| Message ID | 20190401115616.21337-1-megous@megous.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | Add bluetooth, gps and accelerometer to TBS A711 | expand |
On Mon, Apr 01, 2019 at 01:56:11PM +0200, megous@megous.com wrote: > From: Ondrej Jirman <megous@megous.com> > > This series enables some peripherals on TBS A711 tablet that already > have mainline drivers: > > - GPS u-blox neo-6m (via gnss u-blox driver) > - Bluetooth (via recently added OF support in the Broadcom > bluetooth driver) > - Accelermomter BMA-250 (hooked to the I2C bus) > > It also modifies A83T DTSI and adds missing UART interfaces. > > I've added additional compatible to the gnss/u-blox driver for NEO-6M, > because this board uses this module, and I don't think I can use > the existing compatible for u-blox,neo-m8, even as a fallback. > > Please take a look, and apply the patches if you have no objections. > > Many of the patches will go through the sunxi tree, but I'm not > sure who will want to take the GPS patches. I'll take the GPS patches through my tree once I've had a chance to review them. Perhaps easiest to resend the corresponding dts change once that is done. Johan
From: Ondrej Jirman <megous@megous.com> This series enables some peripherals on TBS A711 tablet that already have mainline drivers: - GPS u-blox neo-6m (via gnss u-blox driver) - Bluetooth (via recently added OF support in the Broadcom bluetooth driver) - Accelermomter BMA-250 (hooked to the I2C bus) It also modifies A83T DTSI and adds missing UART interfaces. I've added additional compatible to the gnss/u-blox driver for NEO-6M, because this board uses this module, and I don't think I can use the existing compatible for u-blox,neo-m8, even as a fallback. Please take a look, and apply the patches if you have no objections. Many of the patches will go through the sunxi tree, but I'm not sure who will want to take the GPS patches. regards, Ondrej Jirman Changes in v2: - dropped already applied patches from the series (bluetooth, a83t uarts) - added /omit-if-no-ref/ to "uart2-pb-pins" - renamed node "bma250" to "accelerometer" - removed pinctrl properties that are already in base dtsi (i2c1_pins) Ondrej Jirman (5): ARM: dts: sun8i: tbs-a711: Add node for BMA250 accelerometer ARM: dts: sun8i: a83t: Add UART2 PB pins gnss: Add u-blox,neo-6m compatible dt-bindings: gnss: Add u-blox,neo-6m compatible ARM: dts: sun8i: tbs-a711: Enable UART2 (for NEO-6M GPS module) .../devicetree/bindings/gnss/u-blox.txt | 1 + arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts | 34 +++++++++++++++++++ arch/arm/boot/dts/sun8i-a83t.dtsi | 6 ++++ drivers/gnss/ubx.c | 1 + 4 files changed, 42 insertions(+)