mbox series

[00/15] Enable drivers for NXP/FSL QorIQ arm64 boards

Message ID 1582585690-463-1-git-send-email-leoyang.li@nxp.com (mailing list archive)
Headers show
Series Enable drivers for NXP/FSL QorIQ arm64 boards | expand

Message

Leo Li Feb. 24, 2020, 11:07 p.m. UTC 
The series enables necessary drivers for the QorIQ reference boards
supported in mainline.

Li Yang (15):
  arm64: defconfig: run through savedefconfig for ordering
  arm64: defconfig: Enable NXP flexcan driver
  arm64: defconfig: Enable QorIQ DPAA1 drivers
  arm64: defconfig: Enable QorIQ DPAA2 drivers
  arm64: defconfig: Enable ENETC Ethernet controller and FELIX switch
  arm64: defconfig: Enable NXP/FSL SPI controller drivers
  arm64: defconfig: Enable QorIQ cpufreq driver
  arm64: defconfig: Enable ARM SBSA watchdog driver
  arm64: defconfig: Enable QorIQ IFC NAND controller driver
  arm64: defconfig: Enable QorIQ GPIO driver
  arm64: defconfig: Enable ARM Mali display driver
  arm64: defconfig: Enable flash device drivers for QorIQ boards
  arm64: defconfig: Enable RTC devices for QorIQ boards
  arm64: defconfig: Enable PHY devices used on QorIQ boards
  arm64: defconfig: Enable e1000 device

 arch/arm64/configs/defconfig | 57 +++++++++++++++++++++++++++++-------
 1 file changed, 46 insertions(+), 11 deletions(-)