Show patches with: Submitter = Jason Gunthorpe       |    State = Action Required       |   79 patches
Patch Series A/R/T S/W/F Date Submitter Delegate State
rtc: Allow rtc drivers to specify the tv_nsec value for ntp - - - --- 2017-10-13 Jason Gunthorpe New
On NTP, RTCs and accurately setting their time - - - --- 2017-09-22 Jason Gunthorpe New
On NTP, RTCs and accurately setting their time - - - --- 2017-09-22 Jason Gunthorpe New
On NTP, RTCs and accurately setting their time - - - --- 2017-09-21 Jason Gunthorpe New
On NTP, RTCs and accurately setting their time - - - --- 2017-09-20 Jason Gunthorpe New
PCI: mvebu: Handle changes to the bridge windows while enabled 1 - - --- 2016-12-12 Jason Gunthorpe New
[fpga,9/9] fpga: Remove support for non-sg drivers - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,8/9] fpga socfpga: Use the scatterlist interface - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,7/9] fpga zynq: Use the scatterlist interface - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,6/9] fpga: Add scatterlist based write ops to the driver ops - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,5/9] fpga zynq: Remove priv->dev 2 - - --- 2016-11-09 Jason Gunthorpe New
[fpga,4/9] fpga zynq: Check for errors after completing DMA - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,3/9] fpga zynq: Fix incorrect ISR state on bootup - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,2/9] fpga zynq: Check the bitstream for validity - - - --- 2016-11-09 Jason Gunthorpe New
[fpga,1/9] fpga zynq: Add missing \n to messages - 1 - --- 2016-11-09 Jason Gunthorpe New
fpga zynq: Check the bitstream for validity - - - --- 2016-11-08 Jason Gunthorpe New
fpga zynq: Check the bitstream for validity - - - --- 2016-11-08 Jason Gunthorpe New
fpga zynq: Check the bitstream for validity - - - --- 2016-10-26 Jason Gunthorpe New
PCI: mvebu: Take control of mbus windows setup by the firmware - - - --- 2016-10-26 Jason Gunthorpe New
Revert "gpio/mvebu: convert to use irq_domain_add_simple()" - - - --- 2016-10-19 Jason Gunthorpe New
Revert "gpio/mvebu: convert to use irq_domain_add_simple()" - - - --- 2016-10-18 Jason Gunthorpe New
[ARM] Fix stack alignment when processing backtraces - - - --- 2016-10-18 Jason Gunthorpe New
[v7,0/3] Add support for PCI in AArch64 - - - --- 2014-05-21 Jason Gunthorpe New
[2/2] mtd: orion-nand: fix build error with ARMv4 - - - --- 2014-05-09 Jason Gunthorpe New
Change of TEXT_OFFSET for multi_v7_defconfig - - - --- 2014-04-17 Jason Gunthorpe New
Fixing PCIe issues on Armada XP - - - --- 2014-04-10 Jason Gunthorpe New
[v2] bus: mvebu-mbus: Avoid setting an undefined window size - - - --- 2014-04-08 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-04-08 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-04-08 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-04-07 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-03-26 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-03-26 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-03-25 Jason Gunthorpe New
Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370) - - - --- 2014-03-25 Jason Gunthorpe New
[1/2] of/irq: Fix irq-mapping in of_irq_parse_raw() - - - --- 2014-03-11 Jason Gunthorpe New
[2/2] PCI: mvebu - Call request_resources on the apertures - - - --- 2014-02-12 Jason Gunthorpe New
[1/2] bus: mvebu-mbus: Fix incorrect size for PCI aperture resources - - - --- 2014-02-12 Jason Gunthorpe New
[2/3] PCI: ARM: add support for virtual PCI host controller - - - --- 2014-02-12 Jason Gunthorpe New
[2/3] PCI: ARM: add support for virtual PCI host controller - - - --- 2014-02-12 Jason Gunthorpe New
ARM: Kirkwood: Add support for Excito Bubba B3 - - - --- 2014-01-02 Jason Gunthorpe New
[RESEND,v3,2/2] PCI: mvebu - Support a bridge with no IO port window - - - --- 2013-11-26 Jason Gunthorpe New
