@@ -249,10 +249,6 @@ static int at803x_config_init(struct phy_device *phydev)
{
int ret;
- ret = genphy_config_init(phydev);
- if (ret < 0)
- return ret;
-
/* The RX and TX delay default is:
* after HW reset: RX delay enabled and TX delay disabled
* after SW reset: RX delay enabled, while TX delay retains the
@@ -254,13 +254,8 @@ static int dp83822_config_intr(struct phy_device *phydev)
static int dp83822_config_init(struct phy_device *phydev)
{
- int err;
int value;
- err = genphy_config_init(phydev);
- if (err < 0)
- return err;
-
value = DP83822_WOL_MAGIC_EN | DP83822_WOL_SECURE_ON | DP83822_WOL_EN;
return phy_write_mmd(phydev, DP83822_DEVADDR, MII_DP83822_WOL_CFG,
@@ -68,13 +68,8 @@ static int dp83848_config_intr(struct phy_device *phydev)
static int dp83848_config_init(struct phy_device *phydev)
{
- int err;
int val;
- err = genphy_config_init(phydev);
- if (err < 0)
- return err;
-
/* DP83620 always reports Auto Negotiation Ability on BMSR. Instead,
* we check initial value of BMCR Auto negotiation enable bit
*/
@@ -85,6 +80,11 @@ static int dp83848_config_init(struct phy_device *phydev)
return 0;
}
+static int dummy_config_init(struct phy_device *phydev)
+{
+ return 0;
+}
+
static struct mdio_device_id __maybe_unused dp83848_tbl[] = {
{ TI_DP83848C_PHY_ID, 0xfffffff0 },
{ NS_DP83848C_PHY_ID, 0xfffffff0 },
@@ -113,13 +113,13 @@ MODULE_DEVICE_TABLE(mdio, dp83848_tbl);
static struct phy_driver dp83848_driver[] = {
DP83848_PHY_DRIVER(TI_DP83848C_PHY_ID, "TI DP83848C 10/100 Mbps PHY",
- genphy_config_init),
+ dummy_config_init),
DP83848_PHY_DRIVER(NS_DP83848C_PHY_ID, "NS DP83848C 10/100 Mbps PHY",
- genphy_config_init),
+ dummy_config_init),
DP83848_PHY_DRIVER(TI_DP83620_PHY_ID, "TI DP83620 10/100 Mbps PHY",
dp83848_config_init),
DP83848_PHY_DRIVER(TLK10X_PHY_ID, "TI TLK10X 10/100 Mbps PHY",
- genphy_config_init),
+ dummy_config_init),
};
module_phy_driver(dp83848_driver);
@@ -277,10 +277,6 @@ static int dp83811_config_init(struct phy_device *phydev)
{
int value, err;
- err = genphy_config_init(phydev);
- if (err < 0)
- return err;
-
value = phy_read(phydev, MII_DP83811_SGMII_CTRL);
if (phydev->interface == PHY_INTERFACE_MODE_SGMII) {
err = phy_write(phydev, MII_DP83811_SGMII_CTRL,
@@ -136,7 +136,7 @@ static int meson_gxl_config_init(struct phy_device *phydev)
if (ret)
return ret;
- return genphy_config_init(phydev);
+ return 0;
}
/* This function is provided to cope with the possible failures of this phy
@@ -305,7 +305,6 @@ static int lan88xx_config_init(struct phy_device *phydev)
{
int val;
- genphy_config_init(phydev);
/*Zerodetect delay enable */
val = phy_read_mmd(phydev, MDIO_MMD_PCS,
PHY_ARDENNES_MMD_DEV_3_PHY_CFG);
@@ -48,7 +48,6 @@ static struct phy_driver microchip_t1_phy_driver[] = {
.features = PHY_BASIC_T1_FEATURES,
- .config_init = genphy_config_init,
.config_aneg = genphy_config_aneg,
.ack_interrupt = lan87xx_phy_ack_interrupt,
@@ -1725,7 +1725,7 @@ static int vsc8584_config_init(struct phy_device *phydev)
return ret;
}
- return genphy_config_init(phydev);
+ return 0;
err:
mutex_unlock(&phydev->mdio.bus->mdio_lock);
@@ -1767,7 +1767,7 @@ static int vsc85xx_config_init(struct phy_device *phydev)
return rc;
}
- return genphy_config_init(phydev);
+ return 0;
}
static int vsc8584_did_interrupt(struct phy_device *phydev)
@@ -197,7 +197,7 @@ static int vsc738x_config_init(struct phy_device *phydev)
vsc73xx_config_init(phydev);
- return genphy_config_init(phydev);
+ return 0;
}
static int vsc739x_config_init(struct phy_device *phydev)
@@ -229,7 +229,7 @@ static int vsc739x_config_init(struct phy_device *phydev)
vsc73xx_config_init(phydev);
- return genphy_config_init(phydev);
+ return 0;
}
static int vsc73xx_config_aneg(struct phy_device *phydev)
@@ -267,7 +267,7 @@ static int vsc8601_config_init(struct phy_device *phydev)
if (ret < 0)
return ret;
- return genphy_config_init(phydev);
+ return 0;
}
static int vsc824x_ack_interrupt(struct phy_device *phydev)
Supported PHY features are either auto-detected or explicitly set. In both cases calling genphy_config_init isn't needed. All that genphy_config_init does is removing features that are set as supported but can't be auto-detected. Basically it duplicates the code in genphy_read_abilities. Therefore remove such calls from all PHY drivers. Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com> --- drivers/net/phy/at803x.c | 4 ---- drivers/net/phy/dp83822.c | 5 ----- drivers/net/phy/dp83848.c | 16 ++++++++-------- drivers/net/phy/dp83tc811.c | 4 ---- drivers/net/phy/meson-gxl.c | 2 +- drivers/net/phy/microchip.c | 1 - drivers/net/phy/microchip_t1.c | 1 - drivers/net/phy/mscc.c | 4 ++-- drivers/net/phy/vitesse.c | 6 +++--- 9 files changed, 14 insertions(+), 29 deletions(-)