EN_MASK | IRQ_SDIO, raw_status);
return IRQ_NONE;
}
- if (WARN_ON(!host) || WARN_ON(!host->cmd))
+ if (WARN_ON(!host))
return IRQ_NONE;
/* ack all raised interrupts */
writel(status, host->regs + SD_EMMC_STATUS);
cmd = host->cmd;
- data = cmd->data;
+
+ if (status & IRQ_SDIO) {
+ spin_lock(&host->lock);
+ __meson_mmc_enable_sdio_irq(host->mmc, 0);
+ sdio_signal_irq(host->mmc);
+ spin_unlock(&host->lock);
+ status &= ~IRQ_SDIO;
+ if (!status)
+ return IRQ_HANDLED;
+ }
+
+ if (WARN_ON(!cmd))
+ return IRQ_NONE;
+
cmd->error = 0;
if (status & IRQ_CRC_ERR) {
dev_dbg(host->dev, "CRC Error - status 0x%08x\n", status);
@@ -977,12 +1005,9 @@ static irqreturn_t meson_mmc_irq(int irq, void *dev_id)
meson_mmc_read_resp(host->mmc, cmd);
- if (status & IRQ_SDIO) {
- dev_dbg(host->dev, "IRQ: SDIO TODO.\n");
- ret = IRQ_HANDLED;
- }
-
if (status & (IRQ_END_OF_CHAIN | IRQ_RESP_STATUS)) {
+ struct mmc_data *data = cmd->data;
+
if (data && !cmd->error)
data->bytes_xfered = data->blksz * data->blocks;
if (meson_mmc_bounce_buf_read(data) ||
@@ -1125,6 +1150,21 @@ static int meson_mmc_voltage_switch(struct mmc_host *mmc, struct mmc_ios *ios)
return -EINVAL;
}
+static void meson_mmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
+{
+ struct meson_host *host = mmc_priv(mmc);
+ unsigned long flags;
+
+ spin_lock_irqsave(&host->lock, flags);
+ __meson_mmc_enable_sdio_irq(mmc, enable);
+ spin_unlock_irqrestore(&host->lock, flags);
+}
+
+static void meson_mmc_ack_sdio_irq(struct mmc_host *mmc)
+{
+ meson_mmc_enable_sdio_irq(mmc, 1);
+}
+
static const struct mmc_host_ops meson_mmc_ops = {
.request = meson_mmc_request,
.set_ios = meson_mmc_set_ios,
@@ -1134,6 +1174,8 @@ static const struct mmc_host_ops meson_mmc_ops = {
.execute_tuning = meson_mmc_resampling_tuning,
.card_busy = meson_mmc_card_busy,
.start_signal_voltage_switch = meson_mmc_voltage_switch,
+ .enable_sdio_irq = meson_mmc_enable_sdio_irq,
+ .ack_sdio_irq = meson_mmc_ack_sdio_irq,
};
static int meson_mmc_probe(struct platform_device *pdev)
@@ -1237,7 +1279,13 @@ static int meson_mmc_probe(struct platform_device *pdev)
if (ret)
goto err_init_clk;
+ spin_lock_init(&host->lock);
+
mmc->caps |= MMC_CAP_CMD23;
+
+ if (mmc->caps & MMC_CAP_SDIO_IRQ)
+ mmc->caps2 |= MMC_CAP2_SDIO_IRQ_NOTHREAD;
+
if (host->dram_access_quirk) {
/* Limit segments to 1 due to low available sram memory */
mmc->max_segs = 1;
@@ -1328,6 +1376,7 @@ static const struct meson_mmc_data meson_gx_data = {
.rx_delay_mask = CLK_V2_RX_DELAY_MASK,
.always_on = CLK_V2_ALWAYS_ON,
.adjust = SD_EMMC_ADJUST,
+ .irq_sdio_sleep = CLK_V2_IRQ_SDIO_SLEEP,
};
static const struct meson_mmc_data meson_axg_data = {
@@ -1335,6 +1384,7 @@ static const struct meson_mmc_data meson_axg_data = {
.rx_delay_mask = CLK_V3_RX_DELAY_MASK,
.always_on = CLK_V3_ALWAYS_ON,
.adjust = SD_EMMC_V3_ADJUST,
+ .irq_sdio_sleep = CLK_V3_IRQ_SDIO_SLEEP,
};
static const struct of_device_id meson_mmc_of_match[] = {
Add SDIO interrupt support. Successfully tested on a S905X4-based system (V3 register layout) with a BRCM4334 SDIO wifi module (brcmfmac driver). Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com> --- v2: - use new SDIO IRQ API v3: - don't duplicate checking mmc->sdio_irq_pending Device works fine w/o it. --- drivers/mmc/host/meson-gx-mmc.c | 70 ++++++++++++++++++++++++++++----- 1 file changed, 60 insertions(+), 10 deletions(-)