mbox series

[0/2] leds: Add basic BCMBCA LEDs support

Message ID 20240920-bcmbca-leds-v1-0-5f70e692c6ff@linaro.org (mailing list archive)
Headers show
Series leds: Add basic BCMBCA LEDs support | expand

Message

Linus Walleij Sept. 20, 2024, 11:15 a.m. UTC 
This series adds bindings and a driver for the Broadcom
BCA (Broadband Access) SoC LEDs.

These LEDs can be either serial using 1-4 shift registers
or parallel using unique lines per-LED.

The LED controller supports hardware triggers from an
integrated ethernet switch, this support can be added
later, the modern hardware control framework is complex
and will require phandles and elaborate lookup of the
corresponding netdev etc.

The patches were developed and tested on the Genexis
XG6846B device using the BCM6846 SoC.

Broadcom guys: if you would rather take sole maintenanceship
of this or be listed as comaintainers, tell me, it's fine.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
Linus Walleij (2):
      dt-bindings: leds: bcmbca: Add bindings for BRCMBCA LEDs
      leds: bcmbca: Add new driver for Broadcom BCMBCA

 .../devicetree/bindings/leds/brcm,bcmbca-leds.yaml |  88 +++++
 MAINTAINERS                                        |   7 +
 drivers/leds/Kconfig                               |   9 +
 drivers/leds/Makefile                              |   1 +
 drivers/leds/leds-bcmbca.c                         | 391 +++++++++++++++++++++
 5 files changed, 496 insertions(+)
---
base-commit: 98f7e32f20d28ec452afb208f9cffc08448a2652
change-id: 20240920-bcmbca-leds-e6f16f55cfd9

Best regards,