| Message ID | cover.1733920873.git.michal.simek@amd.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | ARM: zynq: Sync DTs with U-Boot | expand |
On Wed, 11 Dec 2024 13:41:19 +0100, Michal Simek wrote: > Hi, > > over years there were some changes pushed to U-Boot which were never merged > back to Linux. U-Boot introduced new option OF_UPSTREAM and start to sync > up DTs from Linux back to U-Boot. > This series is addressing differences. > There are still 3 more differences but they should be addressed separately. > > Thanks, > Michal > > > Michal Simek (14): > ARM: zynq: Remove deprecated device_type property > ARM: zynq: DT: List OCM memory for all platforms > ARM: zynq: Mark boot-phase-specific device nodes > ARM: zynq: Do not define address/size-cells for nand-controller > ARM: zynq: Wire smcc with nand/nor memories on zc770 platform > ARM: zynq: Add ethernet phy reset information to DT(zc702) > ARM: zynq: Define u-boot bootscrip addr via DT > ARM: zynq: Point via nvmem0 alias to eeprom on zc702/zc706 > ARM: zynq: Define rtc alias on zc702/zc706 > ARM: zynq: Rename i2c?-gpio to i2c?-gpio-grp > ARM: zynq: Fix fpga region DT nodes name > ARM: zynq: Enable QSPIs on platforms > ARM: zynq: Add sdhci to alias node > ARM: zynq: Remove ethernet0 alias from Microzed > > Sai Krishna Potthuri (1): > ARM: zynq: Replace 'io-standard' with 'power-source' property > > arch/arm/boot/dts/xilinx/zynq-7000.dtsi | 33 ++++++- > arch/arm/boot/dts/xilinx/zynq-cc108.dts | 41 ++++++++- > arch/arm/boot/dts/xilinx/zynq-microzed.dts | 10 ++- > arch/arm/boot/dts/xilinx/zynq-parallella.dts | 1 - > arch/arm/boot/dts/xilinx/zynq-zc702.dts | 87 +++++++++++++------ > arch/arm/boot/dts/xilinx/zynq-zc706.dts | 67 +++++++++++--- > arch/arm/boot/dts/xilinx/zynq-zc770-xm010.dts | 39 ++++++++- > arch/arm/boot/dts/xilinx/zynq-zc770-xm011.dts | 31 +++++++ > arch/arm/boot/dts/xilinx/zynq-zc770-xm012.dts | 35 ++++++++ > arch/arm/boot/dts/xilinx/zynq-zc770-xm013.dts | 41 ++++++++- > arch/arm/boot/dts/xilinx/zynq-zed.dts | 43 ++++++++- > .../boot/dts/xilinx/zynq-zturn-common.dtsi | 8 ++ > arch/arm/boot/dts/xilinx/zynq-zybo-z7.dts | 10 ++- > arch/arm/boot/dts/xilinx/zynq-zybo.dts | 9 +- > 14 files changed, 404 insertions(+), 51 deletions(-) > > -- > 2.43.0 > > > My bot found new DTB warnings on the .dts files added or changed in this series. Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings are fixed by another series. Ultimately, it is up to the platform maintainer whether these warnings are acceptable or not. No need to reply unless the platform maintainer has comments. If you already ran DT checks and didn't see these error(s), then make sure dt-schema is up to date: pip3 install dtschema --upgrade New warnings running 'make CHECK_DTBS=y xilinx/zynq-cc108.dtb xilinx/zynq-microzed.dtb xilinx/zynq-parallella.dtb xilinx/zynq-zc702.dtb xilinx/zynq-zc706.dtb xilinx/zynq-zc770-xm010.dtb xilinx/zynq-zc770-xm011.dtb xilinx/zynq-zc770-xm012.dtb xilinx/zynq-zc770-xm013.dtb xilinx/zynq-zed.dtb xilinx/zynq-zybo-z7.dtb xilinx/zynq-zybo.dtb' for cover.1733920873.git.michal.simek@amd.com: arch/arm/boot/dts/xilinx/zynq-parallella.dtb: ethernet@e000b000: ethernet-phy@0: Unevaluated properties are not allowed ('marvell,reg-init' was unexpected) from schema $id: http://devicetree.org/schemas/net/cdns,macb.yaml# arch/arm/boot/dts/xilinx/zynq-zc702.dtb: ethernet@e000b000: Unevaluated properties are not allowed ('phy-reset-active-low', 'phy-reset-gpio' were unexpected) from schema $id: http://devicetree.org/schemas/net/cdns,macb.yaml#