[RESEND,v3,1/2] PCI: mvebu - The bridge should obey the MEM and IO command bits - - - --- 2013-11-26 Jason Gunthorpe New
PCI: mvebu - Return a value for the INTERRUPT_LINE/PIN register - - - --- 2013-11-26 Jason Gunthorpe New
PCI: mvebu - The bridge secondary status register should be 0 - - - --- 2013-11-26 Jason Gunthorpe New
Build breakage from 'ARM: mm: use phys_addr_t appropriately in p2v and v2p conversions' - - - --- 2013-11-25 Jason Gunthorpe New
[3/4] ARM: mvebu: NETGEAR ReadyNAS 104 .dts file cleanup - - - --- 2013-11-22 Jason Gunthorpe New
net: mv643xx_eth: Add missing phy_addr_set in DT mode - - - --- 2013-11-05 Jason Gunthorpe New
[v2] PCI: mvebu - Support a bridge with no IO port window - - - --- 2013-11-01 Jason Gunthorpe New
[v3,2/2] PCI: mvebu - Support a bridge with no IO port window - - - --- 2013-10-31 Jason Gunthorpe New
[1/2] PCI: mvebu - The bridge should obey the MEM and IO command bits - - - --- 2013-10-31 Jason Gunthorpe New
PCI: mvebu - The bridge secondary status register should be 0 - - - --- 2013-10-15 Jason Gunthorpe New
[v2] PCI: mvebu - Support a bridge with no IO port window - - - --- 2013-10-15 Jason Gunthorpe New
[RESEND] PCI: mvebu - Support a bridge with no IO port window - - - --- 2013-10-01 Jason Gunthorpe New
[RESEND] PCI: mvebu: Dynamically detect if the PEX link is up to enable hot plug - - - --- 2013-10-01 Jason Gunthorpe New
Commit breaks strace: ARM: entry: allow ARM-private syscalls to be restarted - - - --- 2013-09-17 Jason Gunthorpe New
[v2] bus: mvebu-mbus: Fix optional pcie-mem/io-aperture properties - - - --- 2013-09-17 Jason Gunthorpe New
[3/3] ARM: kirkwood: Move the nand node under the mbus node - - - --- 2013-09-17 Jason Gunthorpe New
[2/3] ARM: kirkwood: Move the crypto node under the mbus node - - - --- 2013-09-17 Jason Gunthorpe New
.. - - - --- 2013-09-17 Jason Gunthorpe New
bus: mvebu-mbus: Fix optional pcie-mem/io-aperture properties - - - --- 2013-09-17 Jason Gunthorpe New
arm: Kirkwood - Remove kirkwood_setup_wins and rely on the DT binding - - - --- 2013-09-16 Jason Gunthorpe New
[RFC] MSI style interrupt controller for the Host2CPU doorbell on kirkwood - - - --- 2013-03-26 Jason Gunthorpe New
[v2,1/2] ARM: kirkwood: Ensure that kirkwood_ge0[01]_init() finds its clock - - - --- 2013-01-30 Jason Gunthorpe New
[v2,1/2] ARM: kirkwood: Ensure that kirkwood_ge0[01]_init() finds its clock - - - --- 2013-01-28 Jason Gunthorpe New
[2/3] ARM: Orion: Bind the orion bridge interrupt controller through DT - - - --- 2013-01-11 Jason Gunthorpe New
[v3] NTP: Add a CONFIG_RTC_SYSTOHC configuration - - - --- 2012-12-17 Jason Gunthorpe New
[v2] NTP: Add a CONFIG_RTC_SYSTOHC configuration - - - --- 2012-12-14 Jason Gunthorpe New
NTP: Add a CONFIG_RTC_SYSTOHC configuration - - - --- 2012-12-12 Jason Gunthorpe New
[3/3] ARM: Orion: Bind the orion timer through DT - - - --- 2012-12-11 Jason Gunthorpe New
[2/3] ARM: Orion: Bind the orion bridge interrupt controller through DT - - - --- 2012-12-11 Jason Gunthorpe New
[PATCHv2,1/3] ARM: Orion: Hoist bridge interrupt handling out of the timer - - - --- 2012-12-11 Jason Gunthorpe New
ARM: Orion: Hoist bridge interrupt handling out of the timer - - - --- 2012-12-07 Jason Gunthorpe New
ARM: Kirkwood: Add SPI_CHPA and SPI_CPOL support to spi-orion - - - --- 2012-11-21 Jason Gunthorpe New
ARM: Kirkwood: Support basic hotplug for PCI-E - - - --- 2012-11-21 Jason Gunthorpe New
ARM: Kirkwood: Update PCI-E fixup - - - --- 2012-11-21 Jason Gunthorpe New
ARM: Kirkwood: Use hw_pci.ops instead of hw_pci.scan - - - --- 2012-11-21 Jason Gunthorpe New
[ARM] Enable the second I2C bus on Marvell Kirkwood - - - --- 2012-10-01 Jason Gunthorpe New
[ARM] Build failure CONFIG_ARCH_KIRKWOOD_DT relies on CACHE_FEROCEON_L2 - - - --- 2012-09-30 Jason Gunthorpe New
[ARM] Use AT() in the linker script to create correct program headers - - - --- 2012-09-30 Jason Gunthorpe New