mbox series

[v8,0/4] Add support for NetCube Systems Kumquat

Message ID 20250128200355.1948997-1-lukas.schmid@netcube.li (mailing list archive)
Headers show
Series Add support for NetCube Systems Kumquat | expand

Message

Lukas Schmid Jan. 28, 2025, 8:03 p.m. UTC 
This series adds dt-bindings and dt's for the NetCube Systems Kumquat board

Changes in v2:
  - Fix the devicetrees according to the "dt-schema" and 
    "make dtbs_check W=1"
  - Fix the License of the devicetree as requested
  - Create a cover letter for the patch series

Changes in v3:
  - Disable rtc inside the SoC again, as the rtc does not work on the board
  - Add the gpio-reserved-ranges property to the pinctrl bindings
  - Reorder the nodes in the devicetree to match the order of the nodes in 
    the sun8i-v3s.dtsi file

Changes in v4:
  - Moved the dtsi change into a sperate patch
  - Update commit messages to include better descriptions
  - Add descriptions to the uarts and mmc nodes in the dts file
  - Add missing newline at the end of the dts file
  - Removed the gpio-reserved-ranges property from the dts and from the
    pinctrl bindings
  - Remove the rtc status property from the dts file

Changes in v5:
  - Remove the unused lradc node and it's regualtor, as they are not used
    on the board
  - Add another alias for the SoC's rtc as 'rtc1'

Changes in v6:
  - Add reason why DS3232+ is preferred over internal rtc
  - Remove redundant pinctrls from mmc0, mmc1 and i2c0
  - Reordered eeprom0 and spi0/flash@0 properties
  - Reordered nodes by their node name alias+

Changes in v7:
  - Disable the external 32kHz crystal oscillator, as it does not work on
    the board

Changes in v8:
  - Update the commit messages and cover letter according to the Linux
    coding style

Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
---
Lukas Schmid (4):
  dt-bindings: vendor-prefixes: Add NetCube Systems Austria name
  dt-bindings: arm: sunxi: Add NetCube Systems Kumquat board
  ARM: dts: sunxi: add uart1_pe pinctrl for sun8i-v3s
  ARM: dts: sunxi: add support for NetCube Systems Kumquat

 .../devicetree/bindings/arm/sunxi.yaml        |   5 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm/boot/dts/allwinner/Makefile          |   2 +
 .../allwinner/sun8i-v3s-netcube-kumquat.dts   | 278 ++++++++++++++++++
 arch/arm/boot/dts/allwinner/sun8i-v3s.dtsi    |   6 +
 5 files changed, 293 insertions(+)
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-v3s-netcube-kumquat.dts