[V2,1/2] gpio-vbus: support disabling D+ pullup on suspend

Commit Message

Dmitry Baryshkov July 2, 2011, 2:02 p.m. UTC

Some platforms would like to disable D+ pullup on suspend, to drain as
low power, as possible. E.g. this was requested by mioa701 board
maintainers.

Signed-off-by: Dmitry Eremin-Solenikov <[e-mail]>
---
 drivers/usb/otg/gpio_vbus.c   |   32 ++++++++++++++++++++++++++++++++
 include/linux/usb/gpio_vbus.h |    1 +
 2 files changed, 33 insertions(+), 0 deletions(-)

Patch

diff --git a/drivers/usb/otg/gpio_vbus.c b/drivers/usb/otg/gpio_vbus.c
index 52733d9..44527bd 100644
--- a/drivers/usb/otg/gpio_vbus.c
+++ b/drivers/usb/otg/gpio_vbus.c
@@ -327,6 +327,34 @@  static int __exit gpio_vbus_remove(struct platform_device *pdev)
 	return 0;
 }
 
+#ifdef CONFIG_PM
+static int gpio_vbus_suspend(struct platform_device *pdev, pm_message_t state)
+{
+	struct gpio_vbus_data *gpio_vbus = platform_get_drvdata(pdev);
+	struct gpio_vbus_mach_info *pdata = gpio_vbus->dev->platform_data;
+
+	if (gpio_vbus->otg.gadget && pdata->disconnect_on_suspend) {
+		/* optionally disable D+ pullup */
+		if (gpio_is_valid(pdata->gpio_pullup))
+			gpio_set_value(pdata->gpio_pullup,
+					pdata->gpio_pullup_inverted);
+
+		set_vbus_draw(gpio_vbus, 0);
+	}
+	return 0;
+}
+
+static int gpio_vbus_resume(struct platform_device *pdev)
+{
+	struct gpio_vbus_data *gpio_vbus = platform_get_drvdata(pdev);
+
+	if (gpio_vbus->otg.gadget)
+		schedule_work(&gpio_vbus->work);
+
+	return 0;
+}
+#endif
+
 /* NOTE:  the gpio-vbus device may *NOT* be hotplugged */
 
 MODULE_ALIAS("platform:gpio-vbus");
@@ -337,6 +365,10 @@  static struct platform_driver gpio_vbus_driver = {
 		.owner = THIS_MODULE,
 	},
 	.remove  = __exit_p(gpio_vbus_remove),
+#ifdef CONFIG_PM
+	.suspend	= gpio_vbus_suspend,
+	.resume		= gpio_vbus_resume
+#endif
 };
 
 static int __init gpio_vbus_init(void)
diff --git a/include/linux/usb/gpio_vbus.h b/include/linux/usb/gpio_vbus.h
index d9f03cc..2faa38d 100644
--- a/include/linux/usb/gpio_vbus.h
+++ b/include/linux/usb/gpio_vbus.h
@@ -27,4 +27,5 @@  struct gpio_vbus_mach_info {
 	int gpio_pullup;
 	bool gpio_vbus_inverted;
 	bool gpio_pullup_inverted;
+	bool disconnect_on_suspend;
 